RESUMEN
The era of flexible optoelectronics demands development of wearable and bendable structures, foldable touch screens, paper-like displays, and curved and flexible solid-state lighting devices. Here, we demonstrate the fabrication of highly flexible light valves using polymer-dispersed liquid crystal (PDLC) and TiO2/Ag/TiO2 transparent conductive films. TiO2/Ag/TiO2 multilayers were prepared by magnetron sputtering technique on polyethylene terephthalate (PET) substrates at room temperature. By keeping the equivalent TiO2 layers and varying the deposition time of the Ag layer, proper metal nanograins on TiO2 planar plane were formed, providing the best tradeoff between the transmittance, sheet resistance and bending ability. The results are validated by numerical simulations that suggest the best match between the deposition time and individual layer thickness. Based on the performed characteristics of TiO2/Ag/TiO2/PET structures, several flexible light valves are fabricated and characterized. The sheet resistance values of TiO2/Ag/TiO2/PET remain unchanged over 1000 bending cycles. The measured driving voltage and response time values open great potential of TiO2/Ag/TiO2/PET for integration into next-generation ITO-free flexible and stretchable devices.
RESUMEN
We propose a prism-hologram-prism sandwiched recording method for the fabrication of polarization-selective substrate-mode volume holograms with a large diffraction angle. In fabrication, the C-RT20 photopolymer is sandwiched between two 45°-90°-45° prisms and the interference fringes can be easily recorded in the recording material. The experimental results are in good agreement with the theoretical predictions. The proposed method features of a reflection-type recording setup for a transmission element and belongs to a technique of longer-wavelength construction for shorter-wavelength reconstruction. In addition, the method is much easier than the traditional recording method of two incident beam interference and has application potential in holographic photonics.
RESUMEN
In this study, a novel moiré fringe analysis technique is proposed for measuring the surface profile of an object. After applying a relative displacement between two gratings at a constant velocity, every pixel of CMOS camera can capture a heterodyne moiré signal. The precise phase distribution of the moiré fringes can be extracted using a one-dimensional fast Fourier transform (FFT) analysis on every pixel, simultaneously filtering the harmonic noise of the moiré fringes. Finally, the surface profile of the tested objected can be generated by substituting the phase distribution into the relevant equation. The findings demonstrate the feasibility of this measuring method, and the measurement error was approximately 4.3 µm. The proposed method exhibits the merits of the Talbot effect, projection moiré method, FFT analysis, and heterodyne interferometry.