Correction to: Lean mass and lower limb muscle function in relation to hip strength, geometry and fracture risk indices in community-dwelling older women.

The original version of this article, published on 14 December 2018, unfortunately contained a mistake.

Lean mass and lower limb muscle function in relation to hip strength, geometry and fracture risk indices in community-dwelling older women.

In a population-based sample of British women aged over 70 years old, lean mass and peak lower limb muscle force were both independently associated with hip strength and fracture risk indices, thereby suggesting a potential benefit of promoting leg muscle strengthening exercise for the prevention of hip fractures in postmenopausal women. INTRODUCTION: To investigate cross-sectional associations of lean mass and physical performance, including lower limb muscle function, with hip strength, geometry and fracture risk indices (FRIs) in postmenopausal women. METHODS: Data were from the Cohort of Skeletal Health in Bristol and Avon. Total hip (TH) and femoral neck (FN) bone mineral density (BMD), hip geometry and total body lean mass (TBLM) were assessed by dual x-ray absorptiometry (DXA). Finite element analysis of hip DXA was used to derive FN, intertrochanteric and subtrochanteric FRIs. Grip strength, gait speed and chair rise time were measured objectively. Lower limb peak muscle force and muscle power were assessed by jumping mechanography. RESULTS: In total, 241 women were included (age = 76.4; SD = 2.6 years). After adjustment for age, height, weight/fat mass and comorbidities, TBLM was positively associated with hip BMD (ßTH BMD = 0.36, P ≤ 0.001; ßFN BMD = 0.26, P = 0.01) and cross-section moment of inertia (0.24, P ≤ 0.001) and inversely associated with FN FRI (- 0.21, P = 0.03) and intertrochanteric FRI (- 0.11, P = 0.05) (estimates represent SD difference in bone measures per SD difference in TBLM). Lower limb peak muscle force was positively associated with hip BMD (ßTH BMD = 0.28, P ≤ 0.001; ßFN BMD = 0.23, P = 0.008) and inversely associated with FN FRI (- 0.17, P = 0.04) and subtrochanteric FRI (- 0.18, P = 0.04). Associations of grip strength, gait speed, chair rise time and peak muscle power with hip parameters were close to the null. CONCLUSIONS: Lean mass and lower limb peak muscle force were associated with hip BMD and geometrical FRIs in postmenopausal women. Leg muscle strengthening exercises may therefore help prevent hip fractures in older women.

Automated DXA-based finite element analysis for hip fracture risk stratification: a cross-sectional study.

Fracture risk indices (FRIs) generated from DXA-based finite element analysis were associated with hip fracture independent of FRAX score computed with femoral neck bone mineral density (BMD). Prospective studies are warranted to determine whether FRIs represent an improvement over BMD for predicting incident hip fractures. INTRODUCTION: The study aims to examine the association between prior hip fracture and FRIs derived from automated finite element analysis (FEA) of DXA hip scans. Femoral neck, intertrochanteric, and subtrochanteric FRIs were calculated as the von Mises stress induced by a sideways fall divided by the bone yield stress over the specified region of interest (ROI). METHODS: Using the Manitoba Bone Mineral Density Database, we selected women age ≥ 65 years with femoral neck T-scores below - 1 and no osteoporosis treatment. From this population, we identified 324 older women with hip fracture before DXA testing and a random sample of 658 non-fracture controls. FRIs were derived from the anonymized DXA scans. Logistic regression models were used to estimate odds ratios (ORs) and 95% confidence intervals (95% CIs) for the associations between FRIs (per SD increase) and hip fracture. RESULTS: After adjusting for FRAX score (hip fracture with BMD), femoral neck FRI (OR 1.36, 95% CI 1.13, 1.64), intertrochanteric FRI (OR 1.81, 95% CI 1.44, 2.27), and subtrochanteric FRI (OR 2.09, 95% CI 1.68, 2.60) were associated with hip fracture. Intertrochanteric and subtrochanteric FRIs gave significantly higher c-statistics (all P ≤ 0.05) than femoral neck BMD. Subgroup analyses showed that all FRIs were more strongly associated with hip fracture in women who were younger and had higher body mass index (BMI) or non-osteoporotic BMD (all P interaction < 0.1). CONCLUSIONS: FRIs derived from DXA-based FEA were independently associated with prior hip fracture, suggesting that they could potentially improve hip fracture risk assessment.

