Evaluation using hoof wall strain gauges of a therapeutic shoe and a hoof cast with a heel wedge as potential supportive therapy for horses with laminitis.

OBJECTIVE: To evaluate using strain gauges, a hoof cast with heel wedge, and a therapeutic shoe with unsupported toe for their effectiveness in redistribution of load from the dorsal hoof wall. STUDY DESIGN: In vitro biomechanical study. SAMPLE POPULATION: Twenty forelimb specimens. METHODS: Rosette strain gauges were placed on the dorsal and lateral hoof wall of 20 normal shaped hooves. Limbs were loaded vertically using a tensile testing machine with a 1 Hz sinusoidally cycling load up to 3000 N during 15 seconds. Mean values of principal strain and direction at 2500 N load were calculated for 3 experimental conditions (unshod, therapeutic shoe with unsupported toe, and hoof cast with heel elevation) and tested by ANOVA (P<.05). RESULTS: Vertical limb loading in an unshod hoof leads to a biaxial compression of the dorsal wall with high longitudinal compression (epsilon2 = -1515 microm/m). Principal strain at the dorsal wall (epsilon2) was decreased by 23% with the therapeutic shoe and by 59% with the hoof cast. On the lateral hoof wall principal strain was unchanged with the shoe, but increased by 34% with the cast. CONCLUSIONS: Strain measurements indicate unloading of the dorsal hoof wall by both methods with the cast being more effective than the shoe. CLINICAL RELEVANCE: The hoof cast with wedge offers substantial unloading of the dorsal wall, but increases load on the quarter. Therefore a hoof cast would likely be most helpful in acute laminitis when palmar structures can still bear load. The therapeutic shoe offers rehabilitation and regrowth of the dorsal wall without increased load on the quarter wall.

[Measurement of temperature generation in the corium of bovine claws during claw trimming with an angle grinder using different grinding and cutting disks]. / Temperaturentwicklung an der Sohlenlederhaut des Rindes während der Klauenpflege mit dem Winkelschleifer unter Verwendung verschiedener Schleif- und Messerscheiben.

On 80 bovine hindclaws from slaughtered cows a correct functional claw trimming (sole horn thickness 5 mm; group 1) and on further 80 hindclaws a standardised, incorrect claw trimming (sole horn thickness 2 mm; group 2) was performed using 4 different disks (one cutting, three grinding disks). Two thermocouples were inserted into the solar corium and the heat production on the corium was measured during claw trimming. During correct functional claw trimming with each of the 4 disks a temperature increase in the corium with a median of < or = 0.3 degrees C was calculated. During incorrect claw trimming (2 mm sole horn thickness) a temperature increase with a median of < or = 0.3 degrees C for the first three disks was determined. During claw trimming using the abrasive semiflexible plastic disk a median of 1.3 degrees C temperature increase was calculated. Comparison of the temperatures measured in the claws from group 1 and 2 showed a statistically significant difference between all four disks. Comparison of the temperature increase within each group (group 1 and 2) revealed a statistically significant difference between the cutting disk with steel blades and the abrasive, semiflexible plastic disk in both groups. The highest temperatures measured were 41.5 degrees C in group 1 using the disk with 70% amount of fitted hard metal granulate, and 42.2 degrees C in group 2 (temperature increase of 10.6 degrees C) using the abrasive semiflexible plastic disk. Under the experimental conditions of this study, only a very slight thermogenesis was found when a functional and correct claw trimming using the 4 tested disks was performed. This slight thermogenesis should not be able to cause thermic injury of the corium. By trimming the sole horn incorrectly (2 mm) the measured heat generation in the corium was minor, without danger of thermic insult, excepted for using the disk with a 70% amount of fitted hard metal granulate and the abrasive semiflexible plastic disk. Even, it is unlikely that a short term temperature increase of 10.6 degrees C can cause thermic insults of the solar corium.