Value assignment and uncertainty evaluation for anion and single-element reference solutions incorporating historical information.

The National Institute of Standards and Technology, which is the national metrology institute of the USA, assigns certified values to the mass fractions of individual elements in single-element solutions, and to the mass fractions of anions in anion solutions, based on gravimetric preparations and instrumental methods of analysis. The instrumental method currently is high-performance inductively coupled plasma optical emission spectroscopy for the single-element solutions, and ion chromatography for the anion solutions. The uncertainty associated with each certified value comprises method-specific components, a component reflecting potential long-term instability that may affect the certified mass fraction during the useful lifetime of the solutions, and a component from between-method differences. Lately, the latter has been evaluated based only on the measurement results for the reference material being certified. The new procedure described in this contribution blends historical information about between-method differences for similar solutions produced previously, with the between-method difference observed when a new material is characterized. This blending procedure is justified because, with only rare exceptions, the same preparation and measurement methods have been used historically: in the course of almost 40 years for the preparation methods, and of 20 years for the instrumental methods. Also, the certified values of mass fraction, and the associated uncertainties, have been very similar, and the chemistry of the solutions also is closely comparable within each series of materials. If the new procedure will be applied to future SRM lots of single-element or anion solutions routinely, then it is expected that it will yield relative expanded uncertainties that are about 20 % smaller than the procedure for uncertainty evaluation currently in use, and that it will do so for the large majority of the solutions. However, more consequential than any reduction in uncertainty, is the improvement in the quality of the uncertainty evaluations that derives from incorporating the rich historical information about between-method differences and about the stability of the solutions over their expected lifetimes. The particular values listed for several existing SRMs are given merely as retrospective illustrations of the application of the new method, not to suggest that the certified values or their associated uncertainties should be revised.

Development of a Cigarette Tobacco Filler Standard Reference Material.

A new tobacco filler Standard Reference Material (SRM) has been issued by the National Institute of Standards and Technology (NIST) in September 2016 with certified and reference mass fraction values for nicotine, N-nitrosonornicotine, 4-(methylnitrosamino)-1-(3-pyridyl)-1-butanone, and volatiles. The constituents have been determined by multiple analytical methods with measurements at NIST and at the Centers for Disease Control and Prevention, and with confirmatory measurements by commercial laboratories. This effort highlights the development of the first SRM for reduced nicotine and reduced tobacco-specific nitrosamines with certified values for composition.

Development of Standard Reference Material (SRM) 2973 Vitamin D Metabolites in Frozen Human Serum (High Level).

The National Institute of Standards and Technology (NIST), in collaboration with the National Institutes of Health Office of Dietary Supplements and the Vitamin D Standardization Program, has recently issued a new serum-matrix Standard Reference Material (SRM): 2973 Vitamin D Metabolites in Frozen Human Serum (High Level). SRM 2973 was designed to provide a serum material with a total 25-hydroxyvitamin D [25(OH)D] concentration near 100 nmol/L to complement the existing serum-based SRMs with values assigned for total 25(OH)D between 20 and 80 nmol/L. Values were assigned for 25-hydroxyvitamin D2 [25(OH)D2], 25-hydroxyvitamin D3 [25(OH)D3], 3-epi-25(OH)D3, and total 25(OH)D [the sum of 25(OH)D2 + 25(OH)D3] using the NIST isotope dilution LC with tandem MS (MS/MS) reference measurement procedure (RMP) and related methods. SRM 2973 has a certified value of 98.4 ± 2.1 nmol/L for 25(OH)D3 and reference values of 1.59 ± 0.05 nmol/L for 25(OH)D2 and 5.23 ± 0.20 nmol/L for 3-epi-25(OH)D3. In addition, a candidate RMP for 24R,25-dihydroxyvitamin D3 [24R,25(OH)2D3] based on LC-MS/MS was used to assign values to SRM 2973 and the existing SRM 972a Vitamin D Metabolites in Frozen Human Serum. Reference values for 24R,25(OH)2D3 were assigned to SRM 2973 (7.51 ± 0.26 nmol/L) and the four levels of SRM 972a: Level 1 (6.38 ± 0.23 nmol/L), Level 2 (3.39 ± 0.12 nmol/L), Level 3 (3.88 ± 0.013 nmol/L), and Level 4 (6.32 ± 0.22 nmol/L). The development of SRM 2973 [with a higher concentration of 25(OH)D3] and the addition of values for 24R,25(OH)2D3 assigned to both SRM 972a and SRM 2973 provide laboratories involved in vitamin D measurements with improved QA tools.

