Tolerance to agricultural pesticides of strains belonging to four genera of Rhizobiaceae.

In order to determine their tolerance to pesticides, 122 strains of rhizobia isolated from different geographical regions, and belonging to the genera Rhizobium, Mesorhizobium, Sinorhizobium and Bradyrhizobium were tested against eight herbicides, four fungicides and five insecticides. Sensitivity to the pesticides was measured by using the filter paper disk method at four concentrations, 0.45, 4.5, 45 and 450 µg per disk. When the pesticides were used at 0.45 µg per disk, a concentration similar to that found when pesticides are applied under field conditions, no inhibition was observed. Strains growth was affected at concentrations of 45 and 450 µg pesticide per disk. These higher concentrations can be encountered when seeds are treated with pesticides. Pesticides tolerance level was correlated to pesticide function, i.e rhizobial strains were more tolerant to insecticides, followed by herbicides and then fungicides. Two fungicides, captan and mancozeb, inhibited the highest number of strains. Only one insecticide, carbaryl, affected the growth of some rhizobial strains. Strains isolated from the arctic (Mesorhizobium spp. and R. leguminosarum bv. viciae), a putative pesticides-free environment, were either less or equally affected by pesticides compared to strains isolated from agricultural regions.

Evaluation of an acid ammonium oxalate extraction to determine fluoride resident concentrations in soils.

Fluoride depositions near aluminum smelters and other fluoride-emitting plants can lead to fluoride accumulation in soils, which constitutes a risk for ground water contamination. This study was conducted to investigate the capacity of a 0.2 M acid ammonium oxalate solution to selectively and quantitatively extract fluoride accumulated in soils. The recovery of fluoride added to three soils was evaluated following 7- to 28-d incubations. Oxalate extraction was also compared with a total fluoride extraction method, using oxalate-extractable fluoride (Fox) and total fluoride (Ftot) accumulation profiles derived from column percolation experiments. To determine low-level fluoride concentrations without interference from high Al and Fe concentrations, an adapted ion chromatography method was used. Following soil incubations, oxalate extracted 42 to 86% of added fluoride. Recovery varied between soils and, in one soil, increased with added fluoride concentration. Recovery was unaffected by incubation time. Maximum recovery was obtained in a soil high in amorphous Fe and Al, low in clay, and free of carbonate. Lower recoveries were obtained in soils with higher clay or carbonate contents. Only 4 to 8% of Ftot was extracted in untreated samples using Fox, which suggests a high selectivity of this method for added fluoride. In percolation experiments, the use of Fox reduced considerably the background noise associated with Ftot for the evaluation of fluoride accumulation profiles. Because of its high selectivity and despite incomplete fluoride recovery, the use of Fox to determine fluoride resident concentrations in soils may improve environmental monitoring of fluoride accumulation and movement in contaminated soils.