RESUMEN
Identification of sulfonamides (SAs) residues in food is vital for human health. A set of 4-channel sensor array was constructed by carbon dots (CDs) embedded in photonic crystal molecularly imprinted (PCMIP@CDs) film which included 3 PCMIP@CDs units and 1 PCNIP@CDs unit to determine typical SAs: sulfadimethoxine, sulfathiazole, sulfaguanidine, sulfamethazine, sulfadiazine. Under the optimal conditions, the response time of the sensor array was only 200 s. Moreover, 300 fluorescence response signals (4 sensor units × 5 sulfonamides × 3 concentrations × 5 repeats) were processed by pattern recognition technique to analyze the ability of the sensor array to recognize 5 kinds of SAs. Subsequently, the linear discrimination analysis (LDA) method was used to identify the five SAs simultaneously with 100 % classification accuracy and the limit of detection was 0.01-0.26 nmol/L. Moreover, the proposed method can effectively identify-five SAs in water and fish samples.
Asunto(s)
Impresión Molecular , Puntos Cuánticos , Animales , Humanos , Sulfonamidas , Carbono/química , Impresión Molecular/métodos , Fluorometría , Sulfanilamida , Puntos Cuánticos/química , Límite de DetecciónRESUMEN
A magnetic material, Fe3O4@ZrO2, was used to enrich an organophosphorus pesticide, fenthion. After enrichment the Fe3O4@ZrO2 was treated with NaOH to elute and hydrolyze fenthion. The hydrolysis products, orthophosphate ions, combine to molybdate ions to yield molybdophosphoric acid, which was further reduced with SnCl2 to obtain a blue phosphatemolybdate. The content of orthophosphate ions as well as fenthion can be determined through the spectrophotometric method. Adsorption and elution conditions were optimized to obtain an enrichment factor of 12.5. The proposed composite method was successfully used to analyze the fenthion residues on the skin of cucumber and apple samples. The limit of detection was as low as 0.037 mg/Kg, which was close to that of the gas chromatography-mass spectrometer method. The method was simple, rapid, and economic, suitable for the rapid screen of fenthion and the other organophosphorus pesticide in mass samples.
Asunto(s)
Cucumis sativus/química , Fentión/análisis , Compuestos Férricos/química , Contaminación de Alimentos/análisis , Malus/química , Residuos de Plaguicidas/análisis , Circonio/química , Inocuidad de los Alimentos , Cromatografía de Gases y Espectrometría de Masas , Límite de Detección , Fenómenos Magnéticos , Molibdeno/química , Ácidos Fosfóricos/química , Espectrofotometría , Compuestos de Estaño/químicaRESUMEN
In this paper, molecular imprinting and photonic crystal techniques were combined to construct a four-channel sensor array for the simultaneous identification of various sulfonamides. The assay was composed of four units. Three of these units were prepared using sulfaguanidine, sulfamethazine, or sulfathiazole as template molecules. The fourth unit was prepared without a template molecule. The preparation was optimized to obtain maximum identification with a molar ratio of template, monomer, and cross-linker of 1:50:10. The response time was as short as 10 min. For demonstration, six sulfonamides were selected as analytes. The Bragg diffraction patterns of analytes at different concentrations were measured using the sensor array. Data obtained were analyzed using linear discrimination analysis (LDA) and principal component analysis (PCA). LDA can be applied for SAs discrimination. The message ratios of 87.6%, 94.4%, and 95.8% for six SAs at 10-4 mol L-1, 10-6 mol L-1, and 10-8 mol L-1 were achieved using LDA. The sensor array identified the mixture containing various SAs with an LDA coefficient of 86.1%, thereby indicating that the sensor array had a strong anti-interference ability. The sensor array was used to identify six SAs in fish samples. The measured data in spiked samples were consistent with the fingerprint collected from standard solutions. The accuracy rate reached 90.9%, indicating that the array can be used to identify SAs from food samples.