Profiling 25 Bone Marrow microRNAs in Acute Leukemias and Secondary Nonleukemic Hematopoietic Conditions.

INTRODUCTION: The standard treatment of acute leukemias (AL) is becoming more efficacious and more selective toward the mechanisms via which to suppress hematologic cancers. This tendency in hematology imposes additional requirements on the identification of molecular-genetic features of tumor clones. MicroRNA (miRNA, miR) expression levels correlate with cytogenetic and molecular subtypes of acute leukemias recognized by classification systems. The aim of this work is analyzing the miRNA expression profiles in acute myeloblastic leukemia (AML) and acute lymphoblastic leukemia (ALL) and hematopoietic conditions induced by non-tumor pathologies (NTP). METHODS: A total of 114 cytological samples obtained by sternal puncture and aspiration biopsy of bone marrow (22 ALLs, 44 AMLs, and 48 NTPs) were analyzed by real-time PCR regarding preselected 25 miRNAs. For the classification of the samples, logistic regression was used with balancing of comparison group weights. RESULTS: Our results indicated potential feasibility of (i) differentiating ALL+AML from a nontumor hematopoietic pathology with 93% sensitivity and 92% specificity using miR-150:miR-21, miR-20a:miR-221, and miR-24:nf3 (where nf3 is a normalization factor calculated from threshold cycle values of miR-103a, miR-191, and miR-378); (ii) diagnosing ALL with 81% sensitivity and 81% specificity using miR-181b:miR-100, miR-223:miR-124, and miR-24:nf3; and (iii) diagnosing AML with 81% sensitivity and 84% specificity using miR-150:miR-221, miR-100:miR-24, and miR-181a:miR-191. CONCLUSION: The results presented herein allow the miRNA expression profile to de used for differentiation between AL and NTP, no matter what AL subtype.

Outcomes of video-assisted thoracoscopic surgery lobectomy in septuagenarians.

BACKGROUND: Spread of technology and increased surveillance have led to more patients with lung cancers being identified than ever before. Increasingly, patients from the elderly population are referred for surgery; however, many studies do not focus on this patient group. We reviewed the outcomes of septuagenarians who underwent lobectomy via an open thoracotomy (OT) or video-assisted thoracoscopic surgery (VATS) approach to determine whether the VATS approach would result in superior post-operative outcomes. METHODS: Between January 2010 and June 2016, a total of 96 patients aged 70 years or older underwent a lobectomy for non-small cell lung carcinoma. Patients who underwent resection for metastatic disease, small cell lung cancer or neuroendocrine tumour were excluded. Demographic details, early and late post-operative outcomes including post-operative arrhythmia, myocardial infarction, respiratory failure, cerebrovascular events, infection, prolonged air leak, delirium, readmission and 30-day mortality were studied. Mean follow-up duration was 23 ± 19.1 months. RESULTS: Seventy-five patients underwent lobectomy via a VATS approach and 21 patients underwent lobectomy via an OT approach. There was no 30-day mortality and no difference in overall survival between the two techniques (P = 0.25). There was no significant difference between the two techniques with regard to post-operative stroke, myocardial infarction, atrial fibrillation, pneumonia, delirium or bronchopleural fistula. VATS patients had a significantly shorter mean hospital length of stay (VATS 4.7 days, OT 9.3 days, P = 0.005). CONCLUSION: Septuagenarians with non-small cell lung carcinoma can successfully undergo curative lung resection with a low incidence of post-operative complications.

Au Gratings Fabricated by Interference Lithography for Experimental Study of Localized and Propagating Surface Plasmons.

Optical properties of high-frequency Au gratings with a fixed period (296.6 ± 0.5 nm) and a variable modulation depth are studied using measurements of spectral and angular dependence of transmission and reflection of polarized light in order to build the dispersion curves of excited optical modes and to identify their types. It was shown that in gratings with small modulation depth only propagating surface plasmon-polaritons (SPP) modes were observed. With increasing of modulation depth, the intensity of SPP decreases and localized plasmon (LP) resonance appears, which is more intense at small incident angles, and overlaps with the SPP modes. For grating with isolated grooves (nanowires), mostly LP resonance is observed. After additional deposition of gold onto grating with isolated grooves, the intensity of the SPP mode increases again, and the LP band maximum shifts to longer wavelengths.

