RESUMEN
The LD oilfield is one of the representative offshore oilfields. After weak gel flooding, the recovery rate is significantly improved. However, the oilfield is then in a medium- to high-water content stage, presenting a complex distribution of the remaining oil. The measures for further enhanced oil recovery (EOR) are uncertain. As a result, it is necessary to clarify the distribution pattern and development potential of the remaining oil during the high-water content period after weak gel flooding. In this study, an online nuclear magnetic resonance (NMR) oil displacement experiment and microscopic oil displacement experiment were conducted, and the mechanisms of weak gel flooding and the distribution pattern of the remaining oil were clarified in the LD oilfield. Additionally, high-multiple water flooding and numerical simulation experiments were conducted to analyze the development potential after weak gel flooding. The results show that the effect of weak gel flooding was more significant in the core of 1500 mD, with an increase in oil recovery of 9% compared to 500 mD. At a permeability of 500 mD, the degree of crude oil mobilization in micropores and small pores caused by weak gel flooding was improved by 29.64% and 23.48%, respectively, compared with water flooding. At 1500 mD, the degree of crude oil mobilization in small pores caused by weak gel flooding was increased by 37.79% compared to water flooding. After weak gel flooding, the remaining oil was primarily distributed in medium and large pores. Microscopically, the remaining oil was dominated by cluster residual oil, accounting for 16.49%, followed by columnar, membranous, and blind-end residual oil. High multiple water flooding experiments demonstrated that weak gel flooding could significantly reduce development time. The ultimate oil recovery efficiency of 500 mD and 1500 mD reached 71.85% and 80.69%, respectively. Numerical simulation results show that the ultimate oil recovery efficiency increased from 62.04% to 71.3% after weak gel flooding. This indicated that the LD oilfield still had certain development potential after weak gel flooding. The subsequent direction for enhanced oil recovery focuses mainly on mobilizing oil in medium pores or clustered remaining oil. This will play a crucial role in further exploring methods for utilizing the remaining oil and increasing the recovery rate.
RESUMEN
After large-scale and long-term waterflooding, reservoir physical properties such as the pore throat structure and rock wettability may change. In this paper, the relative permeability curves under different water injection volumes through core-flood experiments were used to characterize the comprehensive changes of various reservoir physical properties at high water-cut stage. The novel concept of "water cross-surface flux" was proposed to characterize the cumulative flushing effect on the reservoir by injected water, and a novel method for inverted five-spot reservoir simulation at high water-cut stage based on time-varying relative permeability curves was established. From the relative permeability curves measured through two cores from the X oilfield under different water injection volumes (100, 500, 1000, 1500, and 2000 PV), it is found that with the increase of injected water volume, the two-phase co-flow zone becomes wider, the water permeability under residual oil saturation increases, and the residual oil saturation decreases. A waterflooding core model was established, simulated, and verified by the method proposed in this paper. It is found that using time-varying permeability curves for simulation, the highest oil recovery factor (61.58%) can be obtained with injected water volume up to 2000 PV, and the purpose of improved oil recovery (IOR) can be achieved by high water injection volume, but the increment is only approximately 10%. Besides, a waterflooding model of an inverted five-spot reservoir unit based on the X oilfield was also established, simulated, and analyzed. Simulation results have shown that no matter which set of core permeability curves measured from 100 to 2000 PV is directly used alone, the oil recovery factor will be simulated inaccurately. The findings of this study can help in better understanding the quantitative description of the oil recovery changes with time-varying reservoir physical properties in high water-cut reservoirs during waterflooding.