RESUMEN
An electrochemical series of pyrrolidinium-based ionic liquids is established by designing a redox system where only one kind of anion is present in the electrolyte and metal ions are supplied by anodic dissolution. This is the first report where an electrochemical series is established in pure ionic liquids.
RESUMEN
Effective transportation of fly ash-water slurry through a pipeline from its generation site, a power plant, to a storage site by replacing commercial surfactants such as cetyl trimethyl ammonium bromide and sodium dodecyl sulfate by a natural dispersant extracted from Sapindus laurifolia was studied. The stability of fly ash slurry was determined from its rheological parameters, dispersant concentration, and stabilization mechanism. From surface tensiometric data, the critical micelle concentration of the dispersant was obtained to be 0.017 g/cc. The stabilization of high-concentration fly ash slurry has been studied through its rheological behavior by variation of temperature and dispersant and ash concentration. The rheological result obtained for fly ash concentrations in the range of 50-65% slurry was best justified by the Bingham plastic model. The wettability of fly ash particles is increased in the presence of dispersants, which is inferred from reduction of the surface tension value. The stabilization mechanism of the slurry is explained by a steric factor as indicated by the decrease in the zeta potential value. Air pollution is minimized at its destination site due to agglomeration of fly ash particles, which is confirmed from the SEM microphotograph.
RESUMEN
Dissolution of metals from a pre-oxidized refinery plant spent Co-Mo/Al(2)O(3) catalyst have been tried through low temperature (200-450 degrees C) sulfuric acid baking followed by mild leaching process. Direct sulfuric acid leaching of the same sample, resulted poor Al and Mo recoveries, whereas leaching after sulfuric acid baking significantly improved the recoveries of above two metals. The pre-oxidized spent catalyst, obtained from a Korean refinery plant found to contain 40% Al, 9.92% Mo, 2.28% Co, 2.5% C and trace amount of other elements such as Fe, Ni, S and P. XRD results indicated the host matrix to be poorly crystalline gamma- Al(2)O(3). The effect of various baking parameters such as catalyst-to-acid ratio, baking temperature and baking time on percentage dissolutions of metals has been studied. It was observed that, metals dissolution increases with increase in the baking temperature up to 300 degrees C, then decreases with further increase in the baking temperature. Under optimum baking condition more than 90% Co and Mo, and 93% Al could be dissolved from the spent catalyst with the following leaching condition: H(2)SO(4)=2% (v/v), temperature=95 degrees C, time=60 min and Pulp density=5%.