Sonography in total hip arthroplasty.

PURPOSE: The distance between the anterior surface of the neck of the prosthetic stem and the anterior joint capsule, the "capsular distance", is increased in total hip arthroplasty (THA) with synovitis. We evaluated the potential of ultrasonography (US) in measuring the "capsular distance" in THA hips one year after insertion. MATERIALS AND METHODS: We compared the measurements of the capsular distance using a ruler with those performed with US. A plastic pelvis and femur model with a prosthetic hip and paper tape to simulate the joint capsule were used. We also evaluated the intra- and interobserver agreements between 3 examiners of the US measurements of the anterior capsular distance in 22 patients with THA. The effect of experience in such type of examination was estimated. RESULTS: There was a high correlation when measuring the anterior capsular distance in the prosthetic hip model with a ruler as compared with US. The interobserver agreement in the US measurements was good and became better after examiners gained experience in this procedure. The intraobserver agreement was always better than the interobserver agreement and also improved with increasing numbers of examinations. CONCLUSION: Ultrasonography is a reliable method to measure the anterior capsular distance in THA, especially if performed by an experienced examiner.

Rinsing morcellised bone grafts with bisphosphonate solution prevents their resorption. A prospective randomised double-blinded study.

During revision total hip replacement using morcellised compacted bone allograft, 16 patients were randomised to receive a graft which had been rinsed in either an ibandronate solution or in saline. Patients were assessed by dual energy x-ray absorptiometry after operation and at 3, 6, 12 and 24 months. A region of interest between the tip of the femoral stem and the distal plastic plug was chosen to measure the changes in bone density over time. The study was double-blinded. In all the control patients the bone density decreased during the first three months and then remained constant at this lower level. A large proportion of the mass of the bone graft was lost. In contrast, all patients with grafts treated with bisphosphonate showed a slight increase in bone density. The difference between the groups was highly significant at all points in time. We conclude that rinsing the graft in a bisphosphonate solution prevents its resorption and may therefore reduce the risk of mechanical failure. The treatment is simple, inexpensive, and appears virtually free of risk.

Factors affecting the cement penetration of a hip resurfacing implant: an in vitro study.

An understanding of how the cementing technique influences cement penetration is important for surgeons to plan and conduct hip resurfacing procedures. Therefore the aim of this study is to determine the influence of the following parameters on cement penetration: use of pulse lavage, type of cement, and the standing period of the cement. Nine fresh frozen paired whole cadaver femora were used to investigate cement penetration. The femora were divided into three paired groups: (A) compared the use of pulse lavage to no pulse lavage, (B) compared two low viscosity bone cements SULCEM-3 (Zimmer GmbH, Switzerland) and Surgical Simplex (Stryker Orthopaedics, USA), and (C) compared bone cement viscosities using standing times of 1.5 min. and 3 min. The Durom Hip Resurfacing implant (Zimmer GmbH, Switzerland) was used in all groups. A single slice was taken out of the center of each head. Cement penetration ratio (penetration area divided by the bone area enclosed by implant) and mean cement penetration depth were measured. Cement penetration is increased using pulse lavage, and has the tendency to increase with increasing the cement standing time from 1.5 to 3 min. No difference in cement penetration was found when different cement brands of comparable viscosity were used.

Contamination of polyethylene cups with polymethyl methacrylate particles: an experimental study.

The articulating surfaces of 6 ultra-high molecular weight polyethylene cups were exposed to curing polymethyl methacrylate (PMMA) bone-cement and examined with scanning electron microscopy and laser ablation inductively coupled plasma mass spectrometry (LA-ICPMS). Three of the cups were exposed to blood and bone-cement, and the rest were exposed to bone-cement only. After removal of the bone-cement bulk, PMMA particles were found and identified in all 6 cups. The particles were verified by identifying zirconium with energy-dispersive x-ray fluorescence spectroscopy in 5 cups and with LA-ICPMS in 1 cup. The degree of surface contamination was estimated with LA-ICPMS. The number of zirconium-containing particles detected was on average 10 to 20/mm2. PMMA bone-cement left in polyethylene cups during polymerization can contaminate the articulating surface with adherent PMMA particles.

Polyethylene wear and synovitis in total hip arthroplasty: a sonographic study of 48 hips.

Forty-six patients (48 hips), operated on with cemented total hip arthroplasty (THA) because of arthrosis, were examined radiographically and sonographically at 10-year follow-up. Polyethylene wear of acetabular cups was measured on conventional non-weight-bearing pelvic radiographs, and the volume of polyethylene debris was calculated. Radiographic signs of loosening were identified. The capsular distance (ie, thickness of the synovium or synovial contents) was measured sonographically. We found a significant correlation between increased volumetric wear and increased capsular distance. Hips with radiographically loose acetabular components had significantly greater volumetric wear and capsular distance than those without signs of acetabular loosening. This relationship was not observed in hips with radiographically loose femoral components. In cemented THA, the volume of polyethylene wear debris and the thickness of the synovium and the synovial contents are related. In the event of radiographic loosening of the acetabular component, they are both increased.

