A review on preparative and semi-preparative offgel electrophoresis for multidimensional protein/peptide assessment.

Mass spectrometry (MS) techniques are commonly used for protein identification and further analysis of selected protein spots after high resolution 2-D electrophoresis. Complementary gel-free approaches have been developed during the last few years and have shown to be useful tools in modern proteomics. The development and application of various gel-free electrophoresis devices for performing protein fractionation according to the pI differences is therefore a topic of interest. This review describes the current state of isoelectric focusing (IEF) gel-free electrophoresis based on the Agilent offgel 3100 fractionator. The review includes, therefore, (i) an overview on IEF as well as other previous IEF gel-free electrophoresis developments; (ii) offgel fundamentals and future trends; (iii) advantages and disadvantages of current offgel procedures; (iv) requirements of isolated protein pellets for further offgel fractionation; (v) offgel fraction requirements to perform the second dimensional analysis by advance electrophoresis and chromatographic techniques; and (vi) effect of the offgel operating conditions on the stability of metal-protein complexes.

Assessment of metals bound to marine plankton proteins and to dissolved proteins in seawater.

Studies based on laser ablation-inductively coupled plasma-mass spectrometry (LA-ICP-MS) have been performed to assess metal bound to dissolved proteins and proteins from marine plankton after two-dimensional polyacrylamide gel electrophoresis (2D PAGE). Dissolved proteins were pre-concentrated from surface seawater (60 L) by tangential ultrafiltration with 10 kDa molecular weight cut-off (MWCO) membranes and further centrifugal ultrafiltration (10 kDa) before proteins isolation by methanol/chloroform/water precipitation. Proteins isolation from plankton was assessed after different trichloroacetic acid (TCA)/acetone and methanol washing stages, and further proteins extraction with a phenol solution. LA-ICP-MS analysis of the electrophoretic profiles obtained for dissolved proteins shows the presence of Cd, Cr, Cu, and Zn in five spots analyzed. These proteins exhibit quite similar molecular weights (within the 10-14 kDa range) and pIs (from 5.8 to 7.3). Cd, Cr, Cu, and Zn have also been found to be associated to proteins isolated from plankton samples. In this case, Cd has been found to be bound to proteins of quite different molecular weight (9, 13 and 22 kDa) and pIs (4.5, 5.2, 5.5, and 10). However, trace elements such as Cr, Cu and Zn appear to be mainly bound to plankton proteins of low molecular weight and variable pI.

Study of extraction procedures for protein analysis in plankton samples by OFFGEL electrophoresis hyphenated with Lab-on-a-chip technology.

Extraction procedures for protein analysis from plankton samples were studied. OFFGEL electrophoresis combined with Lab-on-a-chip technology has been applied for protein analysis in plankton samples. BCR-414 (plankton) certified reference material from the European Commission was used to evaluate the protein extraction procedures. Three protein extraction procedures were studied: (1) by using Tris-HCl buffer containing a protease inhibitor cocktail, (2) urea/triton X-100 buffer extraction, and (3) using the phenol/sodium dodecyl sulphate method after different washing steps with 10% trichloroacetic acid/acetone solution and methanol. The pellet of proteins obtained was dried and then dissolved in the OFFGEL buffer. Proteins were separated according to their isoelectric points by OFFGEL electrophoresis. This separation was performed using 24 cm, pH 3-10 IPG Dry Strips. The proteins present in each liquid fraction (24 fractions) were separated according to their molecular weight using a microfluidic Lab-on-a-chip electrophoresis with the Protein 80 LabChip kit. This kit allows for the separation of proteins with a molecular weight ranging from 5 to 80 kDa. Taking into account the intensity and the number of the protein bands obtained, the protein extraction procedure using the phenol/sodium dodecyl sulphate after different wash steps with 10% trichloroacetic acid/acetone solution was selected. The developed method was applied for protein determination in a fresh marine plankton sample. The proteins found in this sample have a molecular weight ranging from 6.4 to 57.3 kDa, and the proteins with highest molecular weight were in the OFFGEL fractions with an isoelectric point ranging from 4.40 to 8.60. The concentration of proteins were calculated using external calibration with Bovine Serum Albumin, and the protein concentrations varied from 50.0 to 925.9 ng µL(-1).

Two-dimensional isoelectric focusing OFFGEL and microfluidic lab-on-chip electrophoresis for assessing dissolved proteins in seawater.

