RESUMEN
Efficiently coupling single-photon emitters in the telecommunication C-band that are not deterministically positioned to photonic structures requires both spatial and spectral mapping. This study introduces the photoluminescence mapping of telecom C-band self-assembled quantum dots (QDs) by confocal laser scanning microscopy, a technique previously unexplored in this wavelength range which fulfills these two requirements. We consider the effects of distortions inherent to any imaging system but largely disregarded in prior works to derive accurate coordinates from photoluminescence maps. We obtain a position uncertainty below 11 nm for 10% of the QDs when assuming no distortions, highlighting the potential of the scanning approach. After distortion correction, we found that the previously determined positions are on average shifted by 428 nm from the corrected positions, demonstrating the necessity of this correction for accurate positioning. Then, through error propagation, the position uncertainty for 10% of the QDs increases to 110 nm.
RESUMEN
Entangled photon generation at 1550 nm in the telecom C-band is of critical importance as it enables the realization of quantum communication protocols over long distance using deployed telecommunication infrastructure. InAs epitaxial quantum dots have recently enabled on-demand generation of entangled photons in this wavelength range. However, time-dependent state evolution, caused by the fine-structure splitting, currently limits the fidelity to a specific entangled state. Here, we show fine-structure suppression for InAs quantum dots using micromachined piezoelectric actuators and demonstrate generation of highly entangled photons at 1550 nm. At the lowest fine-structure setting, we obtain a maximum fidelity of 90.0 ± 2.7% (concurrence of 87.5 ± 3.1%). The concurrence remains high also for moderate (weak) temporal filtering, with values close to 80% (50%), corresponding to 30% (80%) of collected photons, respectively. The presented fine-structure control opens the way for exploiting entangled photons from quantum dots in fiber-based quantum communication protocols.
RESUMEN
Entangled photons are an integral part in quantum optics experiments and a key resource in quantum imaging, quantum communication, and photonic quantum information processing. Making this resource available on-demand has been an ongoing scientific challenge with enormous progress in recent years. Of particular interest is the potential to transmit quantum information over long distances, making photons the only reliable flying qubit. Entangled photons at the telecom C-band could be directly launched into single-mode optical fibers, enabling worldwide quantum communication via existing telecommunication infrastructure. However, the on-demand generation of entangled photons at this desired wavelength window has been elusive. Here, we show a photon pair generation efficiency of 69.9 ± 3.6% in the telecom C-band by an InAs/GaAs semiconductor quantum dot on a metamorphic buffer layer. Using a robust phonon-assisted two-photon excitation scheme we measure a maximum concurrence of 91.4 ± 3.8% and a peak fidelity to the Φ+ state of 95.2 ± 1.1%, verifying on-demand generation of strongly entangled photon pairs and marking an important milestone for interfacing quantum light sources with our classical fiber networks.
RESUMEN
In this work, we demonstrate reconfigurable frequency manipulation of quantum states of light in the telecom C-band. Triggered single photons are encoded in a superposition state of three channels using sidebands up to 53 GHz created by an off-the-shelf phase modulator. The single photons are emitted by an InAs/GaAs quantum dot grown by metal-organic vapor-phase epitaxy within the transparency window of the backbone fiber optical network. A cross-correlation measurement of the sidebands demonstrates the preservation of the single photon nature; an important prerequisite for future quantum technology applications using the existing telecommunication fiber network.
RESUMEN
We report here the design and experimental demonstration of optically pumped photonic crystal bandedge membrane lasers on silicon-on-insulator (SOI) and on bulk silicon (Si) substrates, based on heterogeneously integrated InGaAsP multi-quantum-well membrane layers transfer printed onto patterned photonic crystal cavities. Single-mode lasing under room-temperature operation was observed at 1542 nm, with excellent side mode suppression ratio greater than 31.5 dB, for the laser built on SOI substrate. For the laser built on bulk Si substrate, single-mode lasing was also achieved at 1452 nm with much lower thermal resistance, as compared to that of the laser built on SOI substrates. Such improved thermal characteristics are favorable for lasers operating potentially at higher temperatures and higher power.
RESUMEN
We report here an optically pumped hybrid III-V/Si photoic crystal surface emitting laser (PCSEL), consisting of a heterogeneously integrated III-V InGaAsP quantum well heterostructure gain medium, printed on a patterned defect-free Si photonic crystal (PC) bandedge cavity. Single mode lasing was achieved for a large area laser, with a side-mode suppression ratio of 28 dB, for lasing operation temperature ~ 200 K. Two types of lasers were demonstrated operating at different temperatures. Detailed modal analysis reveals the lasing mode matches with the estimated lasing gain threshold conditions. Our demonstration promises a hybrid laser sources on Si towards three-dimensional (3D) integrated Si photonics for on-chip wavelength-division multiplex (3D WDM) systems for a wide range of volume photonic/electronic applications in computing, communication, sensing, imaging, etc.
RESUMEN
We have recently reported a 980nm GaAs-based three terminal Pnp transistor-vertical-cavity surface-emitting laser (TVCSEL) operating at room temperature with optical power up to 1.8mW. However, the current gain ß = ΔIc/ΔIb was near zero just before lasing and became negative after the lasing threshold. The main cause of the negative current gain was found to be a gradual and position-dependent forward-biasing (saturation) of the base-collector junction with increasing bias even before lasing threshold. In this article, detailed multi-physics device simulations are performed to better understand the device physics, and find ways to avoid the premature saturation of the base-collector junction. We have optimized the thickness of the base region as well as its doping concentration and the location of the quantum wells to ensure that the T-VCSEL is in the active mode throughout its range of operation. That is, the emitter-base junction is forward biased and base-collector junction is reversed biased for sweeping the excess charges out of the base region.
RESUMEN
InSb-based quantum dots grown by metal-organic vapor-phase epitaxy (MOVPE) on InAs substrates are studied for use as the active material in interband photon detectors. Long-wavelength infrared (LWIR) photoluminescence is demonstrated with peak emission at 8.5 µm and photoresponse, interpreted to originate from type-II interband transitions in a p-i-n photodiode, was measured up to 6 µm, both at 80 K. The possibilities and benefits of operation in the LWIR range (8-12 µm) are discussed and the results suggest that InSb-based quantum dot structures can be suitable candidates for photon detection in the LWIR regime.