Erratum: Using Diffuse Scattering to Observe X-Ray-Driven Nonthermal Melting [Phys. Rev. Lett. 126, 015703 (2021)].

This corrects the article DOI: 10.1103/PhysRevLett.126.015703.

Using Diffuse Scattering to Observe X-Ray-Driven Nonthermal Melting.

We present results from the SPring-8 Angstrom Compact free electron LAser facility, where we used a high intensity (∼10^{20} W/cm^{2}) x-ray pump x-ray probe scheme to observe changes in the ionic structure of silicon induced by x-ray heating of the electrons. By avoiding Laue spots in the scattering signal from a single crystalline sample, we observe a rapid rise in diffuse scattering and a transition to a disordered, liquidlike state with a structure significantly different from liquid silicon. The disordering occurs within 100 fs of irradiation, a timescale that agrees well with first principles simulations, and is faster than that predicted by purely inertial behavior, suggesting that both the phase change and disordered state reached are dominated by Coulomb forces. This method is capable of observing liquid scattering without masking signal from the ambient solid, allowing the liquid structure to be measured throughout and beyond the phase change.

Mirror to measure small angle x-ray scattering signal in high energy density experiments.

Small angle x-ray scattering (SAXS) is a well established technique to detect nanometer scale structures in matter. In a typical setup, this diagnostic uses a detector with a direct line of sight to the scattering target. However, in the harsh environment of high intensity laser interaction, intense secondary radiation and high-energy particles are generated. Such a setup would therefore suffer a significant increase of noise due to this background, which could eventually prevent such measurements. In this paper, we present a novel tool consisting of a mosaic graphite crystal that works as a mirror for the SAXS signal and allows us to position the detector behind appropriate shielding. This paper studies the performance of this mirror both by experiment at the European XFEL (X-Ray Free-Electron Laser Facility) laboratory and by simulations.

Glutamic acid leaching of synthetic covellite - A model system combining experimental data and geochemical modeling.

For Kupferschiefer mining established pyrometallurgical and acidic bioleaching methods face numerous problems. This is due to the finely grained and dispersed distribution of the copper minerals, the complex mineralogy, comparably low copper content, and the possibly high carbonate and organic content in this ore. Leaching at neutral pH seemed worth a try: At neutral pH the abundant carbonates do not need to be dissolved and therewith would not consume excessive amounts of provided acids. Certainly, copper solubility at neutral pH is reduced compared to an acidic environment; however, if copper complexing ligands would be supplied abundantly, copper contents in the mobile phase could easily reach the required economic level. We set up a model system to study the effect of parameters such as pH, microorganisms, microbial metabolites, and organic ligands on covellite leaching to get a better understanding of the processes in copper leaching at pH ≥ 6. With this model system we could show that glutamic acid and the microbial siderophore desferrioxamine B promote covellite dissolution. Both experimental and modeling data showed that pH is an important parameter in covellite dissolution. An increase of pH from 6 to 9 could elevate copper extraction in the presence of glutamic acid by a factor of five. These results have implications for both development of a biotechnological process regarding metal extraction from Kupferschiefer, and for the interaction of bacterial metabolites with the lithosphere and potential mobilization of heavy metals in alkaline environments.

Production of three-dimensional quantum dot lattice of Ge/Si core-shell quantum dots and Si/Ge layers in an alumina glass matrix.

We report on the formation of Ge/Si quantum dots with core/shell structure that are arranged in a three-dimensional body centered tetragonal quantum dot lattice in an amorphous alumina matrix. The material is prepared by magnetron sputtering deposition of Al2O3/Ge/Si multilayer. The inversion of Ge and Si in the deposition sequence results in the formation of thin Si/Ge layers instead of the dots. Both materials show an atomically sharp interface between the Ge and Si parts of the dots and layers. They have an amorphous internal structure that can be crystallized by an annealing treatment. The light absorption properties of these complex materials are significantly different compared to films that form quantum dot lattices of the pure Ge, Si or a solid solution of GeSi. They show a strong narrow absorption peak that characterizes a type II confinement in accordance with theoretical predictions. The prepared materials are promising for application in quantum dot solar cells.

