A Three-dimensional Analysis of Nasopharyngeal Airway Characteristics in Subjects with Cleidocranial Dysplasia: A CBCT Study.

Introduction: Children with congenital or acquired craniofacial abnormalities exhibit an array of dental abnormalities like supernumerary teeth, failure of permanent teeth eruption, decreased alveolar bone height, etc. These subjects undergo complex corrective surgeries to improve esthetics and functional derangements, predisposing them to risks of obstructive sleep apnea due to airway obstruction. The various corrective or therapeutic procedures done might lead to airway complications in these children. The study designed was for retrospective evaluation and comparison of the nasopharyngeal (NP) characteristics and assessment of the airway volume three-dimensionally in normal vs cleidocranial subjects. Materials and methods: Cone-beam computed tomography (CBCT) scans of nine subjects with cleidocranial dysplasia (CCD) were compared with the control sample, and matched for age and sex. A 3D-DOCTOR software by Able Software Corporation was used to calculate the volumetric measurements. The correlation and differences among the values were assessed using an independent t-test and Pearson analysis. Results: The values of lower airway width, upper adenoid width, McNamara upper pharynx, retroglossal area, and total pharyngeal area were found to be reduced in the cleidocranial subjects. The NP airway volume and total airway volume also significantly decreased. Discussion: Cleidocranial dysplasia (CCD) being a rare genetic disorder, we could find only nine established cases. Hence our study can be called a pilot study but may work to establish a database of any sort of skeletal and dental anomaly with possible specific respiratory characteristics affecting airway. How to cite this article: Chaturvedi S, Chaturvedi Y, Chowdhary S, et al. A Three-dimensional Analysis of Nasopharyngeal Airway Characteristics in Subjects with Cleidocranial Dysplasia: A CBCT Study. Int J Clin Pediatr Dent 2022;15(5):520-524.

Comparison of sealing ability of MTA and retroplast as root end filling materials evaluated under a stereomicroscope using rhodamine B dye: An In vitro study.

Aim: The aim of the study was to compare the sealing ability of Mineral Trioxide Aggregate (MTA) and Retroplast as root end filling materials using the Rhodamine B dye penetration method in vitro. Methodology: Forty freshly extracted human single-rooted teeth were randomly divided into two groups of 20 teeth each, and standard root-end cavities were prepared in all teeth. The cavities were filled with MTA and Retroplast in groups 1 and 2, respectively. The specimens were then stored in 1% Rhodamine B dye for a week, following which the dye penetration with all samples was analysed under a stereomicroscope and scored according to Tronstad's criteria. The observations were compared with Chi square test at a 0.220 level of significance. Results: 5% of the samples in both the groups showed no significant leakage. The leakage was deeper with the Retroplast group than with the MTA group; however, there was no statistically significant difference between the two groups. Conclusion: Both MTA and Retroplast are similar in their sealing potential as root-end cavity fillings with Retroplast reporting slightly deeper microleakage than MTA within the limits of the present study.

Estimation of changes in nickel and chromium content in nickel-titanium and stainless steel orthodontic wires used during orthodontic treatment: An analytical and scanning electron microscopic study.

INTRODUCTION: The biocompatibility of orthodontic dental alloys has been investigated over the past 20 years, but the results have been inconclusive. The study compares standard 3 M Unitek nickel-titanium (NiTi) and stainless steel archwires with locally available JJ orthodontics wires. Scanning electron microscope (SEM) study of surface changes and complexometric titration to study compositional change was performed. MATERIALS AND METHODS: Ten archwires each of group 1-3 M 0.016" NiTi, group 2-JJ 0.016" NiTi, group 3-3 M 0.019" *0.025" SS and group 4-JJ SS contributed a 10 mm piece of wire for analysis prior to insertion in the patient and 6 weeks post insertion. SEM images were recorded at ×2000, ×4000 and ×6000 magnification. The same samples were subjected to complexiometric titration using ethylenediaminetetraacetic acid to gauge the actual change in the composition. OBSERVATIONS AND RESULTS: The SEM images of all the archwires showed marked changes with deep scratches and grooves and dark pitting corrosion areas post intraoral use. 3M wires showed an uniform criss-cross pattern in as received wires indicating a coating which was absent after intraoral use. There was a significant release of Nickel and Chromium from both group 3 and 4. Group 2 wires released ions significantly more than group 1 (P = 0.0). CONCLUSION: Extensive and stringent trials are required before certifying any product to be used in Orthodontics.

Root canal treatment of a mandibular second premolar with atypical canal pattern.

To present a unique case of mandibular second premolar with an atypical canal pattern. Thorough knowledge of root canal morphology, appropriate assessment of the pulp chamber floor, and critical interpretation of radiographs are a prerequisite for successful root canal treatment. Mandibular premolars frequently exhibit variable and complex root canal morphology and are one of the most difficult cases to treat endodontically. These teeth may require skillful and special root canal preparation and obturation techniques. This article reports an unusual case of a mandibular second premolar with atypical canal pattern that was successfully treated endodontically.

Mandibular left first premolar with two roots: A morphological oddity.

Thorough knowledge of the root canal morphology, appropriate assessment of the pulp chamber floor, and critical interpretation of radiographs are a prerequisite for successful root canal therapy. The possibility of additional root/canal should be considered even in teeth with a low frequency of abnormal root canal anatomy. This article reports on a case of mandibular first premolar with two roots, which was successfully treated with root canal therapy.