RESUMEN
In multivalley systems, the valley pseudospin offers rich physics going from encoding of information by its polarization (valleytronics), to exploring novel phases of matter when its degeneracy is changed. Here, by strain engineering, we reveal fully valley-polarized quantum Hall phases in the Pb_{1-x}Sn_{x}Se Dirac system. Remarkably, when the valley energy splitting exceeds the fundamental band gap, we observe a "bipolar quantum Hall phase," heralded by the coexistence of hole and electron chiral edge states at distinct valleys in the same quantum well. This suggests that spatially overlaid counterpropagating chiral edge states emerging at different valleys do not interfere with each other.
RESUMEN
The self-assembling of 3,4,9,10-perylene-tetracarboxylic-dianhydride (PTCDA) molecules deposited on an InSb(001) c(8 × 2) surface at sub-monolayer quantities has been investigated at low temperature (77 K) using scanning tunnelling microscopy. Sub-molecular resolution was obtained on PTCDA molecules. The results reveal that individual PTCDA molecules are arranged on the substrate in chains parallel to the [110] crystallographic direction, correlated with characteristic features of the low temperature InSb(001) c(8 × 2) surface electronic structure. A structural model for PTCDA molecules adsorbed on InSb is proposed.
RESUMEN
Muscovite mica is an important mineral that has become a standard substrate, due to its easy cleavage along the {001} planes, revealing a very flat surface that is compatible with many biological materials. Here we study mica surfaces by dynamic atomic force microscopy (AFM) operated in the non-contact mode (NC-AFM) under ultra-high vacuum (UHV) conditions. Surfaces produced by cleaving in UHV cannot be imaged with NC-AFM due to large surface charges; however, cleavage in air yields much less surface charge and allows for NC-AFM imaging. We present highly resolved NC-AFM images of air-cleaved mica surfaces revealing a rough morphology originating from a high density of nanometre-sized particles. Among these particles, we find regularly shaped structures indicating the growth of crystallites on the surface. The contamination layer cannot be removed by degassing in UHV; even prolonged heating at a temperature of 560 K under UHV conditions does not yield an atomically flat surface.
RESUMEN
We have used scanning tunnelling microscopy (STM) at 77 K to investigate 3,4,9,10-perylene-tetracarboxylic dianhydride (PTCDA) molecules adsorbed on an ultrathin (1-2 monolayer (ML)) film of KBr grown on a c(8 × 2)InSb(001) substrate. The molecules are stabilized both at the KBr steps and on the terraces. On the 1 ML film the PTCDA molecules appear predominantly as single entities, whereas on the 2 ML film formation of molecular clusters is preferred. Differences in the adsorption configurations indicate that the interaction between the molecules and the surface differs significantly for the cases of 1 and 2 ML films. We present images of the molecules obtained with sub-molecular resolution for both filled and empty state sampling modes. We argue that the highest occupied molecular orbital (the lowest unoccupied molecular orbital) is responsible for intramolecular contrast in filled (empty) state images of the molecules, even though they are deformed due to strong interaction with the substrate.
RESUMEN
PTCDA (3,4,9,10-perylene-tetracarboxylic-dianhydride) molecular structures assembled on an InSb(001) c(8 × 2) reconstructed surface have been studied using frequency modulated atomic force microscopy. The high-resolution imaging of the structures is possible through repulsive interactions, using the constant height scanning mode. During initial stages of growth the [110] diffusion channel dominates as indicated by formation of long PTCDA molecular chains parallel to the [110] crystallographic direction on the InSb surface. For a single monolayer coverage a wetting layer of PTCDA is formed. Finally it is shown that the PTCDA/InSb is a promising system for building molecular nanostructures by manipulation of single molecules with the AFM tip.
RESUMEN
Noncontact atomic force microscopy (NC-AFM) has been used to study the c(8x2) InSb(001) and the c(8x2) GaAs(001) surfaces prepared by sputter cleaning and annealing. Atomically resolved tip-surface interaction maps display different characteristic patterns depending on the tip front atom type. It is shown that representative AFM maps can be interpreted consistently with the most recent structural model of A(III)B(V)(001) surface, as corresponding to the A(III) sublattice, to the B(V) sublattice, or to the combination of both sublattices.