Influence of annealing conditions on the formation of regular lattices of voids and Ge quantum dots in an amorphous alumina matrix.

In this work, the influence of air pressure during the annealing of Ge quantum dot (QD) lattices embedded in an amorphous Al(2)O(3) matrix on the structural, morphological and compositional properties of the film is studied. The formation of a regularly ordered void lattice after performing a thermal annealing process is explored. Our results show that both the Ge desorption from the film and the regular ordering of the QDs are very sensitive to the annealing parameters. The conditions for the formation of a void lattice, a crystalline Ge QD lattice and a disordered QD lattice are presented. The observed effects are explained in terms of oxygen interaction with the Ge present in the film.

Structure and temperature behavior of metallo-supramolecular assemblies.

A detailed structural analysis of a Langmuir-Blodgett (LB) multilayer composed of a polyelectrolyte-amphiphile complex (PAC) is presented. The PAC is self-assembled from metal ions, ditopic bis-terpyridines, and amphiphiles. The vertical structure of the LB multilayer is investigated by X-ray reflectometry. The multilayer has a periodicity of 57 A, which corresponds to an architecture of flat lying metallo-supramolecular coordination polyelectrolyte (MEPE) rods and upright-standing amphiphiles (dihexadecyl phosphate, DHP). In-plane diffraction reveals hexagonal packing of the DHP molecules. Using extended X-ray absorption fine structure (EXAFS) experiments, we prove that the central metal ion is coordinated to the terpyridine moieties in a pseudo-octahedral coordination environment. The Fe-N bond distances are 1.82 and 2.0 A, respectively. Temperature resolved measurements indicate a reversible phase transition in a temperature range up to 55 degrees C. EXAFS measurements indicate a lengthening of the average Fe-N bond distance from 1.91 to 1.95 A. The widening of the coordination cage upon heating is expected to lower the ligand field stabilization, thus giving rise to spin transitions in these composite materials.

Temperature- and time-resolved X-ray scattering at thin organic films.

Multilayers of an Fe(II)-polyelectrolyte-amphiphile complex (Fe-PAC) were investigated simultaneously by energy-dispersive X-ray reflectivity and in-plane diffraction at the bending-magnet beamline at BESSY II. By recording spectra between room temperature and about 348 K with a time resolution of about 60 s, two phase transitions were identified and the respective activation energies were determined. Owing to a fixed geometrical set-up, an energy-dispersive experiment is suitable for measuring X-ray reflectivity and in-plane X-ray diffraction of thin organic films simultaneously. Installed at a bending magnet at BESSY II and using an energy range of 4 < E < 25 keV, both reflectivity and diffraction spectra can be collected within about 60 s. The performance is demonstrated by temperature- and time-resolved measurements of the phase transition behaviour of multilayers of an Fe-PAC deposited on a silicon support by means of the Langmuir-Blodgett (LB) technique. By measuring the X-ray reflectivity while increasing the temperature, it is shown that the original LB phase is not stable and transforms irreversibly into a liquid-crystalline (LC)-like phase at about 318 K. At the same temperature the in-plane diffraction signal vanishes reversibly, reflecting rotational disorder of the hexagonal arrangement of amphiphilic chains. Its activation energy is determined to be about 1.3 eV. At about 338 K a second irreversible phase transition occurs to another LC phase with smaller vertical layer spacing. This transition is reversible between 329 K and 338 K.

Reversible negative thermal expansion of polymer films.

A basic understanding of the properties of thin polymer films is of fundamental importance for developing applications in nanotechnology. Results of energy and angle dispersive x-ray reflectivity measurements on polymer thin films as a function of temperature exhibit reversible negative thermal expansion below the glass transition temperature T(g). Above T(g), the thickness expansion becomes almost equal to the expected bulk volume expansion. These results could be explained on the basis of evolution of disorder with temperature at the interfaces, chain entanglement and associated entropy changes.