RESUMEN
Improved knowledge of the influence of temperature upon layered perovskites is essential to enable perovskite-based devices to operate over a broad temperature range and to elucidate the impact of structural changes upon the optoelectronic properties. We examined the Ruddlesden-Popper layered perovskite 2-thiophenemethylammonium lead iodide (ThMA2PbI4) and observed a structural phase transition between a high- and a low-temperature phase at 220 K using temperature-dependent X-ray diffraction, UV-visible absorption, and photoluminescence (PL) spectroscopy. The structural phase transition altered the tilt pattern of the inorganic octahedra layer, modifying the absorption and PL spectra. Further, we found a narrow and intense additional PL peak in the low-temperature phase, which we assigned to radiative emission from a defect-bound exciton state. In both phases we determined the thermal expansion coefficient and found values similar to those of cubic 3D perovskites, i.e., larger than those of typical substrates such as glass. These results demonstrate that the organic spacer plays a critical role in controlling the temperature-dependent structural and optoelectronic properties of layered perovskites and suggests more widely that strain management strategies may be needed to fully utilize layered perovskites in device applications.
RESUMEN
A better understanding of the materials' fundamental physical processes is necessary to push hybrid perovskite photovoltaic devices towards their theoretical limits. The role of the perovskite grain boundaries is essential to optimise the system thoroughly. The influence of the perovskite grain size and crystal orientation on physical properties and their resulting photovoltaic performance is examined. We develop a novel, straightforward synthesis approach that yields crystals of a similar size but allows the tuning of their orientation to either the (200) or (002) facet alignment parallel to the substrate by manipulating dimethyl sulfoxide (DMSO) and tetrahydrothiophene-1-oxide (THTO) ratios. This decouples crystal orientation from grain size, allowing the study of charge carrier mobility, found to be improved with larger grain sizes, highlighting the importance of minimising crystal disorder to achieve efficient devices. However, devices incorporating crystals with the (200) facet exhibit an s-shape in the current density-voltage curve when standard scan rates are used, which typically signals an energetic interfacial barrier. Using the drift-diffusion simulations, we attribute this to slower-moving ions (mobility of 0.37 × 10-10 cm2 V-1 s-1) in combination with a lower density of mobile ions. This counterintuitive result highlights that reducing ion migration does not necessarily minimise hysteresis.
RESUMEN
Introducing a polymethylmethacrylate (PMMA) layer at the (PEA)0.2(FA)0.8SnI3 perovskite/hole transport layer interface leads to a remarkable improvement in the photogenerated current density and fill factor, resulting in an increase in the power conversion efficiency from 6.5% to 10%. PMMA is proposed to mitigate interfacial charge losses and to induce a more favourable distribution of 2D perovskite phases, elucidating a pathway towards the development of high-performance tin-based perovskite solar cells.