Nanoparticle-Based Combination Therapy for Ovarian Cancer.

Ovarian cancer is one of the most common malignant tumors in gynecology with a high incidence. Combination therapy, eg, administration of paclitaxel followed by a platinum anticancer drug is recommended to treat ovarian cancer due to its advantages in, eg, reducing side effects and reversing (multi)drug-resistance compared to single treatment. However, the benefits of combination therapy are often compromised. In chemo and chemo/gene combinations, co-deposition of the combined therapeutics in the tumor cells is required, which is difficult to achieve due to dramatic pharmacokinetic differences between combinational agents in free forms. Moreover, some undesired properties such as the low-water solubility of chemodrugs and the difficulty of cellular internalization of gene therapeutics also hinder the therapeutic potential. Delivery of dual or multiple agents by nanoparticles provides opportunities to tackle these limits. Nanoparticles encapsulate hydrophobic drug(s) to yield aqueous dispersions facilitating its administration and/or to accommodate hydrophilic genes facilitating its access to cells. Moreover, nanoparticle-based therapeutics can not only improve drug properties (eg, in vivo stability) and ensure the same drug disposition behavior with controlled drug ratios but also can minimize drug exposure of the normal tissues and increase drug co-accumulation at targeted tissues via passive and/or active targeting strategies. Herein, this work summarizes nanoparticle-based combination therapies, mainly including anticancer drug-based combinations and chemo/gene combinations, and emphasizes the advantageous outcomes of nanocarriers in the combination treatment of ovarian cancer. In addition, we also review mechanisms of synergetic effects resulting from different combinations.

Arsenic adsorption by innovative iron/calcium in-situ-impregnated mesoporous activated carbons from low-temperature water and effects of the presence of humic acids.

Innovative iron/calcium in-situ-impregnated mesoporous activated carbons (GL100 and GL200) have been prepared by iron/calcium in-situ-impregnation and Multistage Depth-Activation. Arsenic adsorption kinetics, isotherms, thermodynamics, and re-usability were investigated. Effects of surface-absorbed (ST-HA) and dissolved states humic acid (DHA) on the arsenic adsorption were also determined. Results suggested in-situ iron/calcium impregnation caused the well-development of mesoporous structures during ranges of 2.0-5.0 nm in GL100 and 5.0-50 nm in GL200, respectively. The increase of iron/calcium ensured surface basicity and high ash contents on GL100/GL200, and As(III)/As(V) can be better adsorbed in neutral conditions with higher kinetics in comparison with regular mesoporous carbon XHIT. Maximum adsorption capacities of As(III)/As(V) by GL100 and GL200 were 2.985/3.385 mg/g and 2.516/2.807 mg/g, respectively. Arsenic desorption and carbon re-usability of GL100/200 was improved. As(III)(As (V)) adsorption capacities by GL100 and GL200 were 2.437(1.672) mg/g and 1.740(1.308) mg/g, respectively, after eight cycles. Arsenic adsorption capacities on GL100 were proved to be promoted with the presence of low-level of ST-HA or DHA, and be inhibited at a high-level. As(V) was bound more strongly than As(III) in the presence of ST-HA. As(III)/As(V) uptakes increased slightly and decrease gradually to 1.75/1.86 mg/g in the presence of DHA (0-10 mg DOC/L). Physisorption and chemisorption mechanisms dominant in arsenic adsorption on GL100 in presence of humic acid, forming inner-sphere complexation with metallic oxide, functional groups on carbon surface and humic acid structure, or ternary surface complexation via cationic metal ions as cation bridge.

Seasonal-related effects on ammonium removal in activated carbon filter biologically enhanced by heterotrophic nitrifying bacteria for drinking water treatment.

To determine the potential effects of seasonal changes on water temperature and water quality upon removal of ammonium and organic carbon pollutants and to characterize the variations in microbial characteristics, a pilot-scale activated carbon filter biologically enhanced with heterotrophic nitrifying bacteria was investigated for 528 days. The results show that 69.2 ± 28.6% of ammonium and 23.1 ± 11.6% of the dissolved organic carbon were removed by the biologically enhanced activated carbon (BEAC) reactor. It is shown that higher biodegradable dissolved organic carbon enhances ammonium removal, even at low temperatures. The C/N ratio consumed by the BEAC reactor reached a steady value (i.e., 3.3) after 2 months of operation. Despite seasonal fluctuations and competition of the indigenous community, the heterotrophic nitrifying bacteria (Acinetobacter sp. HRBLi 16 and Acinetobacter harbinensis strain HITLi 7) remained relatively stable. The amount of carbon source was the most significant environmental parameter and dramatically affected the microbial community compositions in the BEAC reactor. The present study provides new insights into the application of a BEAC reactor for ammonium removal from drinking water, resisting strong seasonal changes.

Characterization and performance evaluation of an innovative mesoporous activated carbon used for drinking water purification in comparison with commercial carbons.

