Modeling Mechanochemical Reaction Mechanisms.

The mechanochemical reaction between copper and dimethyl disulfide is studied under well-controlled conditions in ultrahigh vacuum (UHV). Reaction is initiated by fast S-S bond scission to form adsorbed methyl thiolate species, and the reaction kinetics are reproduced by two subsequent elementary mechanochemical reaction steps, namely a mechanochemical decomposition of methyl thiolate to deposit sulfur on the surface and evolve small, gas-phase hydrocarbons, and sliding-induced oxidation of the copper by sulfur that regenerates vacant reaction sites. The steady-state reaction kinetics are monitored in situ from the variation in the friction force as the reaction proceeds and modeled using the elementary-step reaction rate constants found for monolayer adsorbates. The analysis yields excellent agreement between the experiment and the kinetic model, as well as correctly predicting the total amount of subsurface sulfur in the film measured using Auger spectroscopy and the sulfur depth distribution measured by angle-resolved X-ray photoelectron spectroscopy.

Reaction of tributyl phosphite with oxidized iron: surface and tribological chemistry.

The surface chemistry of a model lubricant additive, tributyl phosphite (TBPi), is investigated on Fe3O4 in ultrahigh vacuum. A portion of the TBPi desorbs molecularly following adsorption at approximately 200 K, the remainder decomposing either by C-O bond scission to form 1-butyl species or by P-O bond cleavage to form butoxy species. Adsorbed butyl species either undergo beta-hydride elimination to desorb 1-butene or decompose to deposit carbon and hydrogen on the surface. The resulting adsorbed hydrogen reacts with the oxide to desorb water or with the butoxy species to form 1-butanol. Butoxy species are stable up to approximately 600 K at which temperature they also undergo beta-hydride elimination to form butanal and the released hydrogen reacts with other butoxy species to form 1-butanol. Only a small amount of carbon is deposited onto the surface following adsorption at approximately 200 K, which then desorbs as CO above approximately 750 K. Adsorbing TBPi at 300 K results in the deposition of more carbon and an Auger depth profile reveals that the carbon is located predominantly on the surface, while the phosphorus is rather uniformly distributed throughout the oxide film. This result is in accord with previous near-edge X-ray absorption fine structure measurements, which show the formation of phosphates and polyphosphate glasses. The resulting tribological film appears to be composed of a relatively hard polyphosphate glass formed by rapid diffusion of POx species into the oxide, covered by a low shear strength graphitic layer.