RESUMEN
A fractionation method for technical lignin was developed, combining organic solvent extraction and membrane ultrafiltration of the solvent soluble component. This method was validated on a commercial wheat straw/Sarkanda grass lignin (Protobind 1000) using 2-butanone (MEK) as the solvent for both the extraction and the ultrafiltration operations. The parent lignin and the different obtained fractions were fully characterized in terms of chemical composition and physicochemical properties by gel permeation chromatography, gas chromatography/mass spectrometry (GC/MS), pyrolysis-GC/MS, total phenol contents, 31P nuclear magnetic resonance (31P NMR), thermogravimetric analysis, differential scanning calorimetry analysis, and Fourier-transform infrared spectroscopy. The results show that the proposed process allows a straightforward recovery of the different lignin fractions as well as a selective control over their molecular mass distribution and related dependent properties. Moreover, the operating flexibility of the Soxhlet/ultrafiltration process allows the treatment of lignins from different feedstocks using the same installation just by modulating the choice of the solvent and the membrane porosity with the best characteristics. This is one of the most important features of the proposed strategy, which represents a new fractionation approach with the potential to improve lignin valorization for materials science and preparative organic chemistry applications.
RESUMEN
In vitro biotransformation studies were performed to support the bioaccumulation assessment of 3 hydrophobic organic ultraviolet filters (UVFs), 4-methylbenzylidene camphor (4-MBC), 2-ethylhexyl-4-methoxycinnamate (EHMC), and octocrylene. In vitro depletion rate constants (kdep ) were determined for each UVF using rainbow trout liver S9 fractions. Incubations performed with and without added cofactors showed complete (4-MBC) or partial (EHMC and octocrylene) dependence of kdep on addition of the reduced form of nicotinamide adenine dinucleotide phosphate (NADPH), suggesting that hydrolysis of EHMC and octocrylene by NADPH-independent enzymes (e.g., carboxylesterases) is an important metabolic route. The concentration dependence of kdep was then evaluated to estimate Michaelis-Menten parameters (KM and Vmax ) for each UVF. Measured kdep values were then extrapolated to apparent whole-body biotransformation rate constants using an in vitro-in vivo extrapolation (IVIVE) model. Bioconcentration factors (BCFs) calculated from kdep values measured at concentrations well below KM were closer to empirical BCFs than those calculated from kdep measured at higher test concentrations. Modeled BCFs were sensitive to in vitro binding assumptions employed in the IVIVE model, highlighting the need for further characterization of chemical binding effects on hepatic clearance. The results suggest that the tested UVFs are unlikely to accumulate to levels exceeding the European Union Registration, Evaluation, Authorisation, and Restriction regulation criterion for bioaccumulative substances (BCF > 2000 L kg-1 ). However, consideration of appropriate in vitro test concentrations and binding correction factors are important when IVIVE methods are used to refine modeled BCFs. Environ Toxicol Chem 2019;38:548-560. © 2018 SETAC.
