CE-based sample quality assessment prior to 2-D gel electrophoresis: towards the standardization of gel-based proteomics.

2-DE remains one of the most commonly used separation techniques for complex protein mixtures. This article describes a new approach to 2-DE sample assessment using SDS capillary gel electrophoresis (in Beckman Coulter sieving medium) combined with multi-pixel detection. The performance of this platform was investigated using protein samples prepared for 2-DE. The capability to characterize 2-DE sample was tested and the results show that the repeatability of peak migration time and intensity are better than 2% RSD. The system gives good resolution, accurate molecular mass assignment, as well as absolute and relative quantification of proteins. Notably, this study also demonstrates the use of this platform to screen the quality of simple and complex 2-DE samples. Implementation of this technique in the proteomics workflow will not only improve the success rate of 2-DE, but will also enable sample verification before 2-DE and allow the relative quantification of proteins. The validation of differential protein expression is also demonstrated using the combined information of relative molecular mass and relative quantification. It is the first time that a rapid and visual evaluation method is reported for the quality assessment of 2-DE samples.

CE of dsDNA in low-molecular-weight polyethylene oxide solutions.

To realise effective size separations of nucleic acid fragments using CE, gel-based matrices are commonly employed. The separation of label-free dsDNA ladders and plasmid fragments in an uncross-linked semi-dilute poly (ethylene) oxide solution using multi-pixel UV detection at 254 nm is reported. Improvements in the sensitivity of UV detection of dsDNA using signal averaging over multiple pixels is demonstrated. Separations performed using a diode array detector also allow the progress of the separation to be monitored as a function of time. Several polymers were examined including methyl cellulose, linear polyacrylamide, hydroxy (propyl) methylcellulose and polyethylene oxide. Operations parameters investigated included UV transparency, self-coating capacity and separation efficiency. The results show complete resolution of all fragments under a range of conditions, including short separation lengths.

Comparison of the effects of 2,2,2-trifluoroethanol on peptide and protein structure and function.

The co-solvent 2,2,2-trifluoroethanol (TFE) has been often used to aid formation of secondary structure in solution peptides or alternately as a denaturant within protein folding studies. Hen egg white lysozyme (HEWL) and a synthetic model peptide defining HEWL helix-4 were used as comparative model systems to systematically investigate the effect of increasing TFE concentrations on the structure of proteins and peptides. HEWL was analyzed using NMR, far-UV CD and fluorescence spectroscopy; with correlation of these results towards changes in enzymatic activity and the helix-4 peptide was analysed using NMR. Data illustrates two conflicting modes of interaction: Low TFE concentrations stabilize tertiary structure, observed from an increase in the number of NMR NOE contacts. Higher TFE concentrations denatured HEWL with the loss of lysozyme tertiary structure. The effects of TFE upon secondary structural elements within HEWL are distinct from those observed for the helix-4 peptide. This illustrates a dissimilar interaction of TFE towards both protein and peptide at equivalent TFE concentrations. The concentration that TFE promotes stabilization over denaturation is likely to be protein dependent although the structural action can be extrapolated to other protein systems with implications for the use of TFE in structural stability studies.