Gas-to-Particle Partitioning of Products from Ozonolysis of Δ3-Carene and the Effect of Temperature and Relative Humidity.

Formation of oxidized products from Δ3-carene (C10H16) ozonolysis and their gas-to-particle partitioning at three temperatures (0, 10, and 20 °C) under dry conditions (<2% RH) and also at 10 °C under humid (78% RH) conditions were studied using a time-of-flight chemical ionization mass spectrometer (ToF-CIMS) combined with a filter inlet for gases and aerosols (FIGAERO). The Δ3-carene ozonolysis products detected by the FIGAERO-ToF-CIMS were dominated by semivolatile organic compounds (SVOCs). The main effect of increasing temperature or RH on the product distribution was an increase in fragmentation of monomer compounds (from C10 to C7 compounds), potentially via alkoxy scission losing a C3 group. The equilibrium partitioning coefficient estimated according to equilibrium partitioning theory shows that the measured SVOC products distribute more into the SOA phase as the temperature decreases from 20 to 10 and 0 °C and for most products as the RH increases from <2 to 78%. The temperature dependency of the saturation vapor pressure (above an assumed liquid state), derived from the partitioning method, also allows for a direct way to obtain enthalpy of vaporization for the detected species without accessibility of authentic standards of the pure substances. This method can provide physical properties, beneficial for, e.g., atmospheric modeling, of complex multifunctional oxidation products.

Ozonolysis of α-Pinene and Δ3-Carene Mixtures: Formation of Dimers with Two Precursors.

The formation of secondary organic aerosol (SOA) from the structurally similar monoterpenes, α-pinene and Δ3-carene, differs substantially. The aerosol phase is already complex for a single precursor, and when mixtures are oxidized, products, e.g., dimers, may form between different volatile organic compounds (VOCs). This work investigates whether differences in SOA formation and properties from the oxidation of individual monoterpenes persist when a mixture of the monoterpenes is oxidized. Ozonolysis of α-pinene, Δ3-carene, and a 1:1 mixture of them was performed in the Aarhus University Research on Aerosol (AURA) atmospheric simulation chamber. Here, ∼100 ppb of monoterpene was oxidized by 200 ppb O3 under dark conditions at 20 °C. The particle number concentration and particle mass concentration for ozonolysis of α-pinene exceed those from ozonolysis of Δ3-carene alone, while their mixture results in concentrations similar to α-pinene ozonolysis. Detailed offline analysis reveals evidence of VOC-cross-product dimers in SOA from ozonolysis of the monoterpene mixture: a VOC-cross-product dimer likely composed of the monomeric units cis-caric acid and 10-hydroxy-pinonic acid and a VOC-cross-product dimer ester likely from the monomeric units caronaldehyde and terpenylic acid were tentatively identified by liquid chromatography-mass spectrometry. To improve the understanding of chemical mechanisms determining SOA, it is relevant to identify VOC-cross-products.

Reconciling atmospheric water uptake by hydrate forming salts.

Magnesium and calcium chloride salts contribute to the global atmospheric aerosol burden via emission of sea spray and mineral dust. Their influence on aerosol hygroscopicity and cloud forming potential is important but uncertain with ambiguities between results reported in the literature. To address this, we have conducted measurements of the hygroscopic growth and critical supersaturation of dried, size selected nano-particles made from aqueous solution droplets of MgCl2 and CaCl2, respectively, and compare experimentally derived values with results from state-of-the-art thermodynamic modelling. It is characteristic of both MgCl2 and CaCl2 salts that they bind water in the form of hydrates under a range of ambient conditions. We discuss how hydrate formation affects the particles' water uptake and provide an expression for hydrate correction factors needed in calculations of hygroscopic growth factors, critical super-saturations, and derived κ values of particles containing hydrate forming salts. We demonstrate the importance of accounting for hydrate forming salts when predicting hygroscopic properties of sea spray aerosol.