Relaxing constraints on data acquisition and position detection for trap stiffness calibration in optical tweezers.

Optical tweezers find applications in various fields, ranging from biology to physics. One of the fundamental steps necessary to perform quantitative measurements using trapped particles is the calibration of the tweezer's spring constant. This can be done through power spectral density analysis, from forward scattering detection of the particle's position. In this work we propose and experimentally test simplifications to such measurement procedure, aimed at reducing post-processing of recorded data and dealing with acquisition devices that have frequency-dependent electronic noise. In the same line of simplifying the tweezer setup we also present a knife-edge detection scheme that can substitute standard position sensitive detectors.

Quantifying Photonic High-Dimensional Entanglement.

High-dimensional entanglement offers promising perspectives in quantum information science. In practice, however, the main challenge is to devise efficient methods to characterize high-dimensional entanglement, based on the available experimental data which is usually rather limited. Here we report the characterization and certification of high-dimensional entanglement in photon pairs, encoded in temporal modes. Building upon recently developed theoretical methods, we certify an entanglement of formation of 2.09(7) ebits in a time-bin implementation, and 4.1(1) ebits in an energy-time implementation. These results are based on very limited sets of local measurements, which illustrates the practical relevance of these methods.

MHz rate and efficient synchronous heralding of single photons at telecom wavelengths.

We report on the realization of a synchronous source of heralded single photons at telecom wavelengths with MHz heralding rates and high heralding efficiency. This source is based on the generation of photon pairs at 810 and 1550 nm via Spontaneous Parametric Down Conversion (SPDC) in a 1 cm periodically poled lithium niobate (PPLN) crystal pumped by a 532 nm pulsed laser. As high rates are fundamental for multi-photon experiments, we show that single telecom photons can be announced at 4.4 MHz rate with 45% heralding efficiency. When we focus only on the optimization of the coupling of the heralded photon, the heralding efficiency can be increased up to 80%. Furthermore, we experimentally observe that group velocity mismatch inside long crystals pumped in a pulsed mode affects the spectrum of the emitted photons and their fibre coupling efficiency. The length of the crystal in this source has been chosen as a trade off between high brightness and high coupling efficiency.

A portable, inexpensive and microcontrolled spectrophotometer based on white LED as light source and CD media as diffraction grid.

A portable, microcontrolled and low-cost spectrophotometer (MLCS) is proposed. The instrument combines the use of a compact disc (CD) media as diffraction grid and white light-emitting diode (LED) as radiation source. Moreover, it employs a phototransistor with spectral sensitivity in visible region as phototransductor, as well as a programmable interrupt controller (PIC) microcontroller as control unit. The proposed instrument was successfully applied to determination of food colorants (tartrazine, sunset yellow, brilliant blue and allura red) in five synthetics samples and Fe(2+) in six samples of restorative oral solutions. For comparison purpose, two commercial spectrophotometers (HP and Micronal) were employed. The application of the t-paired test at the 95% confidence level revealed that there are not significant differences between the concentration values estimated by the three instruments. Furthermore, a good precision in the analyte concentrations was obtained by using MLCS. The overall relative standard deviation (R.S.D.) of each analyte was smaller than 1.0%. Therefore, the proposed instrument offers an economically viable alternative for spectrophotometric chemical analysis in small routine, research and/or teaching laboratories, because its components are inexpensive and of easy acquisition.