Efficient one-pot synthesis of magnetic MIL-100(Fe) using nitric acid without additional Fe ion addition and adsorption behavior of charged organic compounds.

Metal organic frameworks (MOFs) are attracting attention as high-performance adsorbents because of their high specific surface area and porosity. In particular, magnetic MIL-100(Fe) has the both characteristics of Fe3O4 and MIL-100(Fe), which are magnetic characteristics, high specific surface area and open metal sites. However, multiple synthetic steps are required for synthesis of magnetic MOF, and there is limitation that the residual organic linker and unreacted Fe center ions can be discharged, and they cause water pollution. In this study, magnetic MIL-100(Fe) was synthesized within 4 h without the addition of Fe ions by using nitric acid for the surface modification of Fe3O4. Magnetic MIL-100(Fe) was confirmed through XRD, FTIR, and TEM surface analysis, and the optimal conditions for nitric acid addition were selected through magnetization measurements and BET analysis of synthesized magnetic MIL-100(Fe). Thereafter, adsorption evaluation was performed using MB and MO, which are representative cationic and anionic dyes, respectively. The pseudo-second-order Langmuir model showed a relatively high correlation compared to the other models. This shows that the adsorption mechanism depends on both the amount of adsorbent and adsorbate, and Fe3O4 modification with nitric acid does not cause any change in the adsorption mechanism. In the case of adsorption selectivity between the MB and MO, removal rates of 93.27% and 58.73% were obtained, respectively. The above results can contribute to the simplification of the manufacturing of magnetic metal organic frameworks for removing ionic organic compounds and the minimization of water pollution in the manufacturing process.

Electrode for selective bromide removal in membrane capacitive deionisation.

Due to the shortage of freshwater around the world, seawater is becoming an important water source. However, seawater contains a high concentration of bromide that can form harmful disinfection by-products during water disinfection. Therefore, the current seawater reverse osmosis (SWRO) has to adopt two-pass reverse osmosis (RO) configuration for effective bromide removal, increasing the overall desalination cost. In this study, a bromide selective composite electrode was developed for membrane capacitive deionisation (MCDI). The composite electrode was developed by coating a mixture of bromide selective resin and anion exchange polymer on the surface of the commercial activated carbon electrode, and its performance was compared to that of conventional carbon electrode. The results demonstrated that the composite electrode has ten times better bromide selectivity than the conventional carbon electrode. The study shows the potential application of MCDI for the selective removal of target ions from water sources and the potential for resource recovery through basic modification of commercial electrode.

Bromide and iodide selectivity in membrane capacitive deionisation, and its potential application to reduce the formation of disinfection by-products in water treatment.

The formation of toxic disinfection by-products during water disinfection due to the presence of bromide and iodide is a major concern. Current treatment technologies such as membrane, adsorption and electrochemical processes have been known to have limitations such as high energy demand and excessive chemical use. In this study, the selectivity between bromide and iodide, and their removal in membrane capacitive deionisation (MCDI) was evaluated. The results showed that iodide was more selectively removed over bromide from several binary feed waters containing bromide and iodide under various initial concentrations and applied voltages. Even in the presence of significant background concentration of sodium chloride, definite selectivity of iodide over bromide was observed. The high partial-charge transfer coefficient of iodide compared to bromide could be a feasible explanation for high iodide selectivity since both bromide and iodide have similar ionic charge and hydrated radius. The result also shows that MCDI can be a potential alternative for the removal of bromide and iodide during water treatment.