RESUMEN
The rising global population and rapid industrialization have frequently resulted in a significant escalation in energy requirements. Hydrogen, renowned for its eco-friendly and renewable characteristics, has garnered substantial interest as a fuel alternative to address the energy needs currently fulfilled by fossil fuels. Embracing such energy substitutes holds pivotal importance in advancing environmental sustainability, aiding in the reduction of greenhouse gas emissions - the primary catalysts of global warming and climate fluctuations. This study elucidates recent trends in sewage sludge (SS)-derived hydrogen through diverse production pathways and critically evaluates the impact of varying parameters on hydrogen yield. Furthermore, a detailed analysis of the breakdown of the hydrogen generation process from SS is provided, along with an assessment of its economic dimensions. The review culminates by illuminating key obstacles in the adoption of this innovative technology, accompanied by practical recommendations to surmount these challenges. This comprehensive analysis is expected to attract considerable interest from stakeholders within the hydrogen production domain, fostering substantial engagement.
RESUMEN
Sulfate (SO42-) is a major water and environmental concern that causes severe diarrhea, death of invertebrates and plant species, and clogging of industrial pipes. In the current work, treatment of SO42- from synthetic and real groundwater having 3901 mg(SO42-)/L was investigated for the first time using Zn-Al and Mg-Al layered double oxides doped granular activated carbon (GAC/Mg-Al LDO and GAC/Zn-Al LDO). The co-precipitation method was followed to synthesize the GAC/LDO composites using an Mg or Zn to Al molar ratio of 3:1. The GAC/Mg-Al LDO possessed a higher specific surface area (323.9 m2/g) compared to GAC/Zn-Al LDO (195.1 m2/g). The GAC/Mg-Al LDO demonstrated more than 99% removal of SO42- from synthetic water, while it was 50.9% for GAC/Zn-Al LDO and less than 1% for raw GAC at an initial concentration of 50 mg/L. The GAC/Mg-Al LDO was selected for further batch experiments and modeling investigation. The equilibrium data followed the Redlich-Peterson and Langmuir models with determination coefficients of 0.943 and 0.935, respectively. The maximum Langmuir adsorption capacity was 143.5 mg/g. In the real groundwater adsorption study, the screening experiment revealed high selectivity towards SO42- with 62% removal efficiency. The optimum dosage was found to be 50 g/L with an uptake capacity of 61.5 mg/g. The kinetic data of SO42- removal from synthetic and brackish water were in excellent agreement with the pseudo-second order model, and the equilibrium was attained in 5 h. Accordingly, it can be concluded that the GAC/Mg-Al LDO is an efficient material for treating SO42- from real groundwater and can be utilized as a pretreatment unit for high sulfate water resources.
Asunto(s)
Agua Subterránea , Contaminantes Químicos del Agua , Purificación del Agua , Óxidos , Carbón Orgánico , Sulfatos , Agua , Óxidos de Azufre , Adsorción , Cinética , Purificación del Agua/métodosRESUMEN
Biohydrogen is considered a green fuel due to its eco-friendly nature since it only produces water and energy on combustion. However, their lower yield and production rate is one of the foremost challenges that need an instant sustainable approach. The use of nanotechnology is a potential approach for the enhanced generation of biohydrogen, owing to the significant characteristics of the nanomaterials such as greater specificity, high surface-area-to-volume ratio, better reactivity and dispersibility, enhanced catalytic activity, superb selectivity, greater electron transfer, and better anaerobic microbiota activity. This article explores the recent trends and innovations in the production of biohydrogen from wastewater through the applications of different nanomaterials. The potential of various nanomaterials employed for biohydrogen production from wastewater is evaluated and the impacts of important parameters such as the concentration and size of the nanomaterials, temperature, and pH on the production and yield of biohydrogen are explained in detail. Several pathways involved in the mechanistic approach of biohydrogen generation from wastewater are critically assessed. Lastly, numerous technological challenges are highlighted and recommendations regarding future research are also provided.
RESUMEN
Trace organic compounds from effluent streams are not completely removed by conventional purification techniques and hence, contaminating groundwater sources. Herein, we report the removal efficiency and rejection mechanisms of three common pharmaceutically active compounds (PhACs); caffeine (CFN), omeprazole (OMZ), and sulfamethoxazole (SMX), using commercial nanofiltration (NF) and reverse osmosis (RO) membranes with different surface characteristics. The RO membranes showed near-complete removal of all PhACs with rejection rates >99%. On the other hand, retention capabilities for the NF membranes varied and were influenced by the characteristics of the PhACs, membranes, and the feed solution. In general, during long-term testing, the rejection did not show much variation and followed a trend compatible with the size exclusion (steric hindrance) mechanism. When a real matrix was used, the rejection of CFN by the more tight NF membranes, HL TFC and NFW decreased by â¼10%, whereas the removal of SMX by the loose NF membrane, XN45, increased by the same ratio. In short-term testing, the rejection of negatively charged SMX increased significantly (â¼20-40%) at a higher pH of â¼8 and in the presence of salts. Fouling by the PhACs was more severe on the high-flux NF membranes, HL TFC and XN45, as witnessed by the significant change in Contact angle (CA) values (â¼25-50°) as well as the flux decline (â¼15%) during long-term testing. To summarize, the removal of PhACs by membranes is a complex phenomenon and depends upon a combination of several factors.