MR-compatibility of a high-resolution small animal PET insert operating inside a 7 T MRI.

A full-ring PET insert consisting of 16 PET detector modules was designed and constructed to fit within the 114 mm diameter gradient bore of a Bruker 7 T MRI. The individual detector modules contain two silicon photomultiplier (SiPM) arrays, dual-layer offset LYSO crystal arrays, and high-definition multimedia interface (HDMI) cables for both signal and power transmission. Several different RF shielding configurations were assessed prior to construction of a fully assembled PET insert using a combination of carbon fibre and copper foil for RF shielding. MR-compatibility measurements included field mapping of the static magnetic field (B 0) and the time-varying excitation field (B 1) as well as acquisitions with multiple pulse sequences: spin echo (SE), rapid imaging with refocused echoes (RARE), fast low angle shot (FLASH) gradient echo, and echo planar imaging (EPI). B 0 field maps revealed a small degradation in the mean homogeneity (+0.1 ppm) when the PET insert was installed and operating. No significant change was observed in the B 1 field maps or the image homogeneity of various MR images, with a 9% decrease in the signal-to-noise ratio (SNR) observed only in EPI images acquired with the PET insert installed and operating. PET detector flood histograms, photopeak amplitudes, and energy resolutions were unchanged in individual PET detector modules when acquired during MRI operation. There was a small baseline shift on the PET detector signals due to the switching amplifiers used to power MRI gradient pulses. This baseline shift was observable when measured with an oscilloscope and varied as a function of the gradient duty cycle, but had no noticeable effect on the performance of the PET detector modules. Compact front-end electronics and effective RF shielding led to minimal cross-interference between the PET and MRI systems. Both PET detector and MRI performance was excellent, whether operating as a standalone system or a hybrid PET/MRI.

18F, 11C and 68Ga in small animal PET imaging. Evaluation of partial volume correction methods.

AIM: The partial volume effect (PVE) significantly affects quantitative accuracy in PET. In this study we used a micro-hollow sphere phantom filled with 18F, 11C or 68Ga to evaluate different partial volume correction methods (PVC). Additionally, phantom data were applied on rat brain scans to evaluate PVC methods on in vivo datasets. METHODS: The four spheres (7.81, 6.17, 5.02, 3.90 mm inner diameter) and the background region were filled to give sphere-to-background (sph/bg) activity ratios of 20 : 1, 10 : 1, 5 : 1 and 2 : 1. Two different acquisition and reconstruction protocols and three radionuclides were evaluated using a small animal PET scanner. From the obtained images the recovery coefficients (RC) and contrast recovery coefficients (CRC) for the different sph/bg ratios were calculated. Three methods for PVC were evaluated: a RC based, a CRC based and a volume of interest (VOI) based method. The most suitable PVC methods were applied to in vivo rat brain data. RESULTS: RCs were shown to be dependent on the radionuclide used, with the highest values for 18F, followed by 11C and 68Ga. The calculated mean CRCs were generally lower than the corresponding mean RCs. Application of the different PVC methods to rat brain data led to a strong increase in time-activity curves for the smallest brain region (entorhinal cortex), whereas the lowest increase was obtained for the largest brain region (cerebellum). CONCLUSION: This study was able to show the importance and impact of PVE and the limitations of several PVC methods when performing quantitative measurements in small structures.

Five-year experience of quality control for a 3D LSO-based whole-body PET scanner: results and considerations.

PET scanners require routine monitoring and quality control (QC) to ensure proper scanner performance. QC helps to ensure that PET equipment performs as specified by the manufacturer and that there have not been significant changes in the system response since acceptance. In this work we describe the maintenance history and we report on the results obtained from the PET system QC testing program over 5 years at two centers, both utilizing a Siemens Biograph 16 HiRez PET/CT system. QC testing programs were based on international standards and included the manufacturer's daily QC, monthly uniformity and sensitivity, quarterly cross-calibration and annual resolution and image quality. For the Winnipeg and Novara sites, two and one PET detector blocks have been replaced, respectively. Neither system has had other significant PET system related hardware replacements. The manufacturer's suggested daily QC was sensitive to detecting problems in the function of PET detector elements. The same test was not sensitive for detecting long term drifts in the systems: the Novara system observed a significant deterioration over five years of testing in the sensitivity which exhibited a decrease of 16% as compared to its initial value measured at system installation. The measure of the energy spectrum, showed that the 511 keV photopeak had shifted to a position of 468 keV. This shift was corrected by having service personnel perform a complete system calibration and detector block setup. We recommend including tests of system energy response and of sensitivity as part of a QC program since they can provide useful information on the actual performance of the scanner. A modification of the daily QC test by the manufacturer is suggested to monitor the long term stability of the system. Image quality and spatial resolution tests have proven to be of limited value for monitoring the system over time.

Sci-Fri AM: Imaging - 03: Temperature dependence of a SiPM detector for an MR compatible PET system.

Silicon photomultiplier (SiPM) detectors are rapidly becoming the detector of choice for research and development of new detectors for positron emission tomography (PET) due to their combination of high gain, fast timing, compact form factor and ability to function in a magnetic field. We are investigating using SiPM based detectors in a compact PET system designed to be inserted into a 7T animal MRI system and enable simultaneous PET/MRI imaging. In order to understand the level of thermal stability required for this PET system, we examined the stability of a prototype SiPM detector vs. temperature. A detector was constructed using a SensL SPMArray4 SiPM array coupled to a LYSO scintillator crystal array. The temperature of the detector was varied between 23 and 60°C in 5°C steps. At each temperature setting data were collected to characterize the detector flood histogram, photopeak amplitude and energy resolution at 511 keV, timing resolution and signal arrival time. While the flood image showed no noticeable changes with temperature, the 511 keV photopeak amplitude showed a linear decrease of 1.5%/°C and the energy resolution degraded by 0.08%/°C. The timing resolution degraded by 1.5 ns, from 3.5 ns to 5 ns when the temperature changed from 23 to 60°C. Over this temperature range there was a shift in the signal arrival time of approximately 3 ns. These results demonstrate that the detector can be operated over a wide range of temperature, giving a large degree of flexibility in choosing an operating temperature set-point for our PET system.

Validation of PET-SORTEO Monte Carlo simulations for the geometries of the MicroPET R4 and Focus 220 PET scanners.

PET-SORTEO is a Monte Carlo-based simulator that enables the fast generation of realistic PET data for the geometry of the ECAT EXACT HR+ scanner. In order to address the increasing need for simulation models of animal PET imaging systems, our aim is to adapt and configure this simulation tool for small animal PET scanners, especially for the widely distributed microPET R4 and Focus 220 systems manufactured by Siemens Preclinical Solutions. We propose a simulation model that can produce realistic rodent images in order to evaluate and optimize acquisition and reconstruction protocols. The first part of this study presents the validation of SORTEO against the geometries of the R4 and the Focus 220 systems. This validation is carried out against actual measurements performed on the R4 scanner at the Montreal Neurological Institute in Canada and on the Focus 220 system of the department of radiopharmaceuticals of the Austrian Research Center in Seibersdorf. The comparison of simulated and experimental performance measurements includes spatial resolution, energy spectra, scatter fraction and count rates. In the second part of the study, we demonstrate the ability to rapidly generate realistic whole-body radioactive distributions using the MOBY phantom and give comparative example case studies of the same rodent model simulated with PET-SORTEO for the R4 and Focus 220 systems.

Falling rings: Group and ritual process in a divorce.

This paper describes, analyzes, interprets, and spells out some implications of a divorce as it was faced and handled by a pastor and congregation. The challenge to work creatively with divorce came when both the husband and wife wished to remain in the congregation as members. The paper briefly sets forth theological perspectives on marriage, divorce, and discipline in the Mennonite Church, a brief case history of the couple, a description of the group and ritual process with which the pastor and congregation responded, and the reflections of the couple and members a year later. The paper offers not a model but, rather, a symbol as presented in the title, "Falling Rings." It is hoped that the symbol will not only give rise to thought, but will also spark the imagination so as to enable other congregations to respond more assertively, creatively, and caringly to those who divorce in their midst.