Kinetic Studies on the Oxoiron(IV) Complex with Tetradentate Aminopyridine Ligand PDP*: Restoration of Catalytic Activity by Reduction with H2O2.

Oxoiron(IV) is a common catalytic byproduct observed in the oxidation of alkenes by the combination of H2O2 and nonheme iron catalysts including complex 1, FeIIPDP* (where PDP* = bis(3,5-dimethyl-4-methoxypyridyl-2-methyl)-(R,R)-2,2'-bipyrrolidine). The oxoiron(IV) species have been proposed to arise by O-O homolysis of the peroxyiron(III) or acylperoxyiron(III) intermediates formed during the presumed FeIII-FeV catalytic cycle and have generally been regarded as off-pathway. We generated complex 1IV═O (λmax = 730 nm, ε = 350 M-1 cm-1) directly from 1 and an oxygen atom donor IBXi-Pr (isopropyl 2-iodoxybenzoate) in acetonitrile in the temperature range from -35 to +25 °C under stopped-flow conditions. Species 1IV═O is metastable (half-life of 2.0 min at +25 °C), and its decay is accelerated in the presence of organic substrates such as thioanisole, alkenes, benzene, and cyclohexane. The reaction with cyclohexane-d12 is significantly slower (KIE = 4.9 ± 0.4), suggesting that a hydrogen atom transfer to 1IV═O is the rate limiting step. With benzene-d6, no significant isotope effect is observed (KIE = 1.0 ± 0.2), but UV-vis spectra show the concomitant formation of an intense 580 nm band likely due to the Fe(III)-phenolate chromophore, suggesting an electrophilic attack of 1IV═O on the aromatic system of benzene. Treatment of 1IV═O with H2O2 resulted in rapid decay of its 730 nm visible band (k = 102.6 ± 4.6 M-1 s-1 at -20 °C), most likely occurring by a hydrogen atom transfer from H2O2. In the presence of excess H2O2, the oxoiron(IV) is transformed into peroxyiron(III), as seen from the formation of a characteristic 550 nm visible band and geff = 2.22, 2.16, and 1.96 electron paramagnetic resonance (EPR) spectroscopy signals. Reductively formed 1III-OOH was able to re-enter the catalytic cycle of alkene epoxidation by H2O2, albeit with lower yields versus those of oxidatively formed (i.e., 1 + H2O2) peroxyiron(III) owing to a loss of ca. 40% active iron. As such, the oxoiron(IV) species can be reintroduced to the catalytic cycle with extra H2O2, acting as an iron reservoir. Alternatively, peroxycarboxylic acids, which have a stronger O-H bond dissociation energy, do not reduce 1IV═O, ensuring that more oxidant is productively employed in substrate oxidation. While this reaction with H2O2 may occur for other nonheme oxoiron(IV) complexes, the only previously reported examples are 3IV═O and 4IV═O, which are reduced by hydrogen peroxide 130- and 2900-fold more slowy, respectively (as in Angew. Chemie - Int. Ed. 2012 , 51 ( 22 ), 5376 - 5380 , DOI: 10.1002/anie.201200901 ).

Kinetic insights into the reactivity of the intermediates generated from hydrogen peroxide and diiron(III) complex with tris(picolyl)amine (TPA).

Two intermediates (2 and 3) are formed consecutively in the reaction of a diiron(III) complex [Fe(III)(2)(µ-O)(OH)(H(2)O)(TPA)(2)](ClO(4))(3) (TPA = tris(2-pyridylmethyl)amine, tris(picolyl)amine) with H(2)O(2) in CH(3)CN at -40 °C. Low-temperature stopped-flow studies showed that both species are kinetically competent in oxidation of phosphines and phenols. The first intermediate (2) reacts with substrates very rapidly (second-order rate constants reach 10(5)-10(6) M(-1) s(-1) for substituted triarylphosphines and 10(3)-10(5) M(-1) s(-1) for substituted phenols), in keeping with a diiron(IV)-oxo formulation. The second intermediate (3), a mixed-valent Fe(III)Fe(IV) species, is more stable than 2, and reacts with substrates more slowly (second-order rate constants range from 150 to 550 M(-1) s(-1) for triaryl phosphine oxidation, and from 18 to 790 M(-1) s(-1) for phenol oxidation). Reaction rates increase with increasing electron donating abilities of substituents, indicating that both 2 and 3 act as electrophilic oxidants.