RESUMEN
Due to the rapid melting and solidification during directed energy deposition (DED) process, the defects and columnar crystals are likely to generate in the deposition layers, which reduce the quality and performance of the whole parts. Therefore, in order to improve the microstructure and mechanical properties of 1Cr12Ni3MoVN alloy manufactured by DED method, ultrasonic vibration (UV) has been employed to assist directed energy deposition process in this work. The results indicate that the high-intensity ultrasonic vibration can weaken the epitaxy growth tendency of crystal grains, and significantly improve plasticity while keeping an approximate strength. In addition, a two-dimensional numerical model is established to simulate the effect of ultrasonic vibration in the molten pool. The simulation results show that ultrasonic vibration remarkably improves the flow velocity and pressure in the molten pool, inducing the cavitation effect that breaks dendritic crystal and affects crystal characteristics. Meanwhile, the acoustic streaming effect changes the thermodynamic conditions and promotes high-temperature diffusion, which uniforms temperature distribution and reduces the temperature gradient in the molten pool. Thus the reduced temperature gradient G and raised solidification growth rate R promote the formation of fine equiaxed crystal characteristics after UV treatment. The product G × R increases and the ratio G/R decreases after UV treatment, resulting in the formation of fine equiaxed crystals.
RESUMEN
The formation of the coarse columnar crystal structure of Ti-6Al-4V alloy in the process of additive manufacturing greatly reduces the mechanical performance of the additive manufactured parts, which hinders the applications of additive manufacturing techniques in the engineering fields. In order to refine the microstructure of the materials using the high intensity ultrasonic via the acoustic cavitation and acoustic flow effect in the process of metal solidification, an ultrasonic vibration technique was developed to a synchronous couple in the process of Laser and Wire Additive Manufacturing (LWAM) in this work. It is found that the introduction of high-intensity ultrasound effectively interrupts the epitaxial growth tendency of prior-ß crystal and weakens the texture strength of prior-ß crystal. The microstructure of Ti-6Al-4V alloy converts to fine columnar crystals from typical coarse columnar crystals. The simulation results confirm that the acoustic cavitation effect applied to the molten pool created by the high-intensity ultrasound is the key factor that affects the crystal characteristics.
RESUMEN
An efficient palladium-catalyzed dearomatizing [2+2+1] carbocyclization of 1,7-enynes with iodophenols has been developed. A type of tetracyclic scaffold was built in this reaction, exhibiting a broad substrate scope with moderate to excellent yields. More importantly, this method provides a potential strategy for the synthesis of tetracyclic skeleton natural products.
