RESUMEN
The structural evolution of black arsenic-phosphorous (b-AsxP1-x) alloys with varying arsenic concentrations was investigated under hydrostatic pressure usingin situRaman spectroscopy. High-pressure experiments were conducted using a diamond anvil cell, which revealed pressure-induced shifts in vibrational modes associated with P-P bonds (A1g,A2g,B2g), As-As bonds (A1g,A2g,B2g), and As-P bonds in b-AsxP1-xalloys. Two distinct pressure regimes were observed. In the first regime (region I), all vibrational modes exhibited a monotonic upshift, indicating phonon hardening due to hydrostatic pressure. In the second regime (region II), As0.4P0.6and As0.6P0.4alloys displayed a linear blueshift (or negligible change in some modes) at a reduced rate, suggesting local structural reorganization with less compression on the bonds. Notably, the alloy with the highest As concentration, As0.8P0.2, exhibited anomalous behavior in the second pressure regime, with a downward shift observed in all As-As and As-P Raman modes (and some P-P modes). Interestingly, the emergence of new peaks corresponding to theEgmode andA1gmode of the gray-As phase was observed in this pressure range, indicating compressive strain-induced structural changes. The anomalous change in region II confirms the formation of a new local structure, characterized by elongation of the P-P, As-As, and As-P bonds along the zigzag direction within the b-AsxP1-xphase, possibly near the grain boundary. Additionally, a gray-As phase undergoes compressive structural changes. This study underscores the significance of pressure in inducing structural transformations and exploring novel phases in two-dimensional materials, including b-AsxP1-xalloys.
RESUMEN
In this study, we report the development of an electrically active solid-liquid interface for the evanescent-wave cavity-ring-down spectroscopic (EW-CRDS) technique to enable spectroelectrochemical investigations of redox events. Because of a high-quality transparent conductive electrode film of indium tin oxide (ITO) coated on the interface of total internal reflection of the EW-CRDS platform, a cavity ring-down time of about 900 ns was obtained allowing spectroelectrochemical studies at solid-liquid interfaces. As a proof-of-concept on the capabilities of the developed platform, measurements were performed to address the effects of an applied electric potential to the adsorption behavior of the redox protein cytochrome c (Cyt-C) onto different interfaces, namely, bare-ITO, 3-aminopropyl triethoxysilane (APTES), and Cyt-C antibody. For each interface, the adsorption and desorption constants, the surface equilibrium constant, the Gibbs free energy of adsorption, and the surface coverage were optically measured by our electrically active EW-CRDS tool. Optical measurements at a set of constant discrete values of the applied electric potential were acquired for kinetic adsorption analysis. Cyclic voltammetry (CV) scans under synchronous optical readout were performed to study the effects of each molecular interface on the redox process of surface-adsorbed protein species. Overall, the experimental results demonstrate the ability of the electro-active EW-CRDS platform to unambiguously measure electrode-driven redox events of surface-confined molecular species at low submonolayer coverages and at a single diffraction-limited spot. Such capability is expected to open several opportunities for the EW-CRDS technique to investigate a variety of electrochemical phenomena at solid-liquid interfaces.