Differential scanning calorimetry and fluorimetry measurements of monoclonal antibodies and reference proteins: Effect of scanning rate and dye selection.

Differential scanning calorimetry (DSC) and differential scanning fluorimetry (DSF) were used to measure the transition temperatures of four proteins: RNase A, invertase, rituximab, and the NISTmAb (NIST Reference Material, RM 8671). The proteins were combined with several different fluorescent dyes for the DSF measurements. This study compares the results of DSC and DSF measurements of transition temperatures with different types of proteins, dye combinations, and thermal scan rates. As protein unfolding is often influenced by kinetic effects, we measured the transition temperatures of the proteins using DSC over a range of temperature scan rates and compared them to the data obtained from DSF over comparable temperature scan rates. The results when the proteins were combined with Sypro Orange® and bis-ANS for the DSF measurements had the best correlations with the transition temperatures determined by calorimetry. The scan rate was found to be an important variable when comparing results between DSC and DSF. The van't Hoff enthalpy changes for the transitions were calculated from the DSC data by using a non-two-state model and from the DSF values using a two-state model. The calculated van't Hoff enthalpy changes did not show a good correlation between the two methods. © 2017 American Institute of Chemical Engineers Biotechnol. Prog., 33:677-686, 2017.

Metrological approaches to organic chemical purity: primary reference materials for vitamin D metabolites.

Given the critical role of pure, organic compound primary reference standards used to characterize and certify chemical Certified Reference Materials (CRMs), it is essential that associated mass purity assessments be fit-for-purpose, represented by an appropriate uncertainty interval, and metrologically sound. The mass fraction purities (% g/g) of 25-hydroxyvitamin D (25(OH)D) reference standards used to produce and certify values for clinical vitamin D metabolite CRMs were investigated by multiple orthogonal quantitative measurement techniques. Quantitative (1)H-nuclear magnetic resonance spectroscopy (qNMR) was performed to establish traceability of these materials to the International System of Units (SI) and to directly assess the principal analyte species. The 25(OH)D standards contained volatile and water impurities, as well as structurally-related impurities that are difficult to observe by chromatographic methods or to distinguish from the principal 25(OH)D species by one-dimensional NMR. These impurities have the potential to introduce significant biases to purity investigations in which a limited number of measurands are quantified. Combining complementary information from multiple analytical methods, using both direct and indirect measurement techniques, enabled mitigation of these biases. Purities of 25(OH)D reference standards and associated uncertainties were determined using frequentist and Bayesian statistical models to combine data acquired via qNMR, liquid chromatography with UV absorbance and atmospheric pressure-chemical ionization mass spectrometric detection (LC-UV, LC-ACPI-MS), thermogravimetric analysis (TGA), and Karl Fischer (KF) titration.

Unfolding properties of recombinant human serum albumin products are due to bioprocessing steps.

We have used differential scanning calorimetry (DSC) to determine the unfolding properties of commercial products of human serum albumin (HSA) prepared from pooled human blood, transgenic yeast, and transgenic rice. The initial melting temperatures (Tm1 ) for the unfolding transitions of the HSA products varied from 62°C to 75°C. We characterized the samples for purity, fatty acid content, and molecular weight. The effects of adding fatty acids, heat pasteurization, and a low pH defatting technique on the transition temperatures were measured. Defatted HSA has a structure with the lowest stability (Tm of ∼62°C). When fatty acids are bound to HSA, the structure is stabilized (Tm of ∼64-72°C), and prolonged heating (pasteurization at 60°C) results in a heat-stabilized structural form containing fatty acids (Tm of ∼75-80°C). This process was shown to be reversible by a low pH defatting step. This study shows that the fatty acid composition and bioprocessing history of the HSA commercial products results in the large differences in the thermal stability.

Development of a Standard Reference Material for metabolomics research.

The National Institute of Standards and Technology (NIST), in collaboration with the National Institutes of Health (NIH), has developed a Standard Reference Material (SRM) to support technology development in metabolomics research. SRM 1950 Metabolites in Human Plasma is intended to have metabolite concentrations that are representative of those found in adult human plasma. The plasma used in the preparation of SRM 1950 was collected from both male and female donors, and donor ethnicity targets were selected based upon the ethnic makeup of the U.S. population. Metabolomics research is diverse in terms of both instrumentation and scientific goals. This SRM was designed to apply broadly to the field, not toward specific applications. Therefore, concentrations of approximately 100 analytes, including amino acids, fatty acids, trace elements, vitamins, hormones, selenoproteins, clinical markers, and perfluorinated compounds (PFCs), were determined. Value assignment measurements were performed by NIST and the Centers for Disease Control and Prevention (CDC). SRM 1950 is the first reference material developed specifically for metabolomics research.

