Association between muscle quality index and pulmonary function in post-COVID-19 subjects.

BACKGROUND: The SARS-CoV2 pandemic impacted many critically ill patients, causing sequelae, affecting lung function, and involving the musculoskeletal system. We evaluated the association between lung function and muscle quality index in severely ill post-COVID-19 patients. METHODS: A cross-sectional study was conducted on a post-COVID-19 cohort at a third-level center. The study included patients who had experienced severe-to-critical COVID-19. Anthropometric measurements, such as body mass index (BMI) and handgrip strength, were obtained to calculate the muscle quality index (MQI). Additionally, spirometry, measurements of expiratory and inspiratory pressure, and an assessment of DLCO in the lungs were performed. The MQI was categorized into two groups: low-MQI (below the 50th percentile) and high-MQI (above the 50th percentile), based on sex. Group differences were analyzed, and a multivariate linear regression analysis was performed to assess the association between respiratory function and MQI. RESULTS: Among the 748 patients analyzed, 61.96% required mechanical ventilation, and the median hospital stay was 17 days. In patients with a low MQI, it was observed that both mechanical respiratory function and DLCO were lower. The multivariate analysis revealed significantly lower findings in mechanical respiratory function among patients with a low MQI. CONCLUSION: The Low-MQI is an independent predictor associated with pulmonary function parameters in subjects with Post-COVID-19 syndrome.

Development of a synthetic single crystal diamond dosimeter for dose measurement of clinical proton beams.

The scope of this work was to develop a synthetic single crystal diamond dosimeter (SCDD-Pro) for accurate relative dose measurements of clinical proton beams in water. Monte Carlo simulations were carried out based on the MCNPX code in order to investigate and reduce the dose curve perturbation caused by the SCDD-Pro. In particular, various diamond thicknesses were simulated to evaluate the influence of the active volume thickness (e AV) as well as the influence of the addition of a front silver resin (250 µm in thickness in front of the diamond crystal) on depth-dose curves. The simulations indicated that the diamond crystal alone, with a small e AV of just 5 µm, already affects the dose at Bragg peak position (Bragg peak dose) by more than 2% with respect to the Bragg peak dose deposited in water. The optimal design that resulted from the Monte Carlo simulations consists of a diamond crystal of 1 mm in width and 150 µm in thickness with the front silver resin, enclosed by a water-equivalent packaging. This design leads to a deviation between the Bragg peak dose from the full detector modeling and the Bragg peak dose deposited in water of less than 1.2%. Based on those optimizations, an SCDD-Pro prototype was built and evaluated in broad passive scattering proton beams. The experimental evaluation led to probed SCDD-Pro repeatability, dose rate dependence and linearity, that were better than 0.2%, 0.4% (in the 1.0-5.5 Gy min-1 range) and 0.4% (for dose higher than 0.05 Gy), respectively. The depth-dose curves in the 90-160 MeV energy range, measured with the SCDD-Pro without applying any correction, were in good agreement with those measured using a commercial IBA PPC05 plane-parallel ionization chamber, differing by less than 1.6%. The experimental results confirmed that this SCDD-Pro is suitable for measurements with standard electrometers and that the depth-dose curve perturbation is negligible, with no energy dependence and no significant dose rate dependence.