A survey of total hydrocyanic acid content in ready-to-eat cassava-based chips obtained in the Australian market in 2008.

Cassava (Manihot esculenta Crantz) is a widely consumed food in the tropics that naturally contains cyanogenic glycosides (cyanogens, mainly composed of linamarin, acetone cyanohydrin, and hydrocyanic acid). If cassava is not adequately processed to reduce the level of cyanogens prior to consumption, these compounds can lead to the formation of hydrocyanic acid in the gut. Exposure to hydrocyanic acid can cause symptoms ranging from vomiting and abdominal pain to coma and death. In 2008, a survey of ready-to-eat (RTE) cassava-based snack foods was undertaken to determine levels of cyanogens measured as total hydrocyanic acid. This survey was undertaken in response to the New South Wales Food Authority being alerted to the detection of elevated levels of cyanogens in an RTE cassava-based snack food. This survey took 374 samples of RTE cassava chips available in the Australian marketplace. Significant variation in the levels of total hydrocyanic acid were observed in the 317 samples testing positive for cyanogens, with levels ranging from 13 to 165 mg of HCN equivalents per kg (mean value, 64.2 mg of HCN eq/kg for positive samples). The results from this survey serve as a timely warning for manufacturers of RTE cassava chips and other cassava-based snack foods to ensure there is tight control over the levels of cyanogens in the cassava ingredient. Evidence from this survey contributed to an amendment to the Australia New Zealand Food Standards Code, which now prescribes a maximum level for hydrocyanic acid in RTE cassava chips of 10 mg of HCN eq/kg, which aligns with the Codex Alimentarius Commission international standard for edible cassava flour.

Microbiology of wheat and flour milling in Australia.

A survey was undertaken to determine the microbiological status of Australian wheat and the distribution of microorganisms in the flour milling fractions and end products. A total of 650 milling process and end product samples was obtained from nine flour mills located in New South Wales (4), Queensland (2), Victoria (2) and Western Australia (1) during the 1997-1998 and 1998-1999 wheat seasons. Most frequent (modal) counts in wheat and flour were, respectively, as follows: aerobic mesophilic plate count, 10(5) and 10(2) colony forming units/gram (cfu/g); coliforms, 10 and 1 most probable number/gram (MPN/g); Bacillus spp., 10(4) and 10(2) cfu/g; B. cereus, 1 and 0.1 MPN/g; mesophilic aerobic spores, 10 and 1 cfu/g; aerobic thermophiles, both 10 cfu/g; yeasts, 10(3) and 10(2) cfu/g, and moulds, 10(3) and 10(2) cfu/g. Bacillus spp., coliforms, yeasts and moulds were the most frequently detected microorganisms throughout the survey. The most common moulds isolated were Aspergillus, Penicillium, Cladosporium and Eurotium spp. Environmental serovars of Salmonella were isolated from two samples. Escherichia coli and B. cereus were present at very low levels, a majority of positive samples being at the minimum level of detection (3 and 0.3 MPN/g, respectively). As wheat grain layers are separated, surface-adhering contaminants are concentrated in end product bran, wheat germ and pollard, which comprise the outer layers of the grain. Consequently, the inner endosperm fraction contains lower microbial counts, and flour is the cleanest end product of the milling process. Higher microbiological counts midstream in the milling process indicate that equipment contamination may contribute to microbiological contamination; however, the microbiological quality of incoming wheat has a strong influence on the ultimate quality of milling end products.