RESUMEN
BACKGROUND: This biomechanical study aimed to test if the fixation of the posterior malleolus (PM) only with screws inserted from posterior to anterior (PA) restores stability comparable with the natural condition. The extent of stability was also compared with that of anterior to posterior (AP) screw osteosynthesis (OS) with an additional syndesmotic screw (SS). METHODS: First, the stability of the upper ankle joint in seven pairs of intact lower legs were examined. Subsequently, half of the lower legs were treated with PA screw fixation of a PM fracture without SS and the other half with AP screw fixation with additional tricortical SS. RESULTS: PA OS without SS showed significantly more diastasis (p = 0.027). The AP OS with an SS revealed a diastasis that was comparable with the intact condition (p = 0.797). The use of SS led to significantly higher stability compared to OS without SS (p = 0.019). CONCLUSIONS: The Fixation of the PM alone without an additional syndesmotic screw cannot achieve intact upper ankle stability. Fixation of a PM fracture with an SS helps in nearly achieving the natural condition.
Asunto(s)
Fracturas de Tobillo , Traumatismos del Tobillo , Inestabilidad de la Articulación , Fracturas de Tobillo/diagnóstico por imagen , Fracturas de Tobillo/cirugía , Traumatismos del Tobillo/diagnóstico por imagen , Traumatismos del Tobillo/cirugía , Articulación del Tobillo/cirugía , Tornillos Óseos , Fijación Interna de Fracturas , Humanos , Inestabilidad de la Articulación/etiología , Inestabilidad de la Articulación/cirugía , Rango del Movimiento Articular , Resultado del TratamientoRESUMEN
BACKGROUND: Various plate shapes and implant configurations are used for stabilization of acetabulum fractures via anterior approaches. Little is known about the biomechanical stability of a two-dimensionally shaped "conventional" plate ("J-Plate"-JP) in comparison to three-dimensionally shaped plate configurations (3DP). In addition, the augmentary effect of an infra-acetabular lag-screw (IACS) fixation for anterior column and posterior hemi-transverse acetabulum fractures has not been clarified in comparison of JP and 3DP constructs. This study analyzed the difference between the biomechanical stability of JP compared to 3DP and the role of an IACS in a standardized acetabular fracture model in a single-leg stance loading configuration. METHODS: In an artificial bone substitute pelvis model (Synbone© Malans, Switzerland), a typical and standardized fracture pattern (anterior column and posterior hemi-transverse) was created with osteotomy jigs. After anatomic reduction the stabilization was performed using JP or 3DP. Eight pelvises per group were axially loaded in a single-leg stance model up to 400 N. After the load cycle, an additional infra-acetabular screw was placed and the measurement repeated. Fragment displacement was recorded by an optical tracking system (Optitrack Prime 13®, Corvallis, USA). RESULTS: In the pure placement, 3DP provided significantly superior stability when compared to JP. Augmentation of JP by IACS increased the stability significantly, up to the level of 3DP alone, whereas augmentation of the 3DP did not result in further increase of overall stability. CONCLUSION: The anatomically shaped plate alone provides a superior biomechanical stability in fixation of an anterior column and posterior hemi-transverse fracture model. In a JP fixation the augmentation by IACS provides similar strength as the anatomically shaped 3DP. By use of the anatomically shaped 3DP the need of a clinically risky application of IACS might be avoidable. LEVEL OF EVIDENCE: IV, Experimental study.