Characterizing Phase Transitions of Microfibrillated Cellulose Induced by Anionic and Cationic Surfactants.

Rheological modifiers are used to tune rheology or induce phase transitions of products. Microfibrillated cellulose (MFC), a renewable material, has the potential to be used for rheological modification. However, the lack of studies on the evolution in rheological properties and structure during its phase transitions has prevented MFC from being added to consumer, fabric, and home care products. In this work, we characterize surface-oxidized MFC (OMFC), a negatively charged colloidal rod suspension. We measure the rheological properties and structure of OMFC during sol-gel phase transitions induced by either anionic or cationic surfactant using multiple particle tracking microrheology (MPT). MPT tracks the Brownian motion of fluorescent probe particles embedded in a sample, which is related to the sample's rheological properties. Using MPT, we measure that OMFC gelation evolution is dependent on the charge of the surfactant that induces the phase transition. OMFC gelation is gradual in anionic surfactant. In cationic surfactant, gelation is rapid followed by length scale-dependent colloidal fiber rearrangement. Initial OMFC concentration is directly related to how tightly associated the network is at the phase transition, with an increase in concentration resulting in a more tightly associated network with smaller pores. Bulk rheology measures that OMFC forms a stiffer structure but yields at lower strains in cationic surfactant than in anionic surfactant. This study characterizes the role of surfactant in inducing phase transitions, which can be used as a guide for designing future products.

Properties of flame-retardant leaf fiber cement-based composites at high temperatures.

Flame retardant modification of leaf fibers was carried out to solve the technical problem of poor fire resistance of plant fibers and improve the utilization rate of urban fallen leaves in building materials. The modification scheme adopts three flame retardants, i.e., ammonium polyphosphate (APP), magnesium hydroxide (MH), and aluminum hydroxide (ATH), and two covering layers, i.e., pure acrylic polymer lotion and water glass (Na2O · nSiO2) solution. The modified leaf fiber's combustion behavior and pyrolysis properties were tested and analyzed. The physical and mechanical characteristics, as well as the thermal insulation qualities, of leaf fiber cement-based composites (LFCC) were studied at high temperatures. The findings revealed that the three flame retardants had an effect on the chemical structure of leaf fibers. In comparison to leaf fibers without flame-retardant modification, flame-retardant-modified leaf fibers have a much greater thermal stability. and its LOI is greater than 27.0%, which is a fire-retardant material. Except for the sample with water glass as the modified cover layer, at high temperatures, the composite flame-retardant fiber LFCC's mass-loss rate is lower compared with fibers without flame-retardant modification or fibers modified with only one kind of flame-retardant. In the composite flame-retardant modified fiber LFCC, the samples with better strength at high temperature are those with ATH replacing 30% and 50% MH. The thermal conductivity of LFCC is negatively correlated with the range of temperature change.

Gelation phase diagrams of colloidal rod systems measured over a large composition space.

Rheological modifiers tune product rheology with a small amount of material. To effectively use rheological modifiers, characterizing the rheology of the system at different compositions is crucial. Two colloidal rod system, hydrogenated castor oil and polyamide, are characterized in a formulation that includes a surfactant (linear alkylbenzene sulfonate) and a depletant (polyethylene oxide). We characterize both rod systems using multiple particle tracking microrheology (MPT) and bulk rheology and build phase diagrams over a large component composition space. In MPT, fluorescent particles are embedded in the sample and their Brownian motion is measured and related to rheological properties. From MPT, we determine that in both systems: (1) microstructure is not changed with increasing colloid concentration, (2) materials undergo a sol-gel transition as depletant concentration increases and (3) the microstructure changes but does not undergo a phase transition as surfactant concentration increases in the absence of depletant. When comparing MPT and bulk rheology results different trends are measured. Using bulk rheology we observe: (1) elasticity of both systems increase as colloid concentration increases and (2) the storage modulus does not change when PEO or LAS concentration is increased. The differences measured with MPT and bulk rheology are likely due to differences in sensitivity and measurement method. This work shows the utility of using both techniques together to fully characterize rheological properties over a large composition space. These gelation phase diagrams will provide a guide to determine the composition needed for desired rheological properties and eliminate trial-and-error experiments during product formulation.

[Effect of total flavonoids of Scutellaria baicalensis Georgi on expression of influenza A virus nucleoprotein in HeLa cells].

OBJECTIVE: To investigate the effect of total flavonoids of Scutellaria baicalensis Georgi (TFSB) on exogenous expression of influenza A virus nucleoprotein (NP) in HeLa cells. METHODS: HeLa cells were transiently transfected with the empty vector pcDNA3.1(+) or pcDNA3.1(+)/NP vector harboring influenza A virus NP. The pcDNA3.1(+)/NP-transfected cells were treated with TSFB and the expression of influenza A virus NP in the cell supernatant was measured using colloidal gold immunochromatography 48 h after the transfection; fluorescent quantitative RT-PCR was performed to measure the starting copy number of NP gene. RESULTS: The cells transfected with pcDNA3.1 (+)/NP with and without TFSB treatment were positive for NP expression. Fluorescent quantitative RT-PCR showed that the starting copy number of NP gene in pcDNA3.1(+)/NP-transfected cells was (8.90±2.53)×106 copies/µl, showing no significant difference from that of (6.15±1.49)×106 copies/µl in pcDNA3.1(+)/NP-transfected cells with subsequent TFSB treatment (P>0.05). CONCLUSION: TFSB treatment does not obviously affect exogenous influenza A virus NP gene expression or its protein synthesis in HeLa cells.

The influenza virus gene pool in a poultry market in South central china.

We surveyed influenza activity in a live poultry market in Central China for 16 months, isolating viruses from 1% of 6360 fecal samples. We obtained multiple H3N6, H9N2, H2N9, H3N3, and H4N6 isolates and single H1N1 and H3N2 isolates. Two distinct H3 molecules were identified; other hemagglutinin subtypes were phylogenetically homogeneous. The H3N6 viruses (9 genotypes) and H9N2 viruses (4 genotypes) were genetically heterogeneous, whereas the H2N9, H3N3 and H4N6 viruses had single genotypes. Thirteen representative viruses were tested for their ability to replicate in quail and chickens. All tested viruses replicated in the respiratory tract of quail. Only nine of the viruses were shed in detectable levels in infected chickens, and four of these were detected in less than 50% of infected birds. A single H4N6 isolate caused disease and systemic spread in chickens. These findings show that quail are broadly susceptible to different subtypes of influenza A virus.