Novel surface-enhanced Raman scattering-based assays for ultra-sensitive detection of human pluripotent stem cells.

Human pluripotent stem cells (hPSCs) are a promising cell source for regenerative medicine, but their derivatives need to be rigorously evaluated for residual stem cells to prevent teratoma formation. Here, we report the development of novel surface-enhanced Raman scattering (SERS)-based assays that can detect trace numbers of undifferentiated hPSCs in mixed cell populations in a highly specific, ultra-sensitive, and time-efficient manner. By targeting stem cell surface markers SSEA-5 and TRA-1-60 individually or simultaneously, these SERS assays were able to identify as few as 1 stem cell in 10(6) cells, a sensitivity (0.0001%) which was ∼2000 to 15,000-fold higher than that of flow cytometry assays. Using the SERS assay, we demonstrate that the aggregation of hPSC-based cardiomyocyte differentiation cultures into 3D spheres significantly reduced SSEA-5(+) and TRA-1-60(+) cells compared with parallel 2D cultures. Thus, SERS may provide a powerful new technology for quality control of hPSC-derived products for preclinical and clinical applications.

Cell alignment induced by anisotropic electrospun fibrous scaffolds alone has limited effect on cardiomyocyte maturation.

Enhancing the maturation of human pluripotent stem cell-derived cardiomyocytes (hPSC-CMs) will facilitate their applications in disease modeling and drug discovery. Previous studies suggest that cell alignment could enhance hPSC-CM maturation; however, the robustness of this approach has not been well investigated. To this end, we examined if the anisotropic orientation of hPSC-CMs imposed by the underlying aligned fibers within a 3D microenvironment could improve the maturation of hPSC-CMs. Enriched hPSC-CMs were cultured for two weeks on Matrigel-coated anisotropic (aligned) and isotropic (random) polycaprolactone (PCL) fibrous scaffolds, as well as tissue culture polystyrenes (TCPs) as a control. As expected, hPSC-CMs grown on the two types of fibrous scaffolds exhibited anisotropic and isotropic orientations, respectively. Similar to cells on TCPs, hPSC-CMs cultured on these scaffolds expressed CM-associated proteins and were pharmacologically responsive to adrenergic receptor agonists, a muscarinic agonist, and a gap junction uncoupler in a dose-dependent manner. Although hPSC-CMs grown on anisotropic fibrous scaffolds displayed the highest expression of genes encoding a number of sarcomere proteins, calcium handling proteins and ion channels, their calcium transient kinetics were slower than cells grown on TCPs. These results suggest that electrospun anisotropic fibrous scaffolds, as a single method, have limited effect on improving the maturation of hPSC-CMs.

Tissue factor activity and ECM-related gene expression in human aortic endothelial cells grown on electrospun biohybrid scaffolds.

All blood vessels are lined with a quiescent endothelium, which aids in regulating regular blood flow and avoiding thrombus formation. Current attempts at replacing diseased blood vessels frequently fail due to the intrinsic thrombogenicity of the materials used as vascular grafts. In extending our previous work where we introduced a new candidate scaffolds for vascular grafts electrospun from a blend solution of PLGA, gelatin, and elastin (PGE), this study aimed to evaluate the potential of PGE scaffolds to support nonthrombogenic monolayers of primary isolates of human aortic endothelial cells (HAECs), as assessed by a combination of biochemical, molecular, and bioinformatics-based analyses. After 24 h of culture on 3-D fibrous PGE scaffolds, HAECs formed a confluent, nonthrombogenic, and physiologically competent monolayer, as assessed by tissue factor (TF) gene expression and protein activity assays. The levels of TF mRNA/protein activity in HAECs grown on PGE scaffolds were similar to those on gelatin or collagen IV-coated 2-D surfaces. In addition, bioinformatics-based analysis of a focused microarray containing 84 ECM-related cDNA probes demonstrated that HAECs essentially expressed a histotypic ECM-related "transcriptome" on PGE scaffolds, where cells were more quiescent than cells cultured on 2-D coverslips coated with gelatin (a well-known "inert" substrate for conventional EC culture), but less so than on 2-D PGE films. These data suggest an important role for nanorough substrates (PGE films) in passivating endothelial cells and confirm the crucial effect of substrate composition in this process. Principal component analysis of microarray data on the above substrates (including collagen IV) implied that substrate composition plays a greater role than surface topography in affecting the endothelial ECM-related "transcriptome". Taken together, our findings suggest that electrospun PGE scaffolds are potentially suitable for application in small diameter vascular tissue engineering.

