Final Measurement of the

This Letter reports one of the most precise measurements to date of the antineutrino spectrum from a purely ^{235}U-fueled reactor, made with the final dataset from the PROSPECT-I detector at the High Flux Isotope Reactor. By extracting information from previously unused detector segments, this analysis effectively doubles the statistics of the previous PROSPECT measurement. The reconstructed energy spectrum is unfolded into antineutrino energy and compared with both the Huber-Mueller model and a spectrum from a commercial reactor burning multiple fuel isotopes. A local excess over the model is observed in the 5-7 MeV energy region. Comparison of the PROSPECT results with those from commercial reactors provides new constraints on the origin of this excess, disfavoring at 2.0 and 3.7 standard deviations the hypotheses that antineutrinos from ^{235}U are solely responsible and noncontributors to the excess observed at commercial reactors, respectively.

Joint Measurement of the

The PROSPECT and STEREO collaborations present a combined measurement of the pure ^{235}U antineutrino spectrum, without site specific corrections or detector-dependent effects. The spectral measurements of the two highest precision experiments at research reactors are found to be compatible with χ^{2}/ndf=24.1/21, allowing a joint unfolding of the prompt energy measurements into antineutrino energy. This ν[over ¯]_{e} energy spectrum is provided to the community, and an excess of events relative to the Huber model is found in the 5-6 MeV region. When a Gaussian bump is fitted to the excess, the data-model χ^{2} value is improved, corresponding to a 2.4σ significance.

Invited Article: miniTimeCube.

We present the development of the miniTimeCube (mTC), a novel compact neutrino detector. The mTC is a multipurpose detector, aiming to detect not only neutrinos but also fast/thermal neutrons. Potential applications include the counterproliferation of nuclear materials and the investigation of antineutrino short-baseline effects. The mTC is a plastic 0.2% (10)B-doped scintillator (13 cm)(3) cube surrounded by 24 Micro-Channel Plate (MCP) photon detectors, each with an 8 × 8 anode totaling 1536 individual channels/pixels viewing the scintillator. It uses custom-made electronics modules which mount on top of the MCPs, making our detector compact and able to both distinguish different types of events and reject noise in real time. The detector is currently deployed and being tested at the National Institute of Standards and Technology Center for Neutron Research nuclear reactor (20 MWth) in Gaithersburg MD. A shield for further tests is being constructed, and calibration and upgrades are ongoing. The mTC's improved spatiotemporal resolution will allow for determination of incident particle directions beyond previous capabilities.

Ultrasound coupling media: their relative transmissivity.

The relative transmissivities of several commonly used ultrasonic coupling agents were measured to determine if there were significant differences in their effectiveness. Coupling media were evaluated in thin films to simulate clinical use. In order to minimize experimental error in this determination, transmitted energy was measured in the far field of the sonating transducer; the receiving transducer was angled slightly to minimize standing waves; and the sonating chamber was made as anechoic as possible. It was found that there is no practical difference in the transmissivities of the common coupling agents, except that hydrocortisone ointments and creams had lower transmissivities, probably due to microscopically entrapped air. When used as a thin film, absorption of ultrasound in the media was insignificant, and variation in transducer pressure was found to cause differences in energy transmitted greater than those found between the common coupling media. Consequently, it was concluded that coupling media can be chosen primarily on the basis of cost and convenience.

Heat and stretch procedures: an evaluation using rat tail tendon.

This study evaluated various methods of applying force to collagenous tissue at various temperatures to produce permanent elongation, using rat tail tendon as the tissue model. A materials testing machine was used to measure the forces applied and the resulting elongation produced by differing procedures. Short-term vigorous stretching and prolonged moderate stretching were compared at 37 C. The effect of heating tissue prior to applying force was evaluated, and the effect of using a prolonged application of low force was demonstrated. The data showed that the low force, long duration procedure was very effective at producing residual elongation. Elevating tissue temperature and maintaining it prior to applying force was found to cause significantly less damage; and finally, the lower loads applied at elevated temperatures for prolonged periods were found to produce significantly greater residual elongation.