RESUMEN
The effect of addition of Si and variation of the Fe/Co ratio on the evolution of the nanostructure was studied in a modification of the Fe-Nb-B system. The entire system (Fe, Co)(73)Nb(7)(Si, B)(20) was prepared in an amorphous state by rapid quenching using the planar flow casting method over a wide range of Fe/Co atomic ratios, ranging from 0 to 1. Nanocrystallization was investigated by evolution of the electrical resistivity with time and temperature. The microstructural analysis was performed using transmission electron microscopy as well as electron and X-ray diffraction. The results from microscopy observations were used to determine the distribution of grain size, which in these alloys attain very small dimensions of approximately 5-8 nm. New algorithms of microscope image analysis were used for grain size determination, crucial for quantifying the microprocesses controlling nucleation and growth from the amorphous rapidly quenched phase.
RESUMEN
The effect of the substitution of Fe by Co on the enhancement of glass-forming ability limits and subsequent nanocrystallization was studied in a rapidly quenched amorphous system (Fe(x)Co(y))(79)Mo(8)Cu(1)B(12) for y/x ranging from 0 to 1. The effect of Cu on nanocrystallization was investigated by comparison with Cu-free amorphous Fe(80)Mo(8)B(12). Systems partially crystallized at the surface layer were prepared for y/x = 0 using different quenching conditions. The effect of heat treatment of master alloys used for ribbon casting was also assessed. The microstructure and surface/bulk crystallization effects were analysed using transmission electron microscopy and electron and X-ray diffraction in relation to the expected enhancement of high-temperature soft magnetic properties, drastically reduced grain sizes (approximately 5 nm) and Co content. Unusual surface phenomena were observed, indicating the origin of possible nucleation sites for preferential crystallization in samples with low Co content.