Electrospun rapamycin-eluting polyurethane fibers for vascular grafts.

PURPOSE: To develop rapamycin-eluting electrospun polyurethane (PU) vascular grafts that could effectively suppress local smooth muscle cell (SMC) proliferation. METHODS: Rapamycin (RM) was incorporated in PU fibers by blend electrospinning using three distinct blending methods. The drug release profiles and the bioavailability of RM-containing PU fibers in the form of fibrous mats and vascular grafts were evaluated up to 77 days in vitro. RESULTS: RM-contained PU fibers generated by the three distinct blending methods exhibited significantly different fiber diameters (200-500 nm) and distinct RM release kinetics. Young's moduli of the electrospun fibrous mats increased with higher RM contents and decreased with larger fiber diameters. For all blending methods, RM release kinetics was characteristic of a Fickian diffusion for at least 77 days in vitro. RM-PU fibers generated via powder blending showed the highest encapsulation efficiency. The RM in grafts made of these fibers remained bioactive and was still able to inhibit smooth muscle cell proliferation after 77 days of continual in vitro release. CONCLUSIONS: Electrospun RM-containing PU fibers can serve as effective drug carriers for the local suppression of SMC proliferation and could be used as RM-eluting scaffolds for vascular grafts.

Synthesis of citrate-stabilized hydrocolloids of hydroxyapatite through a novel two-stage method: a possible aggregates-breakdown mechanism of colloid formation.

Long-term stable (>2 years) hydrocolloids of hydroxyapatite (HA) were synthesized via a low-temperature (18-50 °C) reaction of aqueous ammonium phosphate with calcium nitrate in the presence of citrate ions, followed by an aging process at high temperature (80-99 °C) for 4 h. Changing the reaction and/or aging temperature seldom yielded stable HA hydrocolloids. The as-prepared hydrocolloids were desalinated through ultrafiltration where their average particle size gradually decreased, bottomed out at 100-400 µS/cm, and sharply increased in parallel with a decrease in solution conductivity. The colloid formation is most likely through a temperature-sensitive aggregates-breakdown process. During low-temperature reaction, citrate-calcium chelation bridges the growing HA particles into loose aggregates. High-temperature aging disrupts these inter-particle links and thus breaks the aggregates, imparting negative charges to the HA, forming colloidal particles stabilized by surface charge. The decrease in mean particle size during early ultrafiltration suggested that the aggregate breakdown further proceeded through desalination. In conclusion, the temperature-dependent interactions between citrate ions and calcium sites on HA particles played key roles in the synthesis and stability of the HA colloids.

Fluorescent PLLA-nanodiamond composites for bone tissue engineering.

Superior mechanical properties, rich surface chemistry, and good biocompatibility of diamond nanoparticles make them attractive in biomaterial applications. A multifunctional fluorescent composite bone scaffold material has been produced utilizing a biodegradable polymer, poly(l-lactic acid) (PLLA), and octadecylamine-functionalized nanodiamond (ND-ODA). The uniform dispersion of nanoparticles in the polymer led to significant increase in hardness and Young's modulus of the composites. Addition of 10%wt of ND-ODA resulted in more than 200% increase in Young's modulus and 800% increase in hardness, bringing the nanocomposite properties close to that of the human cortical bone. Testing of ND-ODA/PLLA as a matrix supporting murine osteoblast (7F2) cell growth for up to 1 week showed that the addition of ND-ODA had no negative effects on cell proliferation. ND-ODA serves as a multifunctional additive providing improved mechanical properties, bright fluorescence, and options for drug loading and delivery via surface modification. Thus ND-ODA/PLLA composites open up numerous avenues for their use as components of bone scaffolds and smart surgical tools such as fixation devices in musculoskeletal tissue engineering and regenerative medicine. Intense fluorescence of ND-ODA/PLLA scaffolds can be used to monitor bone re-growth replacing the implant in vivo.

