RESUMEN
For imaging instruments that are in space looking toward the Earth, there are a variety of nuisance signals that can get in the way of performing certain imaging tasks, such as reflections from clouds, reflections from the ground, and emissions from the OH-airglow layer. A method for separating these signals is to perform tomographic reconstructions from the collected data. A lingering struggle for this method is altitude-axis resolution and different methods for helping with it are discussed. An implementation of the maximum likelihood expectation maximization algorithm is given and analyzed.
RESUMEN
This paper is part 2 of two papers that explore performing tomographic reconstructions from a space platform. A simplified model of short-wave infrared emissions in the atmosphere is given. Simulations were performed that tested the effectiveness of reconstructions given signal amplitude, frequency, signal-to-noise ratio, number of iterations run, and others. Maximum likelihood expectation maximization is shown to be effective for reconstructing low signal cases.
RESUMEN
BACKGROUND: Orbital sensors to monitor global climate change during the next decade require low-drift rates for onboard thermometry, which is currently unattainable without on-orbit recalibration. Phase-change materials (PCMs), such as those that make up the ITS-90 standard, are seen as the most reliable references on the ground and could be good candidates for orbital recalibration. Space Dynamics Lab (SDL) has been developing miniaturized phase-change references capable of deployment on an orbital blackbody for nearly a decade. AIMS: Improvement of orbital temperature measurements for long duration earth observing and remote sensing. METHODS: To determine whether and how microgravity will affect the phase transitions, SDL conducted experiments with ITS-90 standard material (gallium, Ga) on the International Space Station (ISS) and compared the phase-change temperature with earth-based measurements. The miniature on-orbit thermal reference (MOTR) experiment launched to the ISS in November 2013 on Soyuz TMA-11M with the Expedition 38 crew and returned to Kazakhstan in March 2014 on the Soyuz TMA-10 spacecraft. RESULTS: MOTR tested melts and freezes of Ga using repeated 6-h cycles. Melt cycles obtained on the ground before and after launch were compared with those obtained on the ISS. CONCLUSIONS: To within a few mK uncertainty, no significant difference between the melt temperature of Ga at 1 g and in microgravity was observed.
RESUMEN
The far-infrared spectroscopy of the troposphere (FIRST) instrument is a Fourier-transform spectrometer developed to measure the Earth's thermal emission spectrum with a particular emphasis on the far-infrared. FIRST has observed the atmosphere from both the ground looking up and from a high-altitude balloon looking down. A recent absolute laboratory calibration of FIRST under ground-like operating conditions showed accuracy to better than 0.3 K at near-ambient temperatures (270-325 K) but reduced accuracy at lower temperatures. This paper presents calibration results for balloon-flight conditions using a cold blackbody to simulate the space view used for on-board calibration. An unusual detector nonlinearity was discovered and corrected, and stray light was measured and removed. Over most of the range of Earth scene temperatures (205-300 K), the accuracy of FIRST is 0.35-0.15 K (one sigma).
RESUMEN
The far-infrared spectroscopy of the troposphere (FIRST) instrument is a Fourier transform spectrometer developed to measure the Earth's thermal emission spectrum with a particular emphasis on far-infrared (far-IR) wavelengths greater than 15 µm. FIRST was developed under NASA's Instrument Incubator Program to demonstrate technology for providing measurements from 10 to 100 µm (1000 to 100 cm(-1)) on a single focal plane with a spectral resolution finer than 1 cm(-1). Presently no spectrometers in orbit are capable of directly observing the Earth's far-IR spectrum. This fact, coupled with the fundamental importance of the far-IR to Earth's climate system, provided the impetus for the development of FIRST. In this paper the FIRST instrument is described and results of a detailed absolute laboratory calibration are presented. Specific channels in FIRST are shown to be accurate in the far-IR to better than 0.3 K at 270 K scene temperature, 0.5 K at 247 K, and 1 K at 225 K.