High power ultralow-intensity noise continuous wave laser tunable from orange to red.

We report here on the development of a multi-Watt power tunable single frequency ultra-low noise laser system emitting around 620 nm. More than 5 W of output power is obtained between 616.5 nm and 630.8 nm using sum frequency generation of 1050 nm and 1550 nm tunable laser sources in a periodic poled lithium niobate crystal. The tunability is achieved through temperature and channel shift, and only limited by the crystal characteristics. An output power of 10.1 W and an optical-optical efficiency of 45% are reached at 624.5 nm. The relative intensity noise properties of the conversion process have been experimentally investigated in different configurations showing excellent agreement with the analytical prediction.

Ultralow-intensity noise, 10 W all-fiber single-frequency tunable laser system around 1550 nm.

We report herein on the development of a linearly polarized, single-frequency tunable laser system producing more than 10 W in the 1550 nm range, using a two-stage erbium/ytterbium co-doped fiber-based master oscillator power amplifier (MOPA) architecture. The all-fiber MOPA provides an ultralow intensity noise of -160dBc/Hz beyond 200 kHz between 1533 and 1571 nm (Δλ=38nm) at full output power and a minimum optical signal to noise ratio of 38 dB. A good stability is obtained over 4 h at maximum power for several wavelengths with peak-to-peak fluctuation less than 3% and rms below 0.5%.

Robust 17 W single-pass second-harmonic-generation at 532 nm and relative-intensity-noise investigation.

We demonstrate a 17 W single-frequency, low-intensity-noise green source at 532 nm, by single-pass second-harmonic generation of a 50 W continuous-wave fiber laser in a 30 mm MgO-doped periodically-poled stoichiometric lithium tantalate crystal. The maximum conversion efficiency is about 37%. A nearly Gaussian beam (M2<1.15 at 15 W) and low wavefront distortion are obtained. The system shows stable behavior over 100 h of uninterrupted operation. The evolution of the relative-intensity-noise transfer from the fundamental to the second harmonic is theoretically and experimentally investigated with high resolution.

Ultra-low intensity noise, all fiber 365 W linearly polarized single frequency laser at 1064†nm.

We demonstrate a robust linearly polarized 365 W, very low amplitude noise, single frequency master oscillator power amplifier at 1064 nm. Power scaling was done through a custom large mode area fiber with a mode field diameter of 30 µm. No evidence of stimulated Brillouin scattering or modal instabilities are observed. The relative intensity noise is reduced down to -160 dBc/Hz between 2 kHz and 10 kHz via a wide band servo loop (1 MHz bandwidth). We achieve 350 W of isolated power, with a power stability < 0.7% RMS over 1100 hours of continuous operation and a near diffraction limited beam (M2 < 1.1).

39 W narrow spectral linewidth monolithic ytterbium-doped fiber MOPA system operating at 976 nm.

We report on a monolithic narrow spectral linewidth master oscillator power amplifier (MOPA) delivering up to 39 W around 976 nm with very high contrast. The amplifier is based on an ytterbium-doped large mode area (LMA) octagonal double clad (DC) active fiber with parameters optimized for long living three-level operation.