On-Line Monitoring of Radiocarbon Emissions in a Nuclear Facility with Cavity Ring-Down Spectroscopy.

There are currently no suitable methods for sensitive automated in situ monitoring of gaseous radiocarbon, one of the main sources of radioactive gas emissions from nuclear power plants. Here, we present a transportable instrument for in situ airborne radiocarbon detection based on mid-infrared cavity ring-down spectroscopy and report its performance in a 1-week field measurement at the Loviisa nuclear power plant. Radiocarbon is detected by measuring an absorption line of the 14CO2 molecule. The time resolution of the measurements is 45 min, significantly less than the few days' resolution of the currently used technique, while maintaining a comparable sensitivity. The method can also assess the prevalence of radiocarbon in different molecular species in the airborne emissions. The optical in situ monitoring presented is a completely new method for monitoring emissions from nuclear facilities.

Emissions from a fast-pyrolysis bio-oil fired boiler: Comparison of health-related characteristics of emissions from bio-oil, fossil oil and wood.

There is currently great interest in replacing fossil-oil with renewable fuels in energy production. Fast pyrolysis bio-oil (FPBO) made of lignocellulosic biomass is one such alternative to replace fossil oil, such as heavy fuel oil (HFO), in energy boilers. However, it is not known how this fuel change will alter the quantity and quality of emissions affecting human health. In this work, particulate emissions from a real-scale commercially operated FPBO boiler plant are characterized, including extensive physico-chemical and toxicological analyses. These are then compared to emission characteristics of heavy fuel-oil and wood fired boilers. Finally, the effects of the fuel choice on the emissions, their potential health effects and the requirements for flue gas cleaning in small-to medium-sized boiler units are discussed. The total suspended particulate matter and fine particulate matter (PM1) concentrations in FPBO boiler flue gases before filtration were higher than in HFO boilers and lower or on a level similar to wood-fired grate boilers. FPBO particles consisted mainly of ash species and contained less polycyclic aromatic hydrocarbons (PAH) and heavy metals than had previously been measured from HFO combustion. This feature was clearly reflected in the toxicological properties of FPBO particle emissions, which showed less acute toxicity effects on the cell line than HFO combustion particles. The electrostatic precipitator used in the boiler plant efficiently removed flue gas particles of all sizes. Only minor differences in the toxicological properties of particles upstream and downstream of the electrostatic precipitator were observed, when the same particulate mass from both situations was given to the cells.

Electrostatic precipitator performance and trace element emissions from two Kraft recovery boilers.

Fine particle emissions from combustion sources have gained attention recently due to their adverse effects on human health. The emission depends on the combustion process, fuel, and particulate removal technology. Particle concentrations at Kraft recovery boiler exits are very high, and the boilers are typically equipped with electrostatic precipitators (ESP). However, little data are available on the ESP performance in recovery boilers. Particle concentrations and size distributions were determined at two modern, operating recovery boilers. In addition, we determined the fractional collection efficiency of the ESPs by simultaneous measurements at the ESP inlet and outlet and the particulate emissions of trace metals. The particle mass concentration atthe ESP inlet was 11-24 g/Nm3 at the two boilers. Particle emissions were 30-40 mg/ Nm3 at boiler A and 12-15 mg/Nm3 at boiler B. The particle size distributions had a major particle mode at around 1 microm. These fume particles contained most of the particle mass. The main components in the particles were sodium and sulfate with minor amounts of chloride, potassium, and presumably some carbonate. The ESP collection efficiency was 99.6-99.8% at boiler A and 99.9% at boiler B. The particle penetration through the ESP was below 0.6% in the entire fume particle size range of 0.3-3 microm. Trace element emissions from both boilers were well below the limit values set by EU directive for waste incineration.

Electrostatic precipitator collection efficiency and trace element emissions from co-combustion of biomass and recovered fuel in fluidized-bed combustion.

Particle and trace element emissions from energy production have continuously been subject to tightening regulations. At the same time, not enough is known on the effect of different combustion processes and different fuels and fuel mixtures on the particle characteristics and particle removal device operation. In this investigation, electrostatic precipitator fractional collection efficiency and trace metal emissions were determined experimentally at a 66 MW biomass-fueled bubbling fluidized-bed combustion plant. The measurements were carried out at the inlet and outlet of the two-field electrostatic precipitator (ESP) at the flue gas temperature of 130-150 degrees C. Two fuel mixtures were investigated: biomass fuel containing 70% wood residue and 30% peat and biomass with recovered fuel containing 70% wood residue, 18% peat, and 12% recovered fuel. The particle mass concentration at the ESP inlet was 510-1400 mg/Nm3. Particle emission at the ESP outlet was 2.3-6.4 mg/Nm3. Total ESP collection efficiency was 99.2-99.8%. Collection efficiency had a minimum in particle size range of 0.1-2 microm. In this size range, collection efficiency was 96-97%. The emission of the trace metals As, Cd, Co, Cr, Cu, Mn, Ni, Pb, Sb, Tl, and V was well below the regulation values set by EU directive for waste incineration and co-incineration.