RESUMEN
The main goal of this paper was to study the optical, electrical, and thermal properties of hybrid composites based on biodegradable polymers (L,D-poly(lactic acid), polycaprolactone or Ecoflex®), single walled carbon nanotubes (SWCN), and 4'-pentyl-4-biphenylcarbonitrile (5CB). The biodegradable polymers' binary and ternary compositions were analyzed in detail by ultraviolet and visible (UV-Vis) spectroscopy taking into consideration their chemical structure and interactions with 5CB and SWCN. Differential scanning calorimetry (DSC) studies of the created hybrid layers showed thermal stability and changes in glass transition temperature and melting point in comparison to neat polymers, depending on the chemical structure of the polymer used and the type of composition. Morphology of the created layers were investigated by atomic force and polarizing microscopy. The static contact angle measurements of a water drop showed that all of the neat polymer layers were hydrophobic with angle values ranging from 108° to 115°. In addition, in the case of the Ecoflex layers, both with and without additives, a rapid sorption of the deposited water drop was observed. Finally, a simple device with poly(ethylene terephthalate) (PET)/indium tin oxide (ITO)/poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS)/poly [[4,8-bis[(2-ethylhexyl)oxy]benzo[1,2-b:4,5-b']dithiophene-2,6-diyl][3-fluoro-2-[(2-ethylhexyl)carbonyl]thieno[3,4-b]thiophenediyl ]] (PTB7) : [6,6]-phenyl-C71-butyric acid methyl ester (PC70BM)/Ag/biodegradable polymer:SWCN architecture was constructed and tested using an infrared (IR) thermographic camera to investigate the surface defects on the created hybrid layers. Increasing the SWCN admixture from 0.01 to 0.5% significantly improved the conductivity only in the case of L,D-poly(lactic acid):SWCN (10:0.5), for which above 5 V, a current with a resistance of 3030.7 Ω could be measured. In order to use the created layers as flexible electrodes, the first experiments were carried out with an admixture of SWCN and poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) as conductive compounds.
RESUMEN
A new unsymmetrical imine with four thiophene rings was synthesized in a one-step reaction, starting from the commercially available and relatively inexpensive reagents. The obtained imine in the form of thin films exhibited photoluminescence properties in the 1.8-2.4 eV energy range and a photoluminescence lifetime of about 0.3 ns. The HOMO and LUMO levels of the imine determined by cyclic voltammetry were at about -5.19 eV and -3.05 eV, respectively. The density functional theory was applied to calculate the geometric and electronic structure of the imine. The UV-Vis spectra showed that the absorption range of the imine overlaps with that of PC70BM, and the absorption peak at the maximum of the imine at 424 nm is located between the two maxima at 404 nm and 461 nm of the fullerene derivative. The electron acceptor and donor activity of the imine was tested in the solar cell architecture: glass/ITO/PEDOT:PSS/active layer/In/Al. The best photovoltaic parameters, with very good reproducibility for each 8 pixels in the cell, were found for the active layer based on ternary mixture PTB7:PC70BM:imine at a weight ratio 8 : 13 : 1, with the power conversion efficiency of about 4%. The external quantum efficiency of devices with the imine was found to be about 40% at 3.3 eV. The thermal imaging together with the recorded current response at increasing potential showed that the presence of imine in the composition has a beneficial impact in terms of current flow stability at temperatures above 200 °C, compared to two component layers with the same imine as an additive.
RESUMEN
In this paper, four new aromatic imines containing at least one thiazole-based heterocycle were analyzed in detail by UV-Vis spectroscopy, taking into consideration their chemical structures and interactions with PTB7, a known polymeric electron donor widely used in bulk heterojunction organic solar cells. It is demonstrated that the absorption spectra of the investigated active compositions can be modified not only by changing the chemical structure of imine, but also via formulations with PTB7. For all investigated imines and PTB7:imine compositions, calibration curves were obtained in order to find the optimum concentration in the composition with PTB7 for expansion and optimization of absorption spectra. All imines and PTB7:imine compositions were investigated in 1,2-dichlorobenzene by UV-Vis spectroscopy in various concentrations, monitoring the changes in the π-π* and n-π* transitions. With increasing imine concentrations, we did not observe changes in absorption maxima, while with increasing imine concentrations, a hypochromic effect was observed. Finally, we could conclude that all investigated compositions exhibited wide absorptions of up to 800 nm and isosbestic points in the range of 440-540 nm, confirming changes in the macromolecular organization of the tested compounds. The theoretical calculations of their vibration spectra (FTIR) and LUMO-HOMO levels by Density Functional Theory (DFT) methods are also provided. Finally, IR thermal images were measured for organic devices based on imines and the imine:PTB7 composite.
RESUMEN
Invited for this month's cover picture is Dr. Agnieszka Gonciarz and her team. The team's cooperation began recently when they met at the Military University of Land Forces (MULF) in Wroclaw (Poland). Previously, each team member had various experience, in which chemistry played a major role. Dr. A. Gonciarz conducted spectroscopic research on coordination compounds, Prof. J. Zwozdziak is a well-known expert in the field of environmental protection, and Prof. M. Zuber is an expert in the application of chemistry in security sciences. When they met at MULF, the idea of cooperation arose and their research interest was directed toward the possibility of practical application of Schiff bases and their complexes in various areas. Read the full text of their Full Paper at https://doi.org/10.1002/open.201800100.
RESUMEN
The nickel(II) complex with a tetradentate Schiff base ligand obtained by condensation of 1,3-propanediamine with salicylaldehyde (H2salpn) was studied in a variety of solvents at room temperature. The product, that is, the N',N''-propylenebis(salicylaldiminato)nickel(II) ([Ni(salpn)]) complex, is brown in color in the solid state. The properties of the ligand and complex were characterized by elemental analysis, solubility in common solvents, molar conductivities, and ultraviolet (UV) and visible (Vis) spectroscopy. The [Ni(salpn)] complex is easily soluble in common solvents such as chloroform, methanol, ethanol, dimethyl formamide, dimethyl sulfoxide, acetonitrile, dioxane, acetone, 2-propanol, and toluene-a necessary condition for observing solvatochromism. The molar conductivity values, equal to 0.0â S mol-1 cm2 in these solvents, point to a typical non-electrolyte behavior for this complex. Spectroscopic measurements were used to confirm the square-planar geometry of the species in solution and to determine the coordination properties of the donor atoms and their bonding abilities (CFM/AOM parameters), as well as trichromaticity coordinate calculations. The results obtained show that the interactions of the metal with the donors depend on the polarity of the solvent.