EBRA improves the accuracy of radiographic analysis of acetabular cup migration.

EBRA (Ein Bild Röntgen Analyse) is a new computerized method measuring migration and wear of the acetabular cup, suggested to improve measurement accuracy. We evaluated possible errors of measurement and compared EBRA with standard methods. 1. We did repeated measurements on a single radiograph using the same reference lines. The reliability of the input procedure with standard measurements was significantly better than repeated digitization with EBRA. 2. In a more clinical test, a group of 10 patients was studied. 5 radiographs were taken of the same patient on the same day. EBRA improved the reliability of repeated radiographic examination significantly for migration measurements in the vertical direction. 3. To assess the inter- and intraobserver variations, repeated measurements were performed on the clinical series of pelvic radiographs of 10 patients. EBRA was significantly better than standard methods. With EBRA, errors of wear and migration measurements could be reduced, as compared to standard methods. The major improvement with EBRA was found for migration measurements in the vertical direction.

Cumulative revision rate with the Scan Hip Classic I total hip prosthesis. 1,660 cases followed for 2-12 years.

We analyzed the cumulative revision rate in 1,474 patients (1,660 hips) operated on with a cemented Scan Hip Classic I prosthesis from November 1983 to January 1994 at Lund University Hospital. The revision rate was analyzed for 3 diagnoses--arthrosis, rheumatoid arthritis and complication after a hip fracture--and for 2 head diameters--22 and 32 mm. Until January 1996, 36 hips were revised: 31 because of aseptic loosening, 3 because of dislocation and 2 because of infection. The overall revision rate was 5.6% after 10 years and was similar in arthrosis, rheumatoid arthritis and fracture cases. Due to revisions because of dislocation in the 22 mm group, the total revision rate was lower in the 32 mm group (p = 0.03).

Intracapsular pressure and loosening of hip prostheses. Preoperative measurements in 18 hips.

We measured the intracapsular pressure preoperatively in 18 hips (17 patients) before revision of a total hip arthroplasty because of aseptic loosening. Distension of the joint capsule was measured with sonography in 13 cases. In extension, the mean intracapsular pressure was 26 (0-60) mmHg, in extension and inward rotation it was 159 (24-280) mmHg, in extension and outward rotation it was 30 (3-67) mmHg and in 45 degrees of flexion it was 12 (0-28) mmHg. A mean of 6 (0.5-20) mL of joint fluid was aspirated after the pressure measurements. Sonography showed increased joint fluid/synovial edema and/or increased capsular thickness, as compared to 34 unrevised, radiographically not loose prosthetic hips, and that the capsular distension correlated to intracapsular pressure during extension and inward rotation. We conclude that the intracapsular pressure usually is elevated in a hip joint with loose prosthetic components, that the intracapsular pressure varies with the position of the hip and that capsular distension reflects increased intracapsular pressure. The increased and often very high pressure, varying during gait, may pump debris away from the joint along the interfaces and even by itself cause osteolysis and loosening.

Polyethylene wear in Scanhip arthroplasty with a 22 or 32 mm head: 62 matched patients followed for 7-9 years.

We measured radiographic polyethylene wear in patients with Scanhip arthroplasty and no clinical or radiographic signs of loosening. The patients were divided into 2 groups according to head sizes. 32 patients (33 hips) had an implant with a 22 mm and 30 patients (34 hips) with a 32 mm head. They were followed for 7-9 years. The groups were matched for diagnosis, sex, weight, age, and time of follow-up. The mean linear wear with a 22 mm head was 1.1 mm and with a 32 mm head 1.5 mm (p 0.004), which corresponds to a yearly wear rate of 0.15 mm and 0.18 mm, respectively. The mean difference in volumetric wear was greater, 420 mm3, as compared to 1239 mm3.

The effect of arthrocentesis in transient synovitis of the hip in the child: a longitudinal sonographic study.

Twenty-one children with transient synovitis of the hip were treated in two consecutive groups. In 12 patients aspiration of the synovial effusion was performed within 24 h of admission. In a second group of nine patients no aspiration was performed. There was no other difference in treatment. Joint effusion was studied sonographically in comparison with the nonsymptomatic contralateral hip. Sonography was performed immediately after admission, within 12 h after aspiration, and repeatedly during a follow-up period of up to 15 days. Following aspiration the capsular distention decreased to 49% but recurred within 24 h to 72% of the preoperative value. However, during the first 4 days of follow-up the capsular distention in the aspirated cases was significantly and permanently lower than in the nonaspirated cases. We conclude that arthrocentesis in the acute stage of transient synovitis of the hip in the child permanently reduces the intracapsular effusion.