Right ventricle involvement in patients with breast cancer treated with chemotherapy.

BACKGROUND: Anthracyclines can cause left ventricular (LV) dysfunction. There is little data about right ventricular (RV) damage during chemotherapy. AIM: This study aimed to investigate the toxic effects of chemotherapy, analyzing its impact on right ventricular function. MATERIAL AND METHODS: A prospective study was conducted, enrolling 83 female patients (55 ± 11 years old) affected by breast cancer treated with anthracyclines. Cardiological evaluation, HFA risk score assessment and comprehensive echocardiogram, including speckle tracking analysis and 3D analysis, were performed before starting chemotherapy (T0) and at 3 (T1), 6 (T2) and 12 months (T3) after beginning treatment. RV function was assessed with tricuspid annular plane excursion (TAPSE), S' wave of the tricuspid annulus, fractional area change (FAC), RV global longitudinal strain (RV-GLS), free wall strain (RV-FWLS) and RV 3D ejection fraction (RV-3DEF). Subclinical LV CTRCD was defined as a reduction of GLS > 15% compared to baseline. Subclinical RV cardiotoxicity was defined as the co-presence of a relative decrease of 10% from baseline in RV-3DEF and a relative reduction of 15% from baseline RV-FWLS. RESULTS: After chemotherapy, we found a significant reduction in 2D-LVEF (p = < 0.001) and 3D-LVEF (p = < 0.001), in LV-GLS and RVLS (p = < 0.001), in FAC and TAPSE, also RV-3DEF reduced significantly (p = 0.002). 39% of patients developed LV subclinical CTRCD; 28% of patients developed RV subclinical cardiotoxicity. LV and RV changes occurred concomitantly, and no RV echocardiographic parameters were found to predict the development of LV CTRCD and vice-versa. CONCLUSION: After anthracyclines-based chemotherapy, LV and RV subclinical damage occurs, and it can be detected early by speckle-tracking and 3D echocardiography.

Gas chromatographic quantitative analysis of methanol in wine: operative conditions, optimization and calibration model choice.

The influence of the wine distillation process on methanol content has been determined by quantitative analysis using gas chromatographic flame ionization (GC-FID) detection. A comparative study between direct injection of diluted wine and injection of distilled wine was performed. The distillation process does not affect methanol quantification in wines in proportions higher than 10%. While quantification performed on distilled samples gives more reliable results, a screening method for wine injection after a 1:5 water dilution could be employed. The proposed technique was found to be a compromise between the time consuming distillation process and direct wine injection. In the studied calibration range, the stability of the volatile compounds in the reference solution is concentration-dependent. The stability is higher in the less concentrated reference solution. To shorten the operation time, a stronger temperature ramp and carrier flow rate was employed. With these conditions, helium consumption and column thermal stress were increased. However, detection limits, calibration limits, and analytical method performances are not affected substantially by changing from normal to forced GC conditions. Statistical data evaluation were made using both ordinary (OLS) and bivariate least squares (BLS) calibration models. Further confirmation was obtained that limit of detection (LOD) values, calculated according to the 3sigma approach, are lower than the respective Hubaux-Vos (H-V) calculation method. H-V LOD depends upon background noise, calibration parameters and the number of reference standard solutions employed in producing the calibration curve. These remarks are confirmed by both calibration models used.

Determination of plant hormones in fertilizers by high-performance liquid chromatography with photodiode array detection: method development and single-laboratory validation.

A simple and reliable high-performance liquid chromatographic method that uses photodiode array detection was developed for the simultaneous determination of 12 native and synthetic plant hormones, i.e., plant growth regulators (PGRs), in fertilizers, such as 1-naphthol, 2,4-dichlorophenoxyacetic acid, 4-(2,4-dichlorophenoxy)butyric acid, 4-chlorophenoxyacetic acid, indole-3-acetic acid, 4-(3-indolyl)butyric acid, dichlorprop, (4-chloro-2-methylphenoxy)acetic acid, alpha-naphthaleneacetic acid, 1-naphthaleneacetamide, beta-naphthoxyacetic acid, and thidiazuron. The method was experimentally validated for routine regulatory application, and the following analytical parameters were assessed for all PGRs studied: linearity; specificity; precision (relative standard deviation) and accuracy, both measured at 3 concentration levels (0.1, 0.05, and 0.01%, w/w); ruggedness; limit of detection; and limit of quantification. Results were satisfactory for all method validation parameters tested and for all PGRs studied, demonstrating the suitability of the method for the determination of PGRs in fertilizers. The uncertainty of measurement was also estimated at 3 concentration levels for all PGRs by using the approach of the International Organization for Standardization, described in its Guide to the Expression of Uncertainty in Measurement. The method was applied to 20 samples of liquid fertilizer with declared biostimulant properties.