Assessment of radiation protection of patients and staff in interventional procedures in four Algerian hospitals.

This study was aimed to assess patient dosimetry in interventional cardiology (IC) and radiology (IR) and radiation safety of the medical operating staff. For this purpose, four major Algerian hospitals were investigated. The data collected cover radiation protection tools assigned to the operating staff and measured radiation doses to some selected patient populations. The analysis revealed that lead aprons are systematically worn by the staff but not lead eye glasses, and only a single personal monitoring badge is assigned to the operating staff. Measured doses to patients exhibited large variations in the maximum skin dose (MSD) and in the dose area product (DAP). The mean MSD registered values are as follows: 0.20, 0.14 and 1.28 Gy in endoscopic retrograde cholangiopancreatography (ERCP), coronary angiography (CA) and percutaneous transluminal coronary angioplasty (PTCA) procedures, respectively. In PTCA, doses to 3 out of 22 patients (13.6 %) had even reached the threshold value of 2 Gy. The mean DAP recorded values are as follows: 21.6, 60.1 and 126 Gy cm(2) in ERCP, CA and PTCA procedures, respectively. Mean fluoroscopic times are 2.5, 5 and 15 min in ERCP, CA and PTCA procedures, respectively. The correlation between DAP and MSD is fair in CA (r = 0.62) and poor in PTCA (r = 0.28). Fluoroscopic time was moderately correlated with DAP in CA (r = 0.55) and PTCA (r = 0.61) procedures. Local diagnostic reference levels (DRLs) in CA and PTCA procedures have been proposed. In conclusion, this study stresses the need for a continuous patient dose monitoring in interventional procedures with a special emphasis in IC procedures. Common strategies must be undertaken to substantially reduce radiation doses to both patients and medical staff.

A study to establish international diagnostic reference levels for paediatric computed tomography.

The article reports results from the largest international dose survey in paediatric computed tomography (CT) in 32 countries and proposes international diagnostic reference levels (DRLs) in terms of computed tomography dose index (CTDI vol) and dose length product (DLP). It also assesses whether mean or median values of individual facilities should be used. A total of 6115 individual patient data were recorded among four age groups: <1 y, >1-5 y, >5-10 y and >10-15 y. CTDIw, CTDI vol and DLP from the CT console were recorded in dedicated forms together with patient data and technical parameters. Statistical analysis was performed, and international DRLs were established at rounded 75th percentile values of distribution of median values from all CT facilities. The study presents evidence in favour of using median rather than mean of patient dose indices as the representative of typical local dose in a facility, and for establishing DRLs as third quartile of median values. International DRLs were established for paediatric CT examinations for routine head, chest and abdomen in the four age groups. DRLs for CTDI vol are similar to the reference values from other published reports, with some differences for chest and abdomen CT. Higher variations were observed between DLP values, based on a survey of whole multi-phase exams. It may be noted that other studies in literature were based on single phase only. DRLs reported in this article can be used in countries without sufficient medical physics support to identify non-optimised practice. Recommendations to improve the accuracy and importance of future surveys are provided.

Monte Carlo photon beam modeling and commissioning for radiotherapy dose calculation algorithm.

The aim of the present work was a Monte Carlo verification of the Multi-grid superposition (MGS) dose calculation algorithm implemented in the CMS XiO (Elekta) treatment planning system and used to calculate the dose distribution produced by photon beams generated by the linear accelerator (linac) Siemens Primus. The BEAMnrc/DOSXYZnrc (EGSnrc package) Monte Carlo model of the linac head was used as a benchmark. In the first part of the work, the BEAMnrc was used for the commissioning of a 6 MV photon beam and to optimize the linac description to fit the experimental data. In the second part, the MGS dose distributions were compared with DOSXYZnrc using relative dose error comparison and γ-index analysis (2%/2 mm, 3%/3 mm), in different dosimetric test cases. Results show good agreement between simulated and calculated dose in homogeneous media for square and rectangular symmetric fields. The γ-index analysis confirmed that for most cases the MGS model and EGSnrc doses are within 3% or 3 mm.

Experimental evaluation of PCXMC and prepare codes used in conventional radiology.

The objective of this study is to evaluate the precision of dose-calculation computer codes used in our laboratory (PCXMC and PREPARE) for organ dose evaluation. Measurements of entrance and organ dose were performed using ionisation chamber and thermoluminescence dosimetry. To obtain a mean dose of organ, we have used the Rando-Alderson phantom. The results showed that computed and measured doses correlate well (within 28%) in 60% of the samples. The percentage shows that the computed doses correlate with the experimental doses rather well for PCXMC software than PREPARE. Although the two programs are based on the Monte-Carlo method, their calculations differ. PCXMC carries out a simulation of the trajectory of the photon, whereas PREPARE provides interpolated values. Our experimental results are close to the values given by the PCXMC, a program which takes into account the weight, the height of the patient and field dimensions.