The preparation, characterization, and performance evaluation of an innovative mesoporous activated carbon (C-XHIT) were conducted in this study. Comparative evaluation with commercial carbons (C-PS and C-ZJ15) and long-term performance evaluation of C-XHIT were conducted in small-scale system-A (S-A) and pilot-scale system-B (S-B-1 and S-B-2 in series), respectively, for treating water from Songhua River. The cumulative uptake of micropollutants varied with KBV (water volume fed to columns divided by the mass of carbons, m(3) H2O/kg carbon) was employed in the performance evaluation. The results identified that mesoporous and microporous volumes were simultaneously well-developed in C-XHIT. Higher mesoporosity (63.94 %) and average pore width (37.91 Å) of C-XHIT ensured a higher adsorption capacity for humic acid compared to C-PS and C-ZJ15. When the KBV of S-A reached 12.58 m(3) H2O/kg carbon, cumulative uptake of organic pollutants achieved by C-XHIT increased by 32.82 and 156.29 % for DOC (QC) and 22.53 and 112.48 % for UV254 (QUV) compared to C-PS and C-ZJ15, respectively; in contrast, the adsorption capacity of NH4 (+)-N did not improve significantly. C-XHIT achieved high average removal efficiencies for DOC (77.43 ± 16.54 %) and UV254 (83.18 ± 13.88 %) in S-B over 253 days of operation (KBV = 62 m(3) H2O/kg carbon). Adsorption dominated the removal of DOC and UV254 in the initial phases of KBV (0-15 m(3) H2O/kg carbon), and simultaneous biodegradation and adsorption were identified as the mechanisms for organic pollutant uptake at KBV above 25 m(3) H2O/kg carbon. The average rates contributed by S-B-1 and S-B-2 for QC and QUV were approximately 0.75 and 0.25, respectively. Good linear and exponential correlations were observed between S-A and S-B in terms of QC and QUV obtained by C-XHIT, respectively, for the same KBV ranges, indicating a rapid and cost-saving evaluation method. The linear correlation between mesoporosity and QC (QUV) was also identified by the evolution of the property indices of C-XHIT.

Draft Genome Sequences of Acinetobacter harbinensis Strain HITLi 7T, Isolated from River Water.

Acinetobacter harbinensis HITLi strain 7(T), isolated from river water, has the ability to remove ammonium and organic chemicals at 2°C. The genome sequences might be useful for investigating the low-temperature adaptability and nitrogen or organic chemical metabolism.

Adsorption characteristics of arsenic from micro-polluted water by an innovative coal-based mesoporous activated carbon.

An innovative coal-based mesoporous activated carbon (NCPAC) was prepared by re-agglomeration, oxidation and two-step activation using coal-blending as precursor. Adsorption capacities of As(III) and As(V) ions (<0.5mg/L) onto NCPAC as a function of pH, adsorbent dose, initial arsenic concentrations, contact time, and adsorption isotherms at 7°C was investigated. The innovative methods promoted total pore volume (1.087cm(3)/g), mesoporosity (64.31%), iodine numbers (1104mg/g), methylene blue (251.8mg/g) and ash contents (15.26%). The adsorption capacities of NCPAC for As(III) and As(V) were found to be strongly dependent on pH and contact time. The optimal pH value was 6. The equilibrium time was 60min for adsorption of As(III) and As(V) by NCPAC. The Langmuir model fitted the experimental data well for both As(III) (R(2)=0.9980) and As(V) (R(2)=0.9988). Maximum adsorption capacities of As(III) and As(V) (C0=0.50mg/L) by NCPAC were 1.491 and 1.760mg/g, respectively.

Study of the adsorption of Cr(VI) by tannic acid immobilised powdered activated carbon from micro-polluted water in the presence of dissolved humic acid.

The adsorption of Cr(VI) (0.500 mg/L) onto food-grade tannic-acid immobilised powdered activated carbon (TA-PAC) in the presence of dissolved humic acid (DHA) was investigated at 280 K as a function of pH, along with the adsorption capacities and the adsorption isotherms for chromium ions. The results showed that the presence of DHA improved the adsorption capacities of Cr(VI) and its reduction product (Cr(III)) over a wide pH range (4.0-8.0). The main mechanism for metal-DHA complexation in the Cr(VI) system was the reduction of Cr(VI) followed by complexation between Cr(III) and DHA. The Freundlich isotherms yielded the best fits to all data (R(2)=0.9951, qm=5.639 mg/g) in the presence of DHA. The adsorption mechanisms of Cr(VI) onto TA-PAC in the presence of DHA were summarized into three categories: (i) binding by anion adsorption, (ii) Cr(VI) reduction followed by Cr(III) adsorption, and (iii) adsorption of Cr(III)-DHA complexes.

Removal of Cr(VI) from low-temperature micro-polluted surface water by tannic acid immobilized powdered activated carbon.

In this study, food-grade tannic acid-immobilized powdered activated carbon (TA-PAC) was prepared, and adsorption of Cr(VI) (0.500 mg/L) onto TA-PAC as a function of pH, contact time, adsorption capacities and adsorption isotherms at 280 K was investigated. The results indicated that the immobilization process introduced abundant acid functional groups. The adsorption capacity of TA-PAC was found to be pH-dependent, and the optimal pH value was found to be 4.0. The equilibrium time was 240 min for TA-PAC. Adsorption data for total chromium were modeled using both two-parameter and three-parameter isotherm models. Freundlich and linear forms of three-parameter models yielded the best results for all of the data. Desorption studies of immobilized material suggested that the immobilization of food-grade tannic acid is steady. The adsorption mechanism of Cr(VI) on TA-PAC was assumed to be a comprehensive process consisting of surface reduction of Cr(VI), esterification between catechol and chromate, and ion exchange.