Influence of Water on the Oxidation of NO on Pd/TiO2 Photocatalysts.

Two series of new photocatalysts were synthesized based on modification with Pd of the commercial P25 photocatalyst (EVONIK®). Two techniques were employed to incorporate Pd nanoparticles on the P25 surface: photodeposition (series Pd-P) and impregnation (series Pd-I). Both series were characterized in depth using a variety of instrumental techniques: BET, DRS, XRD, XPS, TEM, FTIR and FESEM. The modified series exhibited a significant change in pore size distribution, but no differences compared to the original P25 with respect to crystalline phase ratio or particle size were observed. The Pd0 oxidation state was predominant in the Pd-P series, while the presence of the Pd2+ oxidation state was additionally observed in the Pd-I series. The photoactivity tests were performed in a continuous photoreactor with the photocatalysts deposited, by dip-coating, on borosilicate glass plates. A total of 500 ppb of NO was used as input flow at a volumetric flow rate of 1.2 L·min-1, and different relative humidities from 0 to 65% were tested. The results obtained show that under UV-vis or Vis radiation, the presence of Pd nanoparticles favors NO removal independently of the Pd incorporation method employed and independently of the tested relative humidity conditions. This improvement seems to be related to the different interaction of the water with the surface of the photocatalysts in the presence or absence of Pd. It was found in the catalyst without Pd that disproportionation of NO2 is favored through its reaction with water, with faster surface saturation. In contrast, in the catalysts with Pd, disproportionation took place through nitro-chelates and adsorbed NO2 formed from the photocatalytic oxidation of the NO. This different mechanism explains the greater efficiency in NOx removal in the catalysts with Pd. Comparing the two series of catalysts with Pd, Pd-P and Pd-I, greater activity of the Pd-P series was observed under both UV-vis and Vis radiation. It was shown that the Pd0 oxidation state is responsible for this greater activity as the Pd-I series improves its activity in successive cycles due to a reduction in Pd2+ species during the photoactivity tests.

[Subsequent reoperation obstetric hysterectomy and selective ligation of hypogastric arteries]. / Reintervención posterior a histerectomía obstétrica y ligadura selectiva de arterias hipogástricas.

Background: Bleeding in pregnancy, childbirth or postpartum period is an emergency. Selective internal iliac (hypogastric) arteries ligation is a surgical therapy in selected cases of obstetric massive hemorrhage. It had proven to be safe. Objetive: To evaluate the risk for re-intervention for post-operatory bleeding in patients with obstetric hysterectomy and selective hypogastric arteries ligation. Material and method: Cross-sectional study including women diagnosed with obstetric hysterectomy with and without selective arterial ligation as a factor to assess the risk of re-intervention, from December 2013 to December 2014, at High Specialty Medical Unit 23 of Gynaecology and Obstetrics, in Monterrey, which is a tertiary care medical center. Those patients with 28 weeks of gestation or more were selected. The postoperative blood loss was quantified by open drainage system (Penrose). Results: We performed 88 hysterectomies in the study period. We included 45 women according to selection criteria. The average was 31.9 ± 5.48 years old. Performing a selective hypogastric arteries ligation may be a protective factor (p<0.05) for re-intervention as a consequence of postoperative bleeding. Conclusion: Selective arterial ligation is a factor that could help to prevent a re-intervention. A continuous training of physicians and residents of Gynecology and Obstetrics is essential to ensure the reduction in morbidity and maternal mortality.

Comparative study of nanocrystalline titanium dioxide obtained through sol-gel and sol-gel-hydrothermal synthesis.