Determination of moisture content of single-wall carbon nanotubes.

Several techniques were evaluated for the establishment of reliable water/moisture content of single-wall carbon nanotubes. Karl Fischer titration (KF) provides a direct measure of the water content and was used for benchmarking against results obtained by conventional oven drying, desiccation over anhydrous magnesium perchlorate as well as by thermogravimetry and prompt gamma-ray activation analysis. Agreement amongst results was satisfactory with the exception of thermogravimetry, although care must be taken with oven drying as it is possible to register mass gain after an initial moisture loss if prolonged drying time or elevated temperatures (120 °C) are used. Thermogravimetric data were precise but a bias was evident that could be accounted for by considering the non-selective loss of mass as volatile carbonaceous components. Simple drying over anhydrous magnesium perchlorate for a minimum period of 8-10 days is recommended if KF is not available for this measurement.

Thermodynamics of the hydrolysis reactions of 1-naphthyl acetate, 4-nitrophenyl acetate, and 4-nitrophenyl α-L-arabinofuranoside.

Microcalorimetry, high-performance liquid chromatography (HPLC), and liquid chromatography-mass spectrometry (LC-MS) have been used to conduct a thermodynamic investigation of the hydrolysis reactions {1-naphthyl acetate(aq) + H(2)O(l) = 1-naphthol(aq) + acetate(aq)}, {4-nitrophenyl acetate(aq) + H(2)O(l) = 4-nitrophenol(aq) + acetate(aq)}, and {4-nitrophenyl α-L-arabinofuranoside(aq) + H(2)O(l) = L-arabinose(aq) + 4-nitrophenol(aq)}. Calorimetrically determined enthalpies of reaction Δ(r)H(cal) were measured for all three reactions. However, since the positions of equilibrium for all of these reactions were found to lie very far to the right, it was only possible to set lower limits for the values of the apparent equilibrium constants K'. A chemical equilibrium model, together with pKs and standard enthalpies of reaction Δ(r)H° for the H(+) binding reactions of the reactants and products, was then used to calculate the values of Δ(r)H° for chemical reference reactions that correspond to the overall biochemical reactions that were studied experimentally. The values of Benson estimates of Δ(r)H° for the chemical reference reactions that correspond to the first of the above two reactions were, in all cases, within 16 kJ·mol(-1) of the results obtained in this study. Thermochemical network calculations led to Δ(f)H° = -286.4 kJ·mol(-1) for 1-naphthyl acetate(aq) and Δ(f)H° = -364.9 kJ·mol(-1) for 4-nitrophenyl acetate(aq).

Thermodynamic dependence of DNA/DNA and DNA/RNA hybridization reactions on temperature and ionic strength.

The thermodynamics of 5'-ATGCTGATGC-3' binding to its complementary DNA and RNA strands was determined in sodium phosphate buffer under varying conditions of temperature and salt concentration from isothermal titration calorimetry (ITC). The Gibbs free energy change, DeltaG degrees of the DNA hybridization reactions increased by about 6 kJ mol(-1) from 20 degrees C to 37 degrees C and exhibited heat capacity changes of -1.42 +/- 0.09 kJ mol(-1) K(-1) for DNA/DNA and -0.87 +/- 0.05 kJ mol(-1) K(-1) for DNA/RNA. Values of DeltaG degrees decreased non-linearly by 3.5 kJ mol(-1) at 25 degrees C and 6.0 kJ mol(-1) at 37 degrees C with increase in the log of the sodium chloride concentration from 0.10 M to 1.0 M. A near-linear relationship was observed, however, between DeltaG degrees and the activity coefficient of the water component of the salt solutions. The thermodynamic parameters of the hybridization reaction along with the heat capacity changes were combined with thermodynamic contributions from the stacking to unstacking transitions of the single-stranded oligonucleotides from differential scanning calorimetry (DSC) measurements, resulting in good agreement with extrapolation of the free energy changes to 37 degrees C from the melting transition at 56 degrees C.