Mechanism of Inhibition of beta-site amyloid precursor protein-cleaving enzyme (BACE) by a statine-based peptide.

Inhibition of beta-site amyloid precursor protein-cleaving enzyme by a statine-based inhibitor has been studied using steady state and stopped-flow methods. A slow onset rate of inhibition has been observed under steady state conditions, and a K(i) of 22 nm has been derived using progress curves analysis. Simulation of stopped-flow protein fluorescence transients provided an estimate of the K(d) for initial inhibitor binding of 660 nm. A two-step inhibition mechanism is proposed, wherein slower "tightening up" of the initial encounter complex occurs. Two hypotheses have been proposed in the literature to address the nature of the slow step in the inhibition of aspartic proteases by peptidomimetic inhibitors: a conformational change related to the "flap" movement and displacement of a catalytic water. We compared substrate and inhibitor binding rates under pre-steady-state conditions. Both ligands are likely to cause flap movement, whereas no catalytic water replacement occurs during substrate binding. Our results suggest that both ligands bind to the enzyme at a rate significantly lower than the diffusion limit, but there are additional rate limitations involved in inhibitor binding, resulting in a k(on) of 3.5 x 10(4) m(-)1 s(-)1 for the inhibitor compared with 3.5 x 10(5) m(-)1 s(-)1 for the substrate. Even though specific intermediate formation steps might be different in the productive inhibitor and substrate binding to beta-site amyloid precursor protein-cleaving enzyme, a similar final optimized conformation is achieved in both cases, as judged by the comparable free energy changes (DeltaDeltaG of 2.01 versus 1.97 kcal/mol) going from the initial to the final enzyme-inhibitor or enzyme-substrate complexes.

Analysis of protein-peptide interaction by a miniaturized fluorescence polarization assay using cyclin-dependent kinase 2/cyclin E as a model system.

As a result of the increasing size of chemical libraries, more rapid and highly sensitive strategies are needed to accelerate the process of drug discovery without increasing the cost. One means of accomplishing this is to miniaturize the assays that enter high-throughput screening (HTS). Miniaturization requires an assay design that has few steps, has a large degree of separation between the signal and background, and has a low well to well signal variation. Fluorescence polarization (FP) is an assay type that, in many cases, meets all of the above requirements. FP is a homogenous method that allows interactions between molecules to be measured directly in solution. This article demonstrates the application of FP in a miniaturized HTS format, using 1536-well plates, to measure direct binding between cyclin-dependent kinase 2/cyclin E complex (CDK2/E) and an 8-mer-peptide kinase inhibitor. The data indicate that low variability and high specificity allow rapid and precise identification of antagonist compounds affecting CDK2/E-peptide interactions.

Amino acids that specify structure through hydrophobic clustering and histidine-aromatic interactions lead to biologically active peptidomimetics.

Acyclic beta-sheet structure can be nucleated in heptapeptides when the 4-(2-aminoethyl)-6-dibenzofuranpropanoic acid residue (1) is flanked in sequence by two His residues, a His residue and a hydrophobic residue or by two hydrophobic residues. Acyclic beta-sheet peptidomimetics having an appropriate sequence have sufficient structural integrity to exhibit antimicrobial activity equivalent to that of gramicidin S.