Co-electrospun blends of PLGA, gelatin, and elastin as potential nonthrombogenic scaffolds for vascular tissue engineering.

In search for novel biomimetic scaffolds for application in vascular tissue engineering, we evaluated a series of fibrous scaffolds prepared by coelectrospinning tertiary blends of poly(lactide-co-glycolide) (PLGA), gelatin, and elastin (PGE). By systematically varying the ratios of PLGA and gelatin, we could fine-tune fiber size and swelling upon hydration as well as the mechanical properties of the scaffolds. Of all PGE blends tested, PGE321 (PLGA, gelatin, elastin v/v/v ratios of 3:2:1) produced the smallest fiber size (317 ± 46 nm, 446 ± 69 nm once hydrated) and exhibited the highest Young's modulus (770 ± 131 kPa) and tensile strength (130 ± 7 kPa). All PGE scaffolds supported the attachment and metabolization of human endothelial cells (ECs) and bovine aortic smooth muscle cells (SMCs) with some variances in EC morphology and cytoskeletal spreading observed at 48 h postseeding, whereas no morphologic differences were observed at confluence (day 8). The rate of metabolization of ECs, but not of SMCs, was lower than that on tissue culture plastic and depended on the specific PGE composition. Importantly, PGE scaffolds were capable of guiding the organotypic distribution of ECs and SMCs on and within the scaffolds, respectively. Moreover, the EC monolayer generated on the PGE scaffold surface was nonthrombogenic and functional, as assessed by the basal and cytokine-inducible levels of mRNA expression and amidolytic activity of tissue factor, a key player in the extrinsic clotting cascade. Taken together, our data indicate the potential application of PGE scaffolds in vascular tissue engineering.

Electroactive oligoaniline-containing self-assembled monolayers for tissue engineering applications.

A novel electroactive silsesquioxane precursor, N-(4-aminophenyl)-N'-(4'-(3-triethoxysilyl-propyl-ureido) phenyl-1,4-quinonenediimine) (ATQD), was successfully synthesized from the emeraldine form of amino-capped aniline trimers via a one-step coupling reaction and subsequent purification by column chromatography. The physicochemical properties of ATQD were characterized using mass spectrometry as well as by nuclear magnetic resonance and UV-vis spectroscopy. Analysis by cyclic voltammetry confirmed that the intrinsic electroactivity of ATQD was maintained upon protonic acid doping, exhibiting two distinct reversible oxidative states, similar to polyaniline. The aromatic amine terminals of self-assembled monolayers (SAMs) of ATQD on glass substrates were covalently modified with an adhesive oligopeptide, cyclic Arg-Gly-Asp (RGD) (ATQD-RGD). The mean height of the monolayer coating on the surfaces was approximately 3 nm, as measured by atomic force microscopy. The biocompatibility of the novel electroactive substrates was evaluated using PC12 pheochromocytoma cells, an established cell line of neural origin. The bioactive, derivatized electroactive scaffold material, ATQD-RGD, supported PC12 cell adhesion and proliferation, similar to control tissue-culture-treated polystyrene surfaces. Importantly, electroactive surfaces stimulated spontaneous neuritogenesis in PC12 cells, in the absence of neurotrophic growth factors, such as nerve growth factor (NGF). As expected, NGF significantly enhanced neurite extension on both control and electroactive surfaces. Taken together, our results suggest that the newly electroactive SAMs grafted with bioactive peptides, such as RGD, could be promising biomaterials for tissue engineering.