TiO2 particles were prepared by sol-gel method alone and by sol-gel method combined with hydrothermal treatment. The structural and photocatalytic properties of the two series of photocatalysts were compared. XRD studies revealed that rutilization was faster in the series of photocatalysts, which had been additionally subjected to a hydrothermal process (SG-HT). The hydrothermally treated photocatalysts also displayed a higher specific surface area than those which had only been synthesized using the sol-gel process (SG) and subjected to low calcination temperatures of up to 873 K, while this tendency was inverted at higher temperatures. In accordance with the above observation, the hydrothermally treated series of photocatalysts had a lower particle size than the SG series calcined immediately after the sol-gel process up to 873 K, with this relation being inverted for the highest two temperatures which were studied (973 K and 1023 K) and which saw the commencement of rutilization. Increases in average particle size were observed for both series, with a polyhedral morphology seen as calcination temperature rose. FTIR studies highlighted the presence of the band at 2351 cm(-1) in the SG-HT photocatalysts, characteristic of surface-adsorbed CO2. This was not seen in the SG or P25 photocatalysts. In terms of photoreactivity, the best photocatalyst in the SG-HT series was that calcined at 923 K and in the SG series at 1023 K (SG-1023). Comparing these two photocatalysts and the commercial P25 photocatalyst, SG-1023 was found to be the most photoactive in both the photodegradation and the mineralization of phenol.

Effect of additives in photocatalytic degradation of commercial azo dye Lanaset Sun Yellow 180.

The photocatalytic degradation of the commercial dye Lanaset Sun Yellow 180 was studied in the presence and absence of the different additives used in the dye's formulation. The experiments were performed with Degussa P25 as received and doped with Fe (Fe-TiO2) and a new catalyst synthesized by our research group (ECT-1023). The best efficiency was achieved with Fe-TiO2. With this catalyst, the formation of a photoactive complex was observed between the dye and Fe atoms of the catalyst surface that accelerated degradation. FTIR studies revealed that the complex was formed by interaction between the dye's carbonyl groups and the atoms of the metal. In mixtures of the dye containing citric acid or acetate, degradation was notably inhibited with the catalysts Fe-TiO2 and ECT-1023 because of the formation of carboxylates on their surface. This inhibitory effect was neutralized when all the additives were present in the solution. Toxicity analyses indicated that intermediates were not toxic. Thus, the photocatalytic methods seem to be optimal for the decolourization of wastewaters containing this dye.

High levels of polychlorinated biphenyls in tissues of Atlantic turtles stranded in the Canary Islands, Spain.

Polychlorinated biphenyls (PCBs 28, 31, 52, 101, 138, 153, 180, and 209) were measured in tissue samples (liver and fat) from 30 loggerhead turtles Caretta caretta, 1 green turtle Chelonia mydas, and 1 leatherback Dermochelys coriacea stranded on the coasts of the Canary Islands, trying to establish a possible relation between PCB concentrations and the lesions and causes of death. Tissues from these turtles contained higher levels of PCBs than those reported in turtles from other geographical regions. Sigma PCB concentrations (1980+/-5320 ng g(-1)wet wt.) in the liver of loggerheads were higher than in the adipose tissue (450+/-1700 ng g(-1)wet wt.). Concentrations of PCB 209 in the liver (1200+/-3120 ng g(-1)wet wt.) of loggerheads and in the liver (530 ng g(-1)wet wt.) and adipose tissue (500 ng g(-1)wet wt.) of the leatherback were remarkable. Frequencies of detection of PCB 209 in the liver (15.5%) and adipose tissue (31%) were also remarkable. Cachexia was detected in 7 turtles (22%) and septicemia was diagnosed in 10 turtles (31%). Statistically, a positive correlation was detected between Sigma PCBs concentration and cachexia. Poor physical condition, cachexia and/or septicaemia could explain the high levels of PCBs and tissue distribution. However, no histological lesions exclusively attributed to the acute effects of PCBs were described. The most prevalent histological lesions were ulcerative and purulent oesophagitis, purulent dermatitis, necrotizing enteritis, and granulomatous pneumonia. The bacteria most frequently isolated were Escherichia coli, Staphylococcus sp., and Aeromonas sp. Although immunosupression as a result of PCBs pollution has been described previously, other factors in this study, such as incidental fishing, nutritional status, and exposition to different micro-organisms, make it difficult to establish a clear association between PCB concentrations and causes of death.

