RESUMEN
Laser cutting of carbon fibre-reinforced plastics (CFRP) is a promising alternative to traditional manufacturing methods due to its non-contact nature and high automation potential. To establish the process for an industrial application, it is necessary to predict the temperature fields arising as a result of the laser energy input. Elevated temperatures during the cutting process can lead to damage in the composite's matrix material, resulting in local changes in the structural properties and reduced material strength. To address this, a three-dimensional finite element model is developed to predict the temporal and spatial temperature evolution during laser cutting. Experimental values are compared with simulated temperatures, and the cutting kerf geometry is examined. Experiments are conducted at 45° and 90° cutting angles relative to the main fibre orientation using a 1.1 mm thick epoxy-based laminate. The simulation accurately captures the overall temperature field expansion caused by multiple laser beam passes over the workpiece. The influence of fibre orientation is evident, with deviations in specific temperature data indicating differences between the estimated and real material properties. The model tends to overestimate the ablation rate in the kerf geometry, attributed to mesh resolution limitations. Within the parameters investigated, hardly any expansion of a heat affected zone (HAZ) is visible, which is confirmed by the simulation results.
RESUMEN
We demonstrate and discuss the integration of Bragg gratings in aerosol-jetted polymer optical waveguides, produced in the optical assembly and connection technology for component-integrated bus systems (OPTAVER) process. By using a femtosecond laser and adaptive beam shaping, an elliptical focal voxel generates different types of single pulse modification by nonlinear absorption in the waveguide material, which are arranged periodically to form Bragg gratings. Integration of a single grating structure or, alternatively, an array of Bragg grating structures in the multimode waveguide yields a pronounced reflection signal with typical multimodal properties, i.e., a number of reflection peaks with non-Gaussian shapes. However, the main wavelength of reflection, located around 1555 nm, is evaluable by means of an appropriate smoothing algorithm. When loaded by mechanical bending, a pronounced Bragg wavelength shift of this reflected peak up to 160 pm is detected. This demonstrates that the additively manufactured waveguides can be used not only for signal transmission but also as a sensor.
RESUMEN
The constantly increasing demands on components and their resource-efficient production require new strategies in modern process chains. The Collaborative Research Centre (CRC) 1153 "Tailored Forming" is working on the production of hybrid solid components made from joined semi-finished products with subsequent forming. Laser beam welding with ultrasonic assistance has proven to be advantageous in the production of semi-finished products due to the active influence on the microstructure as a result of the excitation. In this work, the feasibility of extending the monofrequency excitation of the melt pool used so far during welding to a multifrequency excitation is investigated. Results from simulations and experiments show that a multi-frequency excitation of the weld pool can be effectively realised. Furthermore, it is shown that a combination of previously separately used excitation methods (positioning of the melt pool in the vibration node and in the vibration antinode, respectively) with two different frequencies is successful and leads to a combination of effects as desired, what can be seen from micrographs.