Asunto(s)
Purificación del Agua , Agua , Purificación del Agua/métodos , Ósmosis , Membranas Artificiales , Filtración/métodosRESUMEN
Efficient management of solid waste is essential to lessen its potential health and environmental impacts. However, the current solid waste management practices encounter several challenges. The development of effective waste management systems using advanced technologies is vital to overcome the challenges faced by the current approaches. Artificial Intelligence (AI) has emerged as a powerful tool for applications in various fields. Several studies also reported the applications of AI techniques in the management of solid waste. This article critically reviews the recent advancements in the applications of AI techniques for the management of solid waste. Various AI and hybrid techniques have been successfully employed to predict the performance of various methods used for the generation, segregation, storage, and treatment of solid waste. The key challenges that limit the applications of AI in solid waste are highlighted. These include the availability and selection of applicable data, poor reproducibility, and less evidence of applications in real solid waste. Based on identified gaps and challenges, recommendations for future work are provided. This review is beneficial for all stakeholders in the field of solid waste management, including policy-makers, governments, waste management organizations, municipalities, and researchers.
Asunto(s)
Inteligencia Artificial , Administración de Residuos , Residuos Sólidos/análisis , Reproducibilidad de los Resultados , PredicciónRESUMEN
The purpose of the present study was to find out the sources of mercury and arsenic pollution of water in the industrial area of Peshawar, the capital of Khyber Pakhtunkhwa, Pakistan. Samples of effluents, mud, and water were collected from the target area (industrial area of Peshawar), the area of water supply source, and from the less polluted area, the Lower Dir district, as the control. Hg was determined by the cold vapor generation technique, while arsenic was determined using the electrothermal atomic absorption technique. Data of the water from the industrial area were compared with that of the source area, control area, as well as with the WHO and some international drinking water quality standards. The results show that some parameters, i.e., TDS, DO, pH, and hardness, were more than the permissible limits. Textile and glass industries were found to be the major sources of Hg and As pollution. Downstream dilution of these contaminants was also observed.
Asunto(s)
Arsénico/análisis , Mercurio/análisis , Contaminantes Químicos del Agua/análisis , Calidad del Agua/normas , Abastecimiento de Agua/estadística & datos numéricos , Monitoreo del Ambiente , Industrias/estadística & datos numéricos , Pakistán , Contaminación Química del AguaRESUMEN
Food crops irrigated with wastewater are mostly contaminated with heavy metals and considered as a main pathway for human exposure. In this study, soil and food crops samples were collected from wastewater irrigated soils, background and relatively less polluted areas. Results of the sequential extraction and total metals concentrations in soils indicated that wastewater irrigation has significantly increased (p > or = 0.001) the bioavailable and total metal contents in wastewater irrigated soil as compared to background and control soils. Heavy metal concentrations in the food crops grown on wastewater irrigated soil were higher than those grown on background and control soils but were found within WHO/FAO permissible limits except for Zn. Health risk index values were less than 1 for both control and wastewater irrigated soils (except Mn). However, the food crops such as Brassica rapa, Spinacia oleracae L., Lycopersicum esculantum, Mentha viridis, Coriandum sativum and Lactuca sativa grown on wastewater irrigated soil can pose health risks because of the high concentration of Mn.
Asunto(s)
Agricultura , Productos Agrícolas/química , Eliminación de Residuos Líquidos , Abastecimiento de Agua/análisis , Adulto , Niño , Análisis por Conglomerados , Productos Agrícolas/efectos adversos , Interpretación Estadística de Datos , Humanos , Indicadores y Reactivos , Residuos Industriales , Manganeso/efectos adversos , Manganeso/análisis , Metales Pesados/efectos adversos , Metales Pesados/análisis , Pakistán , Medición de Riesgo , Seguridad , Suelo/análisis , Verduras/química , Contaminantes Químicos del Agua/efectos adversos , Contaminantes Químicos del Agua/análisisRESUMEN
Multivariate and univariate statistical techniques i.e., cluster analysis PCA, regression and correlation analysis, one way ANOVA, were applied to the metal data of effluents soil and ground water to point out the contribution of different industries towards the metals pollution, their source identification and distribution. The samples were collected from different industries and different downstream points of the main effluents stream and from the relatively less polluted area considered as control area. The samples were analyzed for metal concentration levels by flame atomic absorption spectrophotometer. The metal concentration data in the three media of the polluted area were compared with background data and control data as well as with the WHO safe limits. The results showed that soil has high metals concentration compared to effluents and water. The data also showed elevated levels of Mn and Pb in water that are 8.268 and 2.971 mg/L, respectively. Principal component analysis along with regression analysis showed that the elevated levels of metals in the effluents contaminate adjacent soil and ultimately the ground water. The other elements Co, Cd, Ni and Cu were also found to have correlation in the three media.