Virtual Monoenergetic Images (VMI+) in Dual-Source Dual-Energy CT Venography (DSDE-CTV) of the Lower Extremity Prior to Coronary Artery Bypass Graft (CABG): A Feasibility Study.

RATIONALE AND OBJECTIVES: To evaluate the image quality and suitability of Dual-Source Dual-Energy CT venography (DSDE-CTV) with asynchronous virtual monoenergetic images (VMI+) of the entire lower extremity in the context of pre-surgical assessment of complex cases prior to coronary bypass graft as a feasibility study. MATERIALS AND METHODS: Fifteen consecutive patients, consisting of 5 females and 10 males with an average age of 52 ± 17 years underwent DSDE-CTV from the pubic symphysis to the ankles after intravenous injection of an iodinated contrast medium. DSDE-CTV was acquired with tube voltages of 80 kVp and sn140 kVp. Single spectrum images (A - 80 kVp; B - 140 kVp) as well as a linearly blended mixed data set (M_0.6) were reconstructed. By postprocessing, an VMI+ dataset at 40 keV was generated. Objective image quality parameters of the deep and superficial veins of thigh, knee, and calves were measured separately for each location. Signal-to-noise ratio (SNR) and contrast-to-noise ratio (CNR) were calculated. Additionally, subjective image quality was assessed independently by two radiologists. RESULTS: Mean vascular attenuation was 73.9 ± 17.8 HU at B, 113.7 ± 42.2 HU at M_0.6, 119.4 ± 45.5 HU at A, and 201.0 ± 89.7 HU at VMI+. Mean CNR was 6.7 ± 2.0 at 140 keV, 9.25 ± 2.3 in the M_0.6 datasets, 8.7 ± 3.0 at 80 keV, and 12.9 ± 4.3 at 40 keV. Attenuation values were approximately doubled when compared to the reference standard (M_0.6) with significantly improved SNR and CNR (p < 0.05). Subjective image quality scores were highest for VMI+ datasets (4.1 ± 0.5) and lowest for B datasets (2.3 ± 0.37), however differences between VMI+ datasets and M_0.6 datasets did not reach statistical significance. CONCLUSION: Postprocessing of dual-energy CTV with VMI+ significantly increases attenuation of veins and markedly improves SNR and CNR values, thereby improving the diagnostic quality of CTV for the evaluation of deep and superficial veins of the entire lower limb prior to coronary bypass graft.

Leadless Cardiac Pacemaker (LCP) without Diagnostic Relevant Artifacts in DualSource and DualEnergy-CT Examinations in First- to Third-Generation DSCT Scanner.

RATIONALE AND OBJECTIVES: To identify the influence and artifact burden in cardiac CT imaging of a leadless cardiac pacemaker (LCP) performed with all three generations of DualSource CT (DSCT) Scanners. MATERIALS AND METHODS: The LCP was examined in DSCT scanners of the first to third generation using DualEnergy (DECT) and DSCT as well as alterations of the current-time product. For DECT examinations, virtual monoenergetic images were computed manually on a dedicated workstation. Virtual voltage was manually selected by subjective assessment of the lowest artifact burden. Systematic variations of the pacemaker angle to the gantry were assessed, too. The angle was successively increased by 10°, ranging from 0° to 90°. Artifact burden was quantified on a five-point Likert scale (1- no artifacts, 2- few artifacts, 3- moderate artifacts, 4- many artifacts, and 5- massive artifacts). Likert values of 1-3 were considered diagnostic and assessed by two board-certified radiologists in consensus. RESULTS: In total, 200 examinations were analyzed, a mean Likert value of 1.93 ± 0.61 was found overall. None of the images were assessed Likert value >3. The positioning evaluation showed a clear and significant reduction of artifact burden toward lower angles, (0°: 1.4 ± 0.5 vs. 90° 2.55 ± 0.51). At scanner level, second-generation DSCT performed significantly better (1.68 ± 0.47) than both other scanners. Comparison of technique (DECT vs. DSCT) revealed a significantly improved image quality in DSCT examinations. CONCLUSION: LCP can be safely examined in DSCT scanner of the first to third generation with the evaluated protocols and techniques, which are currently in use. Artifact burden can be significantly reduced by aligning or approaching the LCP's longitudinal axis toward the scanner's z-axis.