RESUMEN
Fiber Bragg grating (FBG) sensors are typically spot-bonded onto the surface of a structure to detect ultrasonic waves in laboratory demonstrations. However, to protect the rest of the optical fiber from any environmental damage during real applications, bonding the entire length of fiber, called continuous bonding, is commonly done. In this paper, we investigate the impact of continuously bonding FBGs on the measured Lamb wave signal. In theory, the ultrasonic wave signal can bi-directionally transfer between the optical fiber and the plate at any adhered location, which could potentially produce output signal distortion for the continuous bonding case. Therefore, an experiment is performed to investigate the plate-to-fiber and fiber-to-plate signal transfer, from which the signal coupling coefficient of each case is theoretically estimated based on the experimental data. We demonstrate that the two coupling coefficients are comparable, with the plate-to-fiber case approximately 19% larger than the fiber-to-plate case. Finally, the signal waveform and arrival time of the output FBG responses are compared between the continuous and spot bonding cases. The results indicate that the resulting Lamb wave signal output is only that directly detected at the FBG location; however, a slight difference in signal waveform is observed between the two bonding configurations. This paper demonstrates the practicality of using continuously bonded FBGs for ultrasonic wave detection in structural health monitoring (SHM) applications.
RESUMEN
The development and validation of a high-speed, full-spectrum measurement technique is described for fiber Bragg grating (FBG) sensors. A FBG is surface-mounted to a split-Hopkinson tensile bar specimen to induce high strain rates. The high strain gradients and large strains that indicate material failure are analyzed under high strain rates up to 500 s-1. The FBG is interrogated using a high-speed full-spectrum solid-state interrogator with a repetition rate of 100 kHz. The captured deformed spectra are analyzed for strain gradients using a default interior point algorithm in combination with the modified transfer matrix approach. This paper shows that by using high-speed full-spectrum interrogation of an FBG and the modified transfer matrix method, highly localized strain gradients and discontinuities can be measured without a direct line of sight.
RESUMEN
Networks of fiber Bragg grating (FBG) sensors can serve as structural health monitoring systems for large-scale structures based on the collection of ultrasonic waves. The demodulation of structural Lamb waves using FBG sensors requires a high signal-to-noise ratio because the Lamb waves are of low amplitudes. This paper compares the signal transfer amplitudes between two adhesive mounting configurations for an FBG to detect Lamb waves propagating in an aluminum plate: a directly bonded FBG and a remotely bonded FBG. In the directly bonded FBG case, the Lamb waves create in-plane and out-of-plane displacements, which are transferred through the adhesive bond and detected by the FBG sensor. In the remotely bonded FBG case, the Lamb waves are converted into longitudinal and flexural traveling waves in the optical fiber at the adhesive bond, which propagate through the optical fiber and are detected by the FBG sensor. A theoretical prediction of overall signal attenuation also is performed, which is the combination of material attenuation in the plate and optical fiber and attenuation due to wave spreading in the plate. The experimental results demonstrate that remote bonding of the FBG significantly increases the signal amplitude measured by the FBG.