Gas chromatography-mass spectrometry with spiral large-volume injection for determination of fluoridated phosphonates produced by fluoride-mediated regeneration of nerve agent adduct in human serum.

A sensitive method for determination of fluoridated phosphonates produced by fluoride-mediated regeneration of nerve agent adduct in human serum was developed using gas chromatography-mass spectrometry (GCMS) with large-volume injection. The GC injection was administered using stomach-type spiral injector (LVI, AiSTI SCIENCE) enabling introduction of only target compounds from 50 µL ethyl acetate extract after purging the solvent. For GCMS analysis of sarin (GB), 670 times higher sensitivity, based on limit of detection (LOD, S/N = 3, on extracted ion chromatogram (EIC) at m/z 99), was achieved using this injection (50 µL) compared to that achieved using 1 µL split injection (ratio 20:1). Ethyl (EtGB), isopropyl (GB), n-propyl (nPrGB), isobutyl (iBuGB), pinacolyl (GD), cyclohexyl (GF) methylphosphonofluoridates, and O-ethyl N, N-dimethylphosphoramidofluoridate (GAF) were detected with low LOD (15-75 pg/mL) and sharp peak shapes (high practical plate number (defined as 5.54 x (tR/Wh)2, where tR is the retention time and Wh is the bandwidth at half-height): 1100000-2400000) in GCMS using a polar separation column, electron ionization, and quadruple mass analyzer. During the analysis of fluoridated phosphonate-spiked ethyl acetate extract of solid phase extraction (SPE, Bond Elut NEXUS) from fluoride-mediated regeneration of blank human plasma, LOD (on EIC at m/z 99 except for GAF (m/z 126)) were 25-140 pg/mL with sharp peak shapes. The reaction recoveries in fluoride-mediated regeneration of plasma, which was inhibited by GB, GD, GA, GF, VX, and Russian VX (10 ng/mL), were 49-114% except for GD (10%). The concentration levels of 0.3-1 ng/mL of nerve agents in plasma could be determined.

Semi-automated bacterial spore detection system with micro-fluidic chips for aerosol collection, spore treatment and ICAN DNA detection.

A semi-automated bacterial spore detection system (BSDS) was developed to detect biological threat agents (e.g., Bacillus anthracis) on-site. The system comprised an aerosol sampler, micro-fluidic chip-A (for spore germination and cell lysis), micro-fluidic chip-B (for extraction and detection of genomic DNA) and an analyzer. An aerosol with bacterial spores was first collected in the collection chamber of chip-A with a velocity of 300 l/min, and the chip-A was taken off from the aerosol sampler and loaded into the analyzer. Reagents packaged in the chip-A were sequentially applied into the chamber. The genomic DNA extract from spore lyzate was manually transferred from chip-A to chip-B and loaded into the analyzer. Genomic DNA in chip-B was first trapped on a glass bead column, washed with various reagents, and eluted to the detection chamber by sequential auto-dispensing. Isothermal and chimeric primer-initiated amplification of nucleic acids (ICAN) with fluorescent measurement was adopted to amplify and detect target DNA. Bacillus subtilis was the stimulant of biological warfare agent in this experiment. Pretreatment conditions were optimized by examining bacterial target DNA recovery in the respective steps (aerosol collection, spore germination, cell lysis, and DNA extraction), by an off-chip experiment using a real-time polymerase chain reaction quantification method. Without the germination step, B. subtilis spores did not demonstrate amplification of target DNA. The detection of 10(4) spores was achieved within 2h throughout the micro-fluidic process.