Photocatalytic degradation of phenol and phenolic compounds Part I. Adsorption and FTIR study.

With the goal of predicting the photocatalytic behaviour of different phenolic compounds (catechol, resorcinol, phenol, m-cresol and o-cresol), their adsorption and interaction types with the TiO(2) Degussa P-25 surface were studied. Langmuir and Freundlich isotherms were applied in the adsorption studies. The obtained results indicated that catechol adsorption is much higher than those of the other phenolics and its interaction occurs preferentially through the formation of a catecholate monodentate. Resorcinol and the cresols interact by means of hydrogen bonds through the hydroxyl group, and their adsorption is much lower than that of catechol. Finally, phenol showed an intermediate behaviour, with a Langmuir adsorption constant, K(L), much lower than that of catechol, but a similar interaction. The interaction of the selected molecules with the catalyst surface was evaluated by means of FTIR experiments, which allowed us to determine the probability of OH radical attack to the aromatic ring.

Photocatalytic degradation of formaldehyde containing wastewater from veterinarian laboratories.

The photocatalytic destruction of methanol, formaline (mixture of formaldehyde, methanol and water) and formaline wastes from the preservation of vertinarian physiologic samples has been attempted by two different processes, at high concentrations of reagents and by dossification of reagents, varying pH in both. Experiment evolution has been monitored by measuring the organic matter such as TOC and formaldehyde concentrations [H2CO]. Also, methanol and methanol-formaldehyde interactions with the TiO2 surface have been analysed by FTIR spectroscopy. Results indicate that at high concentrations the catalyst surfacial alterations given by methoxy, formates or carbonates, according to the pH of the sample can profoundly affect catalyst behaviour. It has been established that reagent dossification is advantageous for enhancing photonic efficiency as it minimizes the adsorbate presence that hampers the photocatalytic process.

Highly concentrated phenolic wastewater treatment by the photo-Fenton reaction, mechanism study by FTIR-ATR.

Phenol degradation by Photo-Fenton reaction has been studied in highly concentrated wastewaters and most intermediate species have been identified by Fourier Transform IR-Spectroscopy with ATR device. During the photodegradation of highly concentrated phenol solutions, the formation of dissolved and precipitate tannin has been observed. The possibility of a Fe3+-Pyrogallol complex formation, previous to the tannin formation, has been proposed too. The complex formation involving Fe3+ ions could be related to the observed Photo-Fenton activity decrease. Tannin formation inhibits the complete mineralization of phenol because *OH radicals attack will produce further condensation steps and the polymer size increase. This fact limits the applicability of the process for highly concentrated phenolic wastes mineralization. However, the tannin precipitation allows its separation from the solution by conventional filtration, and reduction of the corresponding dissolved organic carbon. These observations have been proved from the identification of primary degradation products, catechol and hydroquinone. Catechol is considered to be the first step for the formation of tannins. Degradation process for phenol, catechol and hydroquinone have been monitored by total organic carbon (TOC) measurements along the reaction time span. From these results, a global mechanism for the Photo-Fenton degradation of phenol is proposed.

[Nongynecological surgical procedures performed by an oncological gynecology service]. / Procedimientos quirúrgicos no ginecológicos, realizados por un servicio de ginecología oncológica.

From March, 1987 to July 1990, 1,568 surgical procedures, were done at Oncological Gynecology Service; 206 of them (13.1%) were considered as "non-gynecological" surgical procedures; 182 (88.3%) were secondary to a malignity diagnosis, being the most frequent one ovarian carcinoma (54.4%). As to benign lesions, 11.7% caused "non gynecological" surgery, most frequent were severe pelvic adhesions, 41.6%, and severe endometriosis, 25%. "Non-gynecological" surgical procedure carried out most frequently was pelvic lymphadenectomy. Morbidity was 3.8%, and mortality, 0.48% due to acute myocardial infarction. The acceptance for oncologic gynecologist is justified in this series, based on survival and morbi-mortality, which permits the participation in a multidisciplinary team.