RESUMEN
Mechanical energy harvesting using piezoelectric nanogenerators (PNGs) offers an attractive solution for driving low-power portable devices and self-powered electronic systems. Here, we designed an eco-friendly and flexible piezocomposite nanogenerator (c-PNG) based on H2(Zr0.1Ti0.9)3O7 nanowires (HZTO-nw) and Ba0.85Ca0.15Zr0.10Ti0.90O3 multipods (BCZT-mp) as fillers and polylactic acid (PLA) as a biodegradable polymer matrix. The effects of the applied stress amplitude, frequency and pressing duration on the electric outputs in the piezocomposite nanogenerator (c-PNG) device were investigated by simultaneous recording of the mechanical input and the electrical outputs. The fabricated c-PNG shows a maximum output voltage, current and volumetric power density of 11.5 V, 0.6 µA and 9.2 mW cm-3, respectively, under cyclic finger imparting. A high-pressure sensitivity of 0.86 V kPa-1 (equivalent to 3.6 V N-1) and fast response time of 45 ms were obtained in the dynamic pressure sensing. Besides this, the c-PNG demonstrates high-stability and durability of the electrical outputs for around three months, and can drive commercial electronics (charging capacitor, glowing light-emitting diodes and powering a calculator). Multi-physics simulations indicate that the presence of BCZT-mp is crucial in enhancing the piezoelectric response of the c-PNG. Accordingly, this work reveals that combining 1D and 3D fillers in a polymer composite-based PNG could be beneficial in improving the mechanical energy harvesting performances in flexible piezoelectric nanogenerators for application in electronic skin and wearable devices.
RESUMEN
P2-type NaMO2 sodiated layered oxides with mixed transition metals are receiving considerable attention for use as cathodes in sodium-ion batteries. A study on solid solution (1 - y)P2-NaxCoO2-(y)P2-NaxMn2/3Ni1/3O2 (y = 0, 1/3, 1/2, 2/3, 1) reveals that changing the composition of the transition metals affects the resulting structure and the stability of pure P2 phases at various temperatures of calcination. For 0 ≤ y ≤ 1.0, the P2-NaxCo(1-y)Mn2y/3Niy/3O2 solid-solution compounds deliver good electrochemical performance when cycled between 2.0 and 4.2 V versus Na+/Na with improved capacity stability in long-term cycling, especially for electrode materials with lower Co content (y = 1/2 and 2/3), despite lower discharge capacities being observed. The (1/2)P2-NaxCoO2-(1/2)P2-NaxMn2/3Ni1/3O2 composition delivers a discharge capacity of 101.04 mAh g-1 with a capacity loss of only 3% after 100 cycles and a Coulombic efficiency exceeding 99.2%. Cycling this material to a higher cutoff voltage of 4.5 V versus Na+/Na increases the specific discharge capacity to ≈140 mAh g-1 due to the appearance of a well-defined high-voltage plateau, but after only 20 cycles, capacity retention declines to 88% and Coulombic efficiency drops to around 97%. In situ X-ray absorption near-edge structure measurements conducted on composition NaxCo1/2Mn1/3Ni1/6O2 (y = 1/2) in the two potential windows studied help elucidate the operating potential of each transition metal redox couple. It also reveals that at the high-voltage plateau, all of the transition metals are stable, raising the suspicion of possible contribution of oxygen ions in the high-voltage plateau.