RESUMEN
Cu2ZnSnS4 (CZTS) was synthesized following hot injection method and the process was optimized by varying temperature conditions. Four samples at different temperatures viz., 200, 250, 300 and 350 °C were prepared and analyzed using different characterization techniques. Based on the correlation between XRD, Raman and XPS, we conclude that the formation of ZnS and SnS2 occurs at 350 °C but at 200 °C there is no breakdown of the complex as per XRD. According to Raman and XPS analysis, as the temperature rises, the bonds between the metals become weaker, which is visibly seen in Raman and XPS due to the minor peaks of copper sulfide. Scanning electron microscopic analysis confirmed nanometric particles which increase in size with temperature. The photocatalytic evaluation showed that CZTS synthesized at 200 °C performed efficiently in the removal of the two colorants, methylene blue and Rhodamine 6G, achieving 92.80% and 90.65%, respectively. The photocatalytic degradation efficiencies decreased at higher temperatures due to bigger sized CZTS particles as confirmed by SEM results. Computational simulations confirm that CZTS has a highly negative energy -25,764 Ry, confirming its structural stability and higher covalent than ionic character.
RESUMEN
In this work the effect of noble metal on the photodegradation of 2,4-dichlorophenoxyacetic acid herbicide using TiO2 as support was studied. The metals and concentration were: Rh, Ru, Pt and Au and 1, 0.98, 1.89, and 1.91 wt% respectively. Rhodium was taken as reference for this experiment. The samples were characterized by X-Ray Diffraction (XRD), UV-vis absorption spectra, N2 physisorption (BET Specific Surface Area), High Annular Angle Analysis Darkfield (HAADF) and Transmission Electron Microscopy Scanning (STEM), H2 chemisorption, optical emission spectroscopy with inductive coupling plasma analysis (ICP-OES), solid fluorescence, X-ray Photoelectron Spectroscopy (XPS) and OH quantification. The presence of the anatase crystalline phase was mostly confirmed in all samples. The band gap decreased with the presence of metal (from 3.24 to 2.92 eV). The specific area was a function of the metal particle size. The metal particle diameter showed the following sequence Pt > Ru > Au > Rh. By XPS, TiO2 does not manifest changes in oxidation states, but when impregnated with metals, only Pt shows the highest abundance of any oxidized state (Pt2+). The presence of metal reveals less electron-hole recombination compared with titanium oxide. The results of photocatalytic activity showed that Pt and Rh are the two metals with the highest mineralization (99.0 and 98.3%, respectively).
RESUMEN
This work focused on the use of waste seaweed Sargassum fluitans (S. fluitans) as carbon source precursor to prepare nitrogen doped carbon dots (NCDs) by hydrothermal method. High resolution transmission electron microscopic (HR-TEM) studies revealed that the synthesized water soluble NCDs are in the size range of 2-8nm and exhibits excellent fluorescent properties with a quantum yield of 18.2%. Elemental nitrogen in NCDs was evidenced by X-ray photoelectron spectroscopy (XPS) and Fourier transformed infrared spectrum (FT-IR). The phytochemical analysis of S. fluitans using 1H NMR and 13C NMR revealed the presence of few amino acids which act as nitrogen source in the preparation of NCDs. Application of NCDs as fluorophore for double stranded DNA, single stranded DNA and RNA detection was highlighted in this study. Excellent fluorescent tagging abilities of NCDs with the biological nucleic acids were evidenced using gel electrophoresis. Significant increase in fluorescence was observed upon tagging of NCDs with nucleic acids and this particular phenomenon helps better in visualizing the nucleic acids. All three nucleic acids i.e. double stranded DNA, single stranded DNA and RNA showed similar phenomenon upon tagging with NCDs. Thus synthesized NCDs may be used as an alternate fluorophore for commercial toxic organic staining agents to visualize nucleic acids.
