RESUMEN
This study is focused on the importance of nanohydroxyapatite (nHA) particle morphology with the same particle size range on the rheological behavior of polycaprolactone (PCL) composite ink with nHA as a promising candidate for additive manufacturing technologies. Two different physiologic-like nHA morphologies, that is, plate and rod shape, with particles size less than 100 nm were used. nHA powders were well characterized and the printing inks were prepared by adding the different ratios of nHA powders to 50% w/v of PCL solution (nHA/PCL: 35/65, 45/55, 55/45, and 65/35 w/w%). Subsequently, the influence of nHA particle morphology and concentration on the printability and rheological properties of composite inks was investigated. HA nanopowder analysis revealed significant differences in their microstructural properties, which affected remarkably the composite ink printability in several ways. For instance, adding up to 65% w/w of plate-like nHA to the PCL solution was possible, while nanorod HA could not be added above 45% w/w. The printed constructs were successfully fabricated using the extrusion-based printing method and had a porous structure with interconnected pores. Total porosity and surface area increased with nHA content due to the improved fiber stability following deposition of material ink. Consequently, degradation rate and bioactivity increased, while compressive properties decreased. While nanorod HA particles had a more significant impact on the mechanical strength than plate-like morphology, the latter showed less crystalline order, which makes them more bioactive than nanorod HA. It is therefore important to note that the nHA microstructure broadly affects the printability of printing ink and should be considered according to the intended biomedical applications.