Evidence of electronic influence in the adsorption of cationic and zwitterionic dyes on zeolites.

The adsorption of a cationic dye, Methylene blue (MB), and a zwitterionic dye, 8-Hydroxyquinoline (8-HQ), onto zeolites synthesized from different clays has been investigated. The presence of certain metals and the Si/Al ratio of the parent clay has an overall effect on the type of zeolites produced. Zeolites LTA and FAU Y were obtained using the hydrothermal method. X-ray diffraction and Fourier transform infrared spectroscopy (FTIR) spectral analysis was used to study the adsorption phenomena of the adsorbates on the adsorbents. The adsorption profile of MB (Topological Polar Surface Area (TPSA) 43.9 Å2 and 8-HQ (TPSA 33.1 Å2) compared favourably with a Freundlich isotherm with R2 > 0.9 for all the zeolitic materials synthesized. Adsorption capacities of zeolite FAU was significantly different from zeolite LTA for MB removal. The higher adsorption capacity of zeolite FAU was attributed to geometric effects resulting in greater shrinkage in the inter lattice spacing of zeolite LTA leading to a reduction in surface area. Adsorption of the relatively smaller 8-HQ however, did not show significant difference in the two zeolite types. Surface and structural characterization showed that adsorbates/adsorbents interactions were driven by both geometric (inter lattice spacing which imparts higher surface area of the adsorbent) and electronic (electrostatic repulsions through electron back donation from metals in the zeolitic structure) considerations.

Snail Based Carbonated-Hydroxyapatite Material as Adsorbents for Water Iron (II).

Carbonated hydroxyapatite (CHAp) adsorbent material was prepared from Achatina achatina snail shells and phosphate-containing solution using a wet chemical deposition method. The CHAp adsorbent material was investigated to adsorb aqua Fe(II) complex; [Fe(H2O)6]2+ from simulated iron contaminated water for potential iron remediation application. The CHAp was characterized before and after adsorption using infrared (IR) and Raman spectroscopy. The IR and the Raman data revealed that the carbonate functional groups of the CHAp adsorbent material through asymmetric orientation in water bonded strongly to the aqua Fe(II) complex adsorbate. The adsorption behaviour of the adsorbate onto the CHAp adsorbent correlated well to pseudo-second-order kinetics model, non-linear Langmuir and Freundlich model at room temperature of a concentration (20-100 mg L-1) and contact time of 180 min. The Langmuir model estimated the maximum adsorption capacity to be 45.87 mg g-1 whereas Freundlich model indicated an S-type isotherm curvature which supported the spectroscopy revelation.

A density functional theory study of arsenic immobilization by the Al(III)-modified zeolite clinoptilolite.

We present density functional theory calculations of the adsorption of arsenic acid (AsO(OH)3) and arsenous acid (As(OH)3) on the Al(III)-modified natural zeolite clinoptilolite under anhydrous and hydrated conditions. From our calculated adsorption energies, we show that adsorption of both arsenic species is favorable (associative and exothermic) under anhydrous conditions. When the zeolite is hydrated, adsorption is less favourable, with the water molecules causing dissociation of the arsenic complexes, although exothermic adsorption is still observed for some sites. The strength of interaction of the arsenic complexes is shown to depend sensitively on the Si/Al ratio in the Al(III)-modified clinoptilolite, which decreases as the Si/Al ratio increases. The calculated large adsorption energies indicate the potential of Al(iii)-modified clinoptilolite for arsenic immobilization.

Removal of ammonium ions by laboratory-synthesized zeolite linde type A adsorption from water samples affected by mining activities in Ghana.

Ammonium ion adsorption by laboratory-synthesized zeolite (linde type A; LTA) was investigated in batch kinetics experiments. Synthesized zeolite LTA was characterized by X-ray diffraction, scanning electron microscopy, energy-dispersive X-ray spectroscopy, thermogravimetric analysis, Fourier transform infrared spectroscopy and particle size analysis. Water samples were taken from the Nyam and Tano rivers in Ghana, and 0.8 g of zeolite was added to 100 ml portions of each sample. Portions of the samples were withdrawn every 30 min for 150 min and the concentration of ammonia in each sample was determined. The removal efficiency of zeolite LTA was evaluated by retrieving the zeolite from the water samples and adding to a fresh sample to repeat the process. Equilibrium data were fitted by Langmuir and Freundlich isotherms. Maximum adsorption capacities were 72.99 mg g(-1) for samples from the River Nyam and 72.87 mg g(-1) for samples from the River Tano. The equilibrium kinetic data were analysed using adsorption kinetic models: pseudo-first order and pseudo-second order kinetic models. Linear regression was used to estimate the adsorption and kinetic parameters. The results showed that the adsorption followed pseudo-second order kinetics and suggest that zeolite LTA is a good adsorbent for the removal of nitrogen ammonia from water.

Antimicrobial action and efficiency of silver-loaded zeolite X.

AIMS: To synthesize silver-loaded zeolite X and establish the extent to which it persist in its antimicrobial action against strains of Escherichia coli K12W-T, Pseudomonas aeruginosa NCIMB8295 and Staphylococcus aureus NCIMB6571. METHODS AND RESULTS: The antimicrobial action and efficacy of silver-loaded zeolite X on Escherichia coli, Staphylococcus aureus and Pseudomonas aeruginosa were investigated. Zeolite X was synthesized and loaded with Ag(+) by ion exchange. This resulted in 2.0% (w/w) loading of Ag(+) in the zeolite framework and 5.8% (w/w) on the zeolite. Escherichia coli and Pseudomonas aeruginosa and Staphylococcus aureus suspended in tryptone soya broth were exposed to 0.15, 0.25, 0.5 or 1.0 g l(-1) of silver-loaded zeolite X for a period up to 24 h. No viable cells were detected for any of the three micro-organisms within 1 h. Silver-loaded zeolite X, retrieved three times from the first exposure cultures, was washed with de-ionized water and added to fresh bacterial suspensions. The results showed that the silver-loaded zeolite X retained its antimicrobial action. CONCLUSIONS: Silver-loaded zeolite X persisted in its antimicrobial action against all three micro-organisms. SIGNIFICANCE AND IMPACT OF THE STUDY: The results are significant for the longevity of antimicrobial action of silver-loaded zeolite X.