Enhanced Dielectric Environment Sensitivity of Surface Plasmon-Polariton in the Surface-Barrier Heterostructures Based on Corrugated Thin Metal Films with Quasi-Anticorrelated Interfaces.

A new approach to the formation of a 1D planar periodicity on the front of a plasmonic photodetector based on Schottky barrier is proposed. It allows forming a 1D planar periodicity with corrugation at the "metal/environment" interface by laser interference lithography using embedded chalcogenide wires, whereas the "metal/semiconductor" interface is flat that leads to reducing of surface recombination losses at Shottky barrier in contrary to the conventional technology for forming corrugated metal films on the semiconductor surface requiring chemical etching of the semiconductor substrate. In this case, the metal film interfaces are quasi-anticorrelated as opposed to correlated ones in the conventional technology. It has been theoretically predicted that the polarization sensitivity (T p /T s ) strongly depends on the cross-sectional shape of chalcogenide wires and reaches a value of 8. Furthermore, it was theoretically found that the maximum sensitivity of the signal intensity on the environment refractive index is three times larger than for an equivalent structure obtained by conventional technology. Comparison of experimental data for the photocurrent in the case of two types of correlation between metal film interfaces demonstrates good agreement with numerical simulations.

Fabrication of Periodic Plasmonic Structures Using Interference Lithography and Chalcogenide Photoresist.

This study reports on the employment of the interference lithography (IL) technique, using photoresist based on the chalcogenide glass (ChG) films, for fabrication of one-dimensional (gratings) and two-dimensional (arrays) periodic plasmonic structures on the surface of glass plates. The IL technique was optimized for patterning of the Au and Al layers and formation of gratings and arrays with a spatial frequency of 2000 mm(-1). Optical properties of obtained structures were studied using measurements of spectral and angular dependence of transmission and reflection of polarized light. It was shown that the spectral and angular position of the surface plasmon polariton and local surface plasmon resonance, which are observed in these samples, can be adjusted over a wide range by selecting the geometric parameters of structures and technological modes of their manufacturing.

The nanostructuring of surfaces and films using interference lithography and chalcogenide photoresist.

The reversible and transient photostimulated structural changes in annealed chalcogenide glass (ChG) layers were used to form interference periodic structures on semiconductor surfaces and metal films. It was shown that negative-action etchants based on amines dissolve illuminated parts of a chalcogenide film, i.e., act as positive etchants. The diffraction gratings and 2-D interference structures on germanium ChGs - more environmentally acceptable compounds than traditionally used arsenic chalcogenides - were recorded, and their characteristics were studied.

Photoluminescence decay rate of silicon nanoparticles modified with gold nanoislands.

We investigated plasmon-assisted enhancement of emission from silicon nanoparticles (ncs-Si) embedded into porous SiOx matrix in the 500- to 820-nm wavelength range. In the presence in the near-surface region of gold nanoisland film, ncs-Si exhibited up to twofold luminescence enhancement at emission frequencies that correspond to the plasmon resonance frequency of Au nanoparticles. Enhancement of the photoluminescence (PL) intensity was attributed to coupling with the localized surface plasmons (LSPs) excited in Au nanoparticles and to increase in the radiative decay rate of ncs-Si. It has been shown that spontaneous emission decay rate of ncs-Si modified by thin Au film over the wide emission spectral range was accelerated. The emission decay rate distribution was determined by fitting the experimental decay curves to the stretched exponential model. The observed increase of the PL decay rate distribution width for the Au-coated nc-Si-SiOx sample in comparison with the uncoated one was explained by fluctuations in the surface-plasmon excitation rate. PACS: 78. 67. Bf; 78.55.-m.