Dissolved proteins were assessed in surface and deep seawater by two-dimensional isoelectric focusing (IEF) OFFGEL-lab-on-chip (LOC) electrophoresis after tangential flow ultrafiltration followed by centrifugal ultrafiltration (preconcentration factor of 3000). Dissolved protein isolation was performed by treating the ultrafiltrated retentate with cold acetone and also with chloroform as precipitating reagents. The best electrophoretic behavior of the isolated proteins was obtained after protein precipitation with chloroform before different rinsing stages for removing methanol and water interferences. Metals bound to proteins in the different OFFGEL fractions were assessed by inductively coupled plasma-optical emission spectrometry and electrothermal atomic absorption spectrometry, under optimized operating conditions. Experiments regarding stability of the metal-binding proteins [superoxide dismutase (SOD) and alcohol dehydrogenase (ADH) as protein models] showed the integrity of the Zn-binding SOD/ADH under the OFFGEL electrophoretic conditions. However, stability of Cu bound to SOD is not guaranteed. The first electrophoretic dimension (IEF OFFGEL) showed that dissolved proteins in surface seawater exhibit alkaline isoelectric points (pIs of 8.10 and 8.37) and also acid Ips (4.82, 5.13, 5.43, and 5.73), while LOC showed that the isolated proteins exhibit a spread molecular weight range (within 15 - 63 kDa); although, high molecular weights were the most commonly found. Regarding deep seawater, isolated proteins were of acid Ips (from 3.30 to 4.22) and low molecular weight (within the 21-24 kDa range). Elements such as Cd, Cu, Mn, and Ni were mainly associated with dissolved proteins of alkaline pIs in surface seawater, while Zn was mainly associated to proteins of acid pIs. However, only Cu and Mn were found to be bound to dissolved proteins of higher Ips in deep seawater, and the amount of Mn (from 68 to 84 µg L(-1)) was higher than that found in dissolved proteins in surface seawater (22.4 µg L(-1)).

Size exclusion and anion exchange high performance liquid chromatography for characterizing metals bound to marine dissolved organic matter.

Size exclusion chromatography (SEC) followed by anion exchange chromatography (AEC) hyphenated with inductively coupled plasma-mass spectrometry (ICP-MS) was applied for fractionating metals bound to marine dissolved organic matter (DOM). Surface seawater samples (100 L) were subjected to tangential flow ultrafiltration (10,000 Da cut off) for isolating and pre-concentrating dissolved large molecules. The isolated fraction (retentate) consisted of 1L, which was further freeze-dried and re-dissolved to 250 mL with ultrapure water. After HI Trap desalting of the re-dissolved retentate, SEC with UV detection showed marine DOM ranging from 6.5 kDa (lower than the permeable volume of the SEC column) to 16 kDa. A further characterization of this fraction by AEC with UV detection revealed the existence of four groups of macromolecules exhibiting retention times of 2.3, 2.8, 4.5 and 14.0 min. AEC hyphenated with ICP-MS showed the presence of strontium and zinc in the first AE fraction isolated from the SEC fraction; while manganese was found to be bound to the second AE fraction. Cobalt was found to be bound to molecules comprising the third AE fraction.

On-line ionic imprinted polymer selective solid-phase extraction of nickel and lead from seawater and their determination by inductively coupled plasma-optical emission spectrometry.

Nickel(II) and lead(II) ionic imprinted 8-hydroxyquinoline polymers were synthesized by a precipitation polymerization technique and were used as selective solid phase extraction supports for the determination of nickel and lead in seawater by flow injection solid phase extraction on-line inductively coupled plasma-optical emission spectrometry. An optimum loading flow rate of 2.25 mL min(-1) for 2 min and an elution flow rate of 2.25 mL min(-1) for 1 min gave an enrichment factor of 15 for nickel. However, a low dynamic capacity and/or rate for adsorption and desorption was found for lead ionic imprinted polymer and a flow rate of 3.00 mL min(-1) for 4-min loading and a flow rate of 2.25 mL min(-1) for 1-min elution gave a enrichment factor of 5. The limit of detection was 0.33 microg L(-1) for nickel and 1.88 microg L(-1) for lead, with a precision (n = 11) of 8% (2.37 microg Ni L(-1)) for nickel and 11% (8.38 microg Pb L(-1)) for lead. Accuracy was also assessed by analyzing SLEW-3 (estuarine water) and TM-24 (lake water) certified reference materials, and the values determined were in good agreement